Radial Engineering StageBug SB5W Manual

Radial Engineering Ikke kategoriseret StageBug SB5W

Læs gratis den danske manual til Radial Engineering StageBug SB5W (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Radial Engineering StageBug SB5W, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

www.radialeng.com

True to the Music

Radial Engineering Ltd.

®True to the Music

USER GUIDE

Radial Engineering Ltd. SB5W Direct Box™ SB5W Direct Box™

FEATURES

RADIAL ENGINEERING 3 YEAR

TRANSFERABLE LIMITED WARRANTY

RADIAL ENGINEERING LTD. (“Radial”) warrants this product to be free from defects in material and

workmanship and will remedy any such defects free of charge according to the terms of this warranty.

Radial will repair or replace (at its option) any defective component(s) of this product (excluding nish and

wear and tear on components under normal use) for a period of three (3) years from the original date of

purchase. In the event that a particular product is no longer available, Radial reserves the right to replace

the product with a similar product of equal or greater value. In the unlikely event that a defect is uncovered,

please call 604-942-1001 or email service@radialeng.com to obtain a RA number (Return Authorization

number) before the 3 year warranty period expires. The product must be returned prepaid in the original

shipping container (or equivalent) to Radial or to an authorized Radial repair center and you must assume

the risk of loss or damage. A copy of the original invoice showing date of purchase and the dealer name

must accompany any request for work to be performed under this limited and transferable warranty.

This warranty shall not apply if the product has been damaged due to abuse, misuse, misapplication,

accident or as a result of service or modication by any other than an authorized Radial repair center.

THERE ARE NO EXPRESSED WARRANTIES OTHER THAN THOSE ON THE FACE HEREOF

AND DESCRIBED ABOVE. NO WARRANTIES WHETHER EXPRESSED OR IMPLIED, INCLUDING

BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR

A PARTICULAR PURPOSE SHALL EXTEND BEYOND THE RESPECTIVE WARRANTY PERIOD

DESCRIBED ABOVE OF THREE YEARS. RADIAL SHALL NOT BE RESPONSIBLE OR LIABLE FOR

ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LOSS ARISING FROM THE USE

OF THIS PRODUCT. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO

HAVE OTHER RIGHTS, WHICH MAY VARY DEPENDING ON WHERE YOU LIVE AND WHERE THE

PRODUCT WAS PURCHASED.

Specications and appearance are subject to change without notice.

Radial Engineering Ltd.

1588 Kebet Way, Port Coquitlam BC V3C 5M5

tel: 604-942-1001 • fax: 604-942-1010

info@radialeng.com • www.radialeng.com

RADIAL SB5W WALL MouNT DIREcT Box SpEcIFIcATIoNS

S B 5 W

W a ll M o u n t

D i r e c t B o x

1. LEVEL: Let’s you adjust the volume level of your source

device.

2. MONO: Mixes the left and right inputs together and

outputs a mono signal to the PA system.

3. LIFT: Disconnects the audio ground of both channel outputs

to eliminate hum and buzz created by ground loops.

4. 3.5MM INPUT: Stereo mini-phone jack lets you connect

mobile devices such as laptop computers, MP3 players

or tablets. Plugging in here will deactivate the RCA

connectors.

5. RCA INPUT: A stereo pair of RCA inputs lets you connect

a wide range of consumer electronics such as CD/DVD

players and digital players/recorders.

6. STEEL ENCLOSURE COVER: Protects the audio circuit

from electro-magnetic and radio interference.

7. HEAVY DUTY FRAME: The PCB and cover mount to a

ridgid 14-guage steel L-frame that’s powder-coated for

long life.

8. OUTPUT TERMINALS: Balanced left and right mic-level

outputs connections are made via two screw-down

terminals.

9. TIE-WRAP HOLD-DOWNS: Slots cut in the steel frame

for tie-wraps (included) help secure the cable and provide

strain relief for the connectors.

Frequency response 20Hz to 18kHz +/- .5dB ��

Total harmonic distortion 0.01% THD 20Hz to 20kHz ��

Stereo input Unbalanced high-Z -10dB ��

Input connections RCA and 3.5mm TRS ��

Stereo output AES standard balanced 600-Ohm, ��

mic-level, pin-2 hot

Output connection Screw terminals ��

Input level Variable from innity ��

Power requirement None, completely passive��

Mounting Fits single gang electrical junction box ��

8 8

To meet the requirements of California Proposition 65, it is our responsibility to inform you of

the following: WARNING: This product contains chemicals known to the State of California to

cause cancer, birth defects or other reproductive harm. Please take proper care when handling

and consult local government regulations before discarding.

Thank you for purchasing the Radial SB5W stereo direct box. This innovative

direct box is designed to t a standard single-gang electrical wall plate and

provides the A/V integrator with an elegant means of connecting a stereo

audio source such as a laptop computer, CD player or tablet to a professional

audio system. Although the SB5W is designed to be plug & play easy to use,

please take a minute to read this short manual. It will give you insight on how

to best use the Radial SB5W direct box and get the most out of it.

INSTALLATION

The SB5W ts a standard single gang electrical wall plate and should be

installed in accordance with the electrical codes in your region. It is the

responsibility of the installing contractor to comply with electrical codes

and regulations with regards to installing and terminating the SB5W. The

SB5W is classied as a low voltage device and should never be installed in

the same electrical junction box alongside high-voltage class-1 electrical

power devices. Please consult your local electrical authority before installing.

The SB5W is completely passive and no power source is required. Signal

connections are made using standard twisted pair audio cable. This usually

comes in a shielded format with two insulated conductors (18AWG to 26AWG)

and a ground conductor often called the drain wire. The cable itself should

comply with all electrical codes as regulated in your area.

Shielded twisted pair audio cable with drain wire.

GROUND (DRAIN)

WHITE OR RED (+)

FOIL SHIELD

BLACK (-)

Run two twisted pair cables from the PA mixer/amplier to the location where

the SB5W is to be installed. Mark one of the cables with tape or magic marker.

This will help to indicate one cable as the left channel. Pull about 20cm (8”)

of cable through the electrical junction box to allow easy manipulation while

installing. Strip back the cable insulation by 1cm (½”) and tin the bare wire

ends with solder to prevent corrosion.

Next, remove the protective metal cover from the SB5W using a Phillips

screwdriver and locate the audio output terminals on either side and labeled

‘LEFT’ and ‘RIGHT’. The output terminals are balanced and have three

screw-down connections, one labeled negative (-); another labeled ground

(G); and a third labeled positive (+).

Left output Right output

CONNECTIONS

Starting with the left channel terminal, push the BLACK wire into the negative

connection and screw down tight using a small slotted screwdriver. Insert the

other color wire (sometimes white or red) into the positive connection and screw

it down tight. The drain wire or shield is inserted into the ground connection and

tightened. Repeat for the right channel.

Tie-wrap

inserted into

hold down slots

The included tie-wraps are used with hold-down slots cut into the frame to secure

the twisted pair cable and provide strain relief. Once secure, replace the cover

and t into the electrical junction box.

You will need to terminate the cables at the mixer/amplier using the same polarity.

The following diagrams show balanced terminations for standard XLR and ¼”

TRS phone connectors.

SHIELD/DRAIN

RING (-)

TIP (+)

SLEEVE (G)

SHIELD/DRAIN

- G + XLR and ¼” TRS Balanced terminations

The SB5W’s output is mic level and therefore should be connected to a microphone

preamp input. At the mixer/amplier, connect the left and right cables from the SB5W

to two mic inputs on the PA mixer/amplier system. If there is only one mic input

available or if the PA system operates in mono you can connect the left channel and

set the SB5W to mono mode by depressing the MONO switch on the front panel.

USING THE SB5W DIRECT BOX

Before connecting a device to the SB5W,

turn the audio level control fully counter-

clockwise to the off position. This will help

avoid loud transients that can damage

more sensitive components like tweeters

and startle your audience.

The SB5W features stereo RCA and 3.5mm TRS input jacks to connect an

unbalanced audio source. The RCA jack allows consumer electronics like

CD/DVD players to connect to the PA system while the 3.5mm jack works

well with mobile devices like smart phones and tablets.

After connecting your device, start playback and slowly turn up the level

control on the SB5W to a comfortable listening volume. Be aware your device

may also have its own volume control that you may need to adjust. It is very

difcult to overload the SB5W, however it is possible to overload the input

on the mixer/amplier. If you hear distortion, turn the level control down or

adjust the volume on your device.

USING THE GROUND LIFT

Sometimes when connecting your device to the PA system via the SB5W

direct box you can encounter noise like hum and buzz caused by ground

loops. If you encounter noise after connecting depress the ground LIFT switch

on the front panel. This disconnects the signal ground between the source

device and the PA system eliminating ground loop noise. The LIFT switch is

recessed to prevent tampering. Use a small screwdriver to access the switch.

USING THE MONO SUM

The MONO switch on the front panel sums the left and right inputs together.

When this switch is fully depressed the SB5W will output the same mono

signal at both screw terminal outputs. This can be used to connect a stereo

device like a CD/DVD player to a mono only sound system or when only

one input at the mixer is available. The MONO switch is recessed to prevent

tampering. Use a small screwdriver to access the switch.

Radial Engineering Ltd. Radial Engineering Ltd. Radial Engineering Ltd.SB5W Direct Box™ SB5W Direct Box™ SB5W Direct Box™

Produkt Specifikationer

Mærke:	Radial Engineering
Kategori:	Ikke kategoriseret
Model:	StageBug SB5W

Har du brug for hjælp?

Hvis du har brug for hjælp til Radial Engineering StageBug SB5W stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Radial Engineering Manualer

Radial Engineering JS-2 Manual

28 September 2025

Radial Engineering Phazerbank Manual

17 September 2025

Radial Engineering HotShot MD Manual

16 September 2025

Radial Engineering Backtrack Manual

5 September 2025

Radial Engineering JX44 V2 Manual

4 September 2025

Radial Engineering JS3 Manual

20 Juli 2025

Radial Engineering Loopbone Manual

18 Juli 2025

Radial Engineering JS2 Manual

18 Juli 2025

Radial Engineering JR-5 Manual

18 Juli 2025

Radial Engineering JX62 Manual

17 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

StarTech.com RKUNITAPE Manual

3 Oktober 2025

Kenwood Abbey Lux TCP05 Manual

3 Oktober 2025

Realme 11x 5G Manual

3 Oktober 2025

Realme GT5 Manual

3 Oktober 2025

Sony PFM-510A2WU Manual

3 Oktober 2025

Arctic AATA-5G Manual

3 Oktober 2025

Fisher & Paykel WB30SPEX3 Manual

3 Oktober 2025

EasyMaxx 00621 Manual

3 Oktober 2025

Inkbird IBS-TH5-WiFi Manual

3 Oktober 2025

Sony EP-NI1010L Manual

3 Oktober 2025