Raspberry Pi 8486806 Manual


Læs gratis den danske manual til Raspberry Pi 8486806 (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Raspberry Pi 8486806, eller vil du spørge andre brugere om produktet?

Side 1/6
Gertbot Advanced Rev 0.2 8-Sept.-2014
1
Gertbot Advanced
Rev-0.2, 8-Sept.- 2014
The Gertbot is a motor controller board for the Raspberry-Pi. For details how to operate it read the
Gertbot manual and/or the Gertbot GUI. This manual describes how to unlock some of the more
challenging features of the board.
Contents
Cascade. .................................................................................................................................................. 2
More current for DC motors. .................................................................................................................. 3
More current for Stepper motors. ............................................................................................................ 5
Going to DC 10 Amp. ............................................................................................................................. 5
Going to Stepper 10 Amp. ...................................................................................................................... 6
Uploading new software. ........................................................................................................................ 6
Board Erase. ............................................................................................................................................ 6
Gertbot Advanced Rev 0.2 8-Sept.-2014
2
Cascade.
To use two or more boards you need to make a cascade cable. That is a flat cable with up to four 8-pin
female headers. This is such a cable:
The length of the cable depends on how far apart you want to mount the boards. If you stack them
using 15mm stand-offs you need 120 mm cable. You also need an 8-pin IDC press connector per
board. I put a video on YouTube how to make a press connector a while ago:
http://www.youtube.com/watch?v=sMiRoXY_oZg.
The following picture shows an example how the cable can be connected to four boards.
Note that the jumpers on the picture above . You must give each board a unique ID. are wrong
The following diagram shows the with the jumpers: ID
ID=0 ID=1 ID=2 ID=3


Produkt Specifikationer

Mærke: Raspberry Pi
Kategori: Ikke kategoriseret
Model: 8486806

Har du brug for hjælp?

Hvis du har brug for hjælp til Raspberry Pi 8486806 stil et spørgsmål nedenfor, og andre brugere vil svare dig