RCA BVLR333EVWW Manual

RCA Tørretumbler BVLR333EVWW

Læs gratis den danske manual til RCA BVLR333EVWW (3 sider) i kategorien Tørretumbler. Denne vejledning er vurderet som hjælpsom af 80 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 40.5 anmeldelser. Har du et spørgsmål om RCA BVLR333EVWW, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

BVLR333EVWW—RCA 5.4 Cu. Ft. Large Capacity Electric Dryer

Revised 11/98

Dryer Dimensions (in inches)

Exhaust Options:

4-way via rear, right, left and bottom.

Circuit Requirements:

A properly-grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay

fuse, is required.

Electric Dryer Rating: 208V/240V, 3 wire, 5600W, 60Hz, 30 Amps

Installation Information: For complete information, see installation instructions packed

with your dryer.

36 42

25-1/2

2-1/2

25-1/2

Side View Rear View

4-3/4

25-3/4

23-1/2

11-3/4

Listed by

Underwriters

Laboratories

BVLR333EVWW—RCA 5.4 Cu. Ft. Large Capacity Electric Dryer

Revised 11/98

Dryer Exhausting Information—Use Metal Duct Only

0 90 ft. 60 ft. 55 ft. 45 ft.

1 60 ft. 45 ft. 40 ft. 30 ft.

2 45 ft. 35 ft. 30 ft. 20 ft.

Full Size 3 35 ft. 25 ft. 20 ft. 15 ft.

All Electric Dryers 4 25 ft. 15 ft. 15 ft. 10 ft.

0 45 ft. 30 ft. 30 ft. 15 ft.

1 35 ft. 20 ft. 20 ft. 10 ft.

Full Size 2 25 ft. 10 ft. 10 ft. —

All Gas Dryers 3 15 ft. — — —

Number of

90° Turns

Maximum Length of 4" Dia.

Rigid Metal Duct

Maximum Length of 4" Dia.

Flexible Metal Duct

Exhaust Hood Type Exhaust Hood Type

Domestic

Dryer Models

Cat. No. WX8X59

(Preferred)

4" Opening

2-1/2" Opening

Cat. No. WX8X59

(Preferred)

4" Opening

2-1/2" Opening

2-1/2

Best Performance

For complete information, see installation instructions packed with your dryer.

Important Note:

GE Kit Number WE14X70 needed when converting rear exhaust to bottom or side. (On large capacity models.)

Ducting Materials:

For best performance, this dryer should be vented with 4” diameter all rigid metal exhaust duct. If “all rigid metal”

duct cannot be used, then “flexible all metal” venting can be used, but it will reduce the maximum recommended

duct length.

Exhaust Length Calculation:

1. Determine the number of 90° turns needed for your installation. If you exhaust to the side

or bottom of dryer, add one turn.

2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is shown

in the table. The maximum length for flexible ducts are less than for rigid duct.

A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow. A

turn over 45° should be treated as a 90° elbow.

Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and

lint from being blown into the room. Gas dryers or any dryer located in a closet must be exhausted to the outside.

Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed

house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard

or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen

exhaust, since the combination of lint and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall

cap must also be located at least 12” above the ground or any other obstruction with the opening pointed Down.

Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4” opening

dampered wall cap.

Special Installation Requirements

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

• The dryer MUST be exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:

0” either side

3” front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.

• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area

equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in.

of open area equally distributed.

• The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.

• No other fuel-burning appliance shall be installed in the same closet with the dryer.

Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas

Code, ANSI Z223.

Minimum Clearances other than Alcove or Closet Installation:

•Minimum clearances to combustible surfaces

0” both sides

3” rear

Listed by

Underwriters

Laboratories

Produkt Specifikationer

Mærke:	RCA
Kategori:	Tørretumbler
Model:	BVLR333EVWW

Har du brug for hjælp?

Hvis du har brug for hjælp til RCA BVLR333EVWW stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Tørretumbler RCA Manualer

RCA BVLR333EVWW Manual

11 August 2024

RCA BWXR473EVAA Manual

24 Juli 2024

RCA BJLR473EVWW Manual

21 Juli 2024

RCA BJLR473GVWW Manual

6 April 2023

RCA BWXR473GVAA Manual

23 Februar 2023

RCA BWXR473GVWW Manual

19 Oktober 2022

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

Electrolux EW6D4183P1 Manual

19 Juni 2025

Haier HD90-C367GU1 Manual

18 Juni 2025

Sogo SS-3665-P Manual

18 Juni 2025

Blomberg LTA18320 Manual

18 Juni 2025

Haier HD90-CQ387U1 Manual

18 Juni 2025

Haier HD100-C367GU1 Manual

18 Juni 2025

Haier HD100-CQ387U1 Manual

18 Juni 2025

Bosch WQG24200ID Manual

17 Juni 2025

Haier HD100-C367U1 Manual

17 Juni 2025

GE GTD58GBPVDG Manual

17 Juni 2025