ENGLISH
UK 016 03 710339
US 877-928-7333
FR 0811 850 11 3
DE 0800-181-9091
info@reef-one.com
www.reef-one.com
1
5
L
/
4
U
S
G
a
l
s
=
1
8
K
g
/
4
0
l
b
s
3
0
L
/
8
U
S
G
a
l
s
=
3
6
K
g
/
8
0
l
b
s
This guide will help you understand how your
aquarium works and how to create a healthy
environment for your fish. Please read these
i
nstructions carefully before filling your
aquarium with water. This is not a toy, adult
supervision is recommended. Removing the
serial number or dismantling your aquarium
will invalidate your guarantee.
L
L
L
L
5
1
2
3
4
6
7
8
1 Carefully remove contents from the
box and check. Choose a suitable
location for your aquarium noting all the
advice above and place your aquarium
on a strong and level surface.
Remember the aquarium needs a
power source within reach.
2 Remove plastic wrapper from filter
cartridge (A) then offer up cartridge to
base of bubble tube (B), locate tabs and
twist in a counterclockwise direction
ensuring all cartridge tabs are fully
located. New cartridges are available
from a biOrb dealer.
3 Remove the light unit and lid from the
biOrb then take the bubble tube and
filter cartridge assembled in step 2 and
insert into the biOrb. Turn the bubble tube
clockwise until it locks in position. When
correctly located, the bubble tube and filter
will remain in place.
4 Wash the ceramic media supplied
thoroughly before placing around the
filter body, ensuring none remains on top.
Use only ceramic media supplied, do not
use aquarium gravel. Discard any pieces
smaller than a pea.
5 Connect the airline to the pump as shown
and place in a suitable position. Positioning
the pump higher than the aquarium water
level will prevent water leakage or damage
to pump should valve failure occur.
Setting up your aquarium
6 Plug the pump and light unit plug into
the separate sockets on the transformer
supplied, then plug the transformer into
the power source and turn on. The
pump should be left running 24hrs a
day, only switch it off during filter
cartridge changes and cleaning.
7 Fill the aquarium with tap water to
approximately 3”/7.5cm above the top
of the bubble tube and add Water
Conditioner. Leave the aquarium
running for at least 24 hours before
adding Biological Booster and then you
will be ready to add your first fish. Do
not immerse the light unit in water.
3’’- 7.5cm
DO NOT MOVE
WHEN FULL
A
VOID
H
OT AREAS
IMPORTANT:
AVOID SUNLIGHT
NOT ON OR NEAR
ELECTRICAL ITEMS
