Rigol RM-1-DG1000Z Manual

Rigol Ikke kategoriseret RM-1-DG1000Z

Læs gratis den danske manual til Rigol RM-1-DG1000Z (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Rigol RM-1-DG1000Z, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

RIGOL

Rack Mount Kit

DG2000&DG1000Z&DSG800

to mount RIGOL DG2000/DG1000Z series

erator or DSG800 RF signal source into a 19-inch cabinet

that conforms to the Electronic Industries Association (EIA) standard. This manual takes

DG1000Z as an example to introduce the installation method.

Kit Part Checklist

No. Name Qty. Description

RM-1-DG1000Z [1] RM-2-DG1000Z [1]

1 Front Plate 1 None --

2 Fastener 1 2 --

3 Connecting Plate A None 1 --

4 Connecting Plate B None 1 --

5 Retaining Bracket None 2 --

6 M4 Countersunk Flat

Head Screw None 4 M4x10 Phillips Pan

Head Screw

7 M4 Pan Head Screw 4 8 M4x8 Phillips Pan

Head Screw

8 M6 Pan Head Screw 4 4 M6x16 Phillips Pan

Head Screw

9 M6 Nut 4 4 M6 Square Lock

Cage Nut

Note[1]:RM-1-DG1000Z is designed for installing a single instrument, and RM-2-DG1000Z for two instruments.

6 7 8 9

Installation Guide RIGOL

Installation Tool

The PH2 Phillips screwdriver and T20 Phillips screwdriver are recommended.

Space Requirements

To mount the instrument into the cabinet correctly, please ensure that the following

requirements are met.

 The cabinet must be a standard 19-inch one.

 The available height of the cabinet should be at least 2U (88mm).

 The depth of the cabinet should be at least 400mm.

The dimensions of the rack are as shown below.

RM-1-DG1000Z Unit: mm

RM-2-DG1000Z Unit: mm

Installation Procedures

CAUTION

Only authorized operators are allowed to perform the installation. Improper

installation might cause damage to the instrument or an installation failure.

Installation Guide RIGOL

Pre-Installation Preparation: Dissemble the handle and protective rubber

covers

1. Rotate the handle upright. Then, pull it out from the sides of the instrument to remove

it.

2. Use the T20 Phillips screwdriver to remove eight M4 screws at four corners of the front

panel and four M4 screws at four corners of the rear panel. Then, take off the eight

protective rubber covers.

Mount a single instrument (Requiring to order a set of

RM-1-DG1000Z)

1. Attach the fastener to one side of the

front panel, then secure the fastener

with two M4 pan head screws.

2. Attach the front plate to the other side

of the front panel, then secure the

plate using two M4 pan head screws.

3. Mount the assembled instrument and

rack into a standard 19-inch cabinet

using four M6 pan head screws and

four M6 square nuts.

-End-

Mount two instruments (Requiring to order a set of RM-2-DG1000Z)

1. Attach one fastener to the right side of

the front panel of Instrument A, then

secure the fastener with two M4 pan

head screws. Attach Connecting Plate A

to the left side of the front panel of

Instrument A, and then use two M4

countersunk head screws to fasten

Connecting Plate A to Instrument A.

Instrument A

Fastener

Connecting Plate A

Installation Guide RIGOL

2. Attach another fastener to the left side

of the front panel of Instrument B, then

secure the fastener with two M4 pan

head screws. Attach Connecting Plate B

to the right side of Instrument B, and

then use two M4 countersunk head

screws to fasten Connecting Plate B to

Instrument B.

3. Joint Connecting Plate A with

Connecting Plate B.

4. Place two retaining brackets onto the

connecting position of rear panels of

two instruments, and then secure the

retaining brackets with four M4 pan

head screws.

5. Mount the assembled instrument and

rack into a standard 19-inch cabinet

using four M6 pan head screws and

four M6 square nuts.

-End-

Instrument B

Fastener

Connecting Plate B

Instrument A

Instrument B

Produkt Specifikationer

Mærke:	Rigol
Kategori:	Ikke kategoriseret
Model:	RM-1-DG1000Z

Har du brug for hjælp?

Hvis du har brug for hjælp til Rigol RM-1-DG1000Z stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Rigol Manualer

6 Juni 2025

6 September 2024

5 September 2024

5 September 2024

29 August 2024

Rigol RM-1-DG1000Z Manual

29 August 2024

29 August 2024

28 August 2024

28 August 2024

28 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Tracer Ambience - Smart Circle Manual

17 Juni 2025

Ulsonix ULX-480-1 Manual

17 Juni 2025

JUNG CD 104.18 WU Manual

17 Juni 2025

Hughes & Kettner TriAmp MKII Manual

17 Juni 2025

Cecotec Bean&Clean Manual

17 Juni 2025

Steinberg SBS-FZ 3000/3BM Manual

17 Juni 2025

Mars Gaming MPB1000SI Manual

17 Juni 2025

Stamos SWS05 Manual

17 Juni 2025

Royal Catering RCAT-140/80 Manual

17 Juni 2025

Planet Audio P90CPAP Manual

17 Juni 2025