Roland RUBIX44 Manual

Roland Hi-Fi system RUBIX44

Læs gratis den danske manual til Roland RUBIX44 (31 sider) i kategorien Hi-Fi system. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Roland RUBIX44, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/31

Reference Manual

Panel Descriptions

Rubix22

Front Panel

5 9

1 1 72 2 63 8

1 [SENS 1L] knob, [SENS 2R] knob

Adjust the volume of the audio signal that is input via the

INPUT (1L, 2R) jacks.

2 Level indicator

The indicator is lit green if an audio signal greater than -24 dB (*) is

being input to the INPUT (1L, 2R) jacks. If the input level is -3 dB (*)

or higher, the indicator is lit red. If the indicator is lit red, use the

[SENS 1L] knob and [SENS 2R] knob to adjust the input level.

* The level relative to the maximum allowable input (0 dB)

3 INPUT (1L, 2R) connectors (combo jacks)

These are analog audio input jacks with microphone preamps. They

accommodate both XLR connectors and 1/4-inch phone type jacks,

and support both balanced and unbalanced connections.

XLR

connector

(balanced)

Phone type plug

(unbalanced)

TRS phone

type plug

(balanced)

INPUT (1L, 2R)

connectors Input sensitivity

XLR connector -60– -12dBu

Phone type plug -44–+4dBu

MEMO

To prevent malfunction and equipment failure, always turn

down the volume, and turn o all the units before making

any connections.

Pin assignment of INPUT connector/jack

1: GND

2: HOT

3: COLD

GND (SLEEVE)

HOT (TIP)

COLD (RING)

5Set the [Hi-Z] button (p. 2) and [48V] button (p. 2) as

appropriate for the audio device that is connected.

Use a microphone with an XLR connector.

The sound level will be very low if you use a

microphone with a phone type plug.

5When connecting a guitar or bass, use the INPUT 1L

jack. The sound level will be very low if you

connect directly to the INPUT 2R jack.

4 [Hi-Z] button

Determines the impedance of the INPUT 1L jack.

You can select high impedance (Hi-Z) or low impedance (Lo-Z) as

appropriate for the connected equipment.

[Hi-Z] button Equipment connected to the INPUT 1L jack

Lit (Hi-Z) Guitar or bass

Unlit (Lo-Z) Other equipment (such as synthesizers)

5 [48V] button

Determines whether the Rubix22 supplies phantom power to the

XLR connectors of the INPUT (1L, 2R) jacks.

[48V] button Connected equipment

Lit

Condenser microphone that requires phantom

power

* Phantom power supplied by this unit: DC 48 V;

maximum 6 mA. (current value per channel)

Unlit Other equipment

NOTE

You must leave the [48V] button set to unless “OFF”

condenser microphones requiring phantom power are

connected to the XLR connectors. Supplying phantom

power to a dynamic microphone or to an audio playback

device may damage the equipment. For details on the

requirements of your microphone, refer to its owner’s

manual.

Minimize the volume before you turn phantom power on

or o. Even if the volume is minimized, turning phantom

power on/o might make a sound, but this is not a

malfunction.

6 Power indicator

Indicates the status of the connection with a USB device.

Power

indicator Status

Lit Connected to a computer or iPad.

Unlit Not connected to a computer or iPad.

7 [OUTPUT] knob

Adjusts the output level of the audio signal.

MEMO

Adjusting the [OUTPUT] knob does not change the volume

that is output to the (headphones) jack.Q

8 [ ] (Headphone) knobQ

Adjusts the output level of the jack.Q

9 (Headphone) jackQ

Used to connect headphones.

MEMO

This jack outputs the same sound as the OUTPUT (1L, 2R)

jacks. Even if headphones are connected, sound will be

output from the OUTPUT (1L, 2R) jacks.

Produkt Specifikationer

Mærke:	Roland
Kategori:	Hi-Fi system
Model:	RUBIX44
Bredde:	310 mm
Dybde:	165 mm
Højde:	46 mm
Vægt:	1800 g
Brugervejledning:	Ja
Produktfarve:	Sort
Formfaktor:	Desktop
Hurtig start guide:	Ja
Strømkilde:	USB
Enhedsgrænseflade:	USB
Antal USB-porte:	1
Lydindgang:	4
Lydudgang:	4
MIDI udgang:	Ja
Lyd A/D konverter (ADC):	24-bit/192kHz
6,35 mm (1/4 tommer) udgang:	4
Understøttede stikprøver:	44.1,48,96,192 kHz
MIDI indgang:	Ja
XLR-indgange:	4
48V phantom effekt:	Ja
AC udgangsspænding:	5 V