
This tank accessory is for use with RYOBI P2807, P2808, and 
P28010 handheld electrostatic sprayers ONLY. 
To reduce the risk of injury, user must read and understand the 
operator’s manual for their electrostatic sprayer and this in-
struction sheet. Always wear eye protection with side shields 
marked to comply with ANSI Z87.1, as well as any other safety 
equipment required due to the solution being sprayed. Ensure 
compatibility and fit before using this accessory. Do not use 
this accessory if a part is damaged or missing. 
Follow the chemical manufacturer’s safety instructions and 
guidelines listed on the SDS sheet and/or product labeling 
for use, cleaning, and storage. Clean thoroughly after each 
use, following the instruc tions in the operator’s manual for 
your electrostatic sprayer. Chemicals should be stored out 
of the reach of children. Failure to do so may result in serious 
Push the male barb on the hose onto the female quick con-
Pull on the hose to be certain it is properly  secured.
ATTACHING/DETACHING THE QUICK CONNECT 
Pull back the quick-connect collar.
Push the hose into place onto the male barb on the back of 
Push the collar forward so that the hose is secured properly.
Check to see that the hose is secure.
Pull back and hold the quick-connect collar.
Remove the hose by pulling it from the quick-connect collar.
 NOTE: Be careful when disconnecting the hose from the tank 
because the liquid in the hose will drain from that end. Drain 
remaining liquid back into container.
The electrostatic sprayer is now ready to use following the 
instructions in your electrostatic sprayer operator’s manual.
P.O. Box 1288, Anderson, SC 29622 USA
1-800-525-2579   www.ryobitools.com
A - Quick connect hose (tuyau à raccord rapide, manguera de conexión rápida)
B - Hose barb (raccord cannelé du tuyau, conector de manguera)
A - Hose barb (raccord cannelé du tuyau, conector de manguera)
B - Quick connect hose (tuyau à raccord rapide, manguera de conexión rápida)