Without disengaging the sheet from the drive mechanism,
remove the stub roll from the upper roll holders and
temporarily hold it forward of the upper roll holders. (Figure 5)
Electronic Dispenser Module Loading and Operating Instructions
LOADING INSTRUCTIONS
Loading the dispenser without a stub roll
Load the towel roll into the upper roll holders so
that the paper feeds down from the back (Figure 1).
SEE OTHER SIDE FOR OPERATING INSTRUCTIONS Form 034140 5/2020
A
Lift the black transfer bar and place the leading
edge of paper under it. Lower the black transfer
bar (Figure 2).
B
Press the white feed button until the paper exits
the module (Figure 3).
C
Tear off paper and close cover securely.
NOTE: Following cover closure, there is a four
second delay before unit is activated.
D
Loading the dispenser with a stub roll
When the main roll reaches approximately 2.6” in
diameter the low product light will begin to flash
(Figure 4) indicating the roll may be moved to the
stub roll position.
A
B
Lift the gray bar so it is positioned against the back wall
of the dispenser (Figure 6).
C
Load the stub roll into the lower roll holders.
(Figure 7)
D
Slowly lower the gray bar until it is seated on the paper
DO NOT SLAM GRAY BAR DOWN (Figure 8).
E
Load the new towel roll into upper roll holders so
that the paper feeds down from the back. (Figure 9)
F
Lift the black transfer bar and place the leading edge
of the paper under it and on to of the existing paper sheet.
Slowly release the black transfer bar (Figure 10).
G
Wrap the leading edge of the paper up and around the
black transfer bar and pierce the paper on the center hook
on the black transfer bar so it is held in place (Figure 11).
H
Leave some slack in the main roll to ensure proper transfer.
Close cover securely. NOTE: Following cover closure, there
is a four second delay before unit is activated.
I
The stub roll will continue to dispense until it is empty
at which time the main roll will begin to feed.
J
1 2
1
2
3
4
11
00:02
10
1
2
9
5
6
7 8
NOTE: Use only new Fuji EnviroMAX, Gold Peak Ultra Plus,
Energizer Max, or Duracell Coppertop or Procell Alkaline (LR20)
“D” size batteries.
Loading batteries
When battery power is low, the red Low Battery Light
will flash (Figure 12).
A
Grasp the battery box tab and pull upward (Figure 13).
B
Remove spent batteries if present.
C
Insert new batteries ensuring the polarity is correct
(Figure 14).
D
Close battery box cover securely (Figure 15).
E
13
14 15
12
AC ADAPTOR NOTE: For AC Power only use adaptor #51224
