SE Electronics RF-X Manual


Læs gratis den danske manual til SE Electronics RF-X (3 sider) i kategorien Mikrofon. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 11 anmeldelser. Har du et spørgsmål om SE Electronics RF-X, eller vil du spørge andre brugere om produktet?

Side 1/3
REFLEXION FILTER® X A S S E M B LY + U S E
RF-X ASSEMBLY MANUAL
sE Electronics RF-X Assembly + Use
Thank you for purchasing an sE Electronics RF-X! We hope it helps make your
tracks sound great - no matter WHERE you’re recording.
STEP ONE
The rst step is to attach the hardware to
the stand, which is done by screwing the
bracket onto the top of a mic stand, where
the mic or shockmount normally attaches.
*Theres an adapter screwed
inside this connector for a
European mic thread size - if
you remove the adapter, the
connector will t US mic stands.
Use the lever on top of the L bracket
to tighten it, but not too tight, as you’ll
probably need to shift it slightly later.
STEP TWO
Next, attach the lter to the vertical portion
of the L bracket by inserting the two included
screws through the vertical cutout in the L
bracket, and into the two screw holes on the
back of the RFX.


Produkt Specifikationer

Mærke: SE Electronics
Kategori: Mikrofon
Model: RF-X

Har du brug for hjælp?

Hvis du har brug for hjælp til SE Electronics RF-X stil et spørgsmål nedenfor, og andre brugere vil svare dig