Segway X2 SE Manual

Segway Zelfbalancerende scooter X2 SE

Læs gratis den danske manual til Segway X2 SE (148 sider) i kategorien Zelfbalancerende scooter. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Segway X2 SE, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/148

User Manual

Segway Personal Transporter (PT)

i2 SE

x2 SE

x2 SE Turf

WARNING

• Whenever you ride the Segway® PT you risk death or serious injury from loss of control, collisions, and falls. It is your responsibility to learn how to safely

ride the PT in order to reduce this risk. To ride safely you must follow all instructions in the user materials, including the User Manual and Safety Video. These

materials are available at www.segwaysafety.com.

• Always wear a helmet when riding. Use an approved bicycle or skateboard helmet that ﬁts properly with the chin strap in place, and provides protection for

the back of your head.

• Never place anything on the Mats except your feet. Doing so could interfere with the Rider Detection system and allow the PT to travel on its own, risking

running into a person or property and causing injury or damage.

• Avoid obstacles and slippery surfaces that could result in a loss of balance or traction and cause a fall.

• Pay attention to all Safety Warnings and Alerts from the PT. They indicate unsafe operating conditions. You must learn about and understand the PT Safety

Alerts described in the User Manual and respond as instructed.

• Do not get back on the PT after a Safety Shutdown until the condition that caused the Safety Shutdown has been identiﬁed and corrected.

• Never let go of the PT when it is in Balance Mode because it will travel some distance on its own, give the Stick Shake Warning, then cut power to the wheels.

If you let go of a PT while in Balance Mode, you risk injury to others and damage to the PT.

• Never restart and ride your PT after it has indicated an empty battery condition or performed a Safety Shutdown due to low battery. The PT may not

have enough power to keep you balanced, especially if you demand a lot of power at once. If you restart and continue riding, you risk falling. Also, you risk

damaging your batteries, resulting in reduced battery life and capacity.

• While the PT is designed to keep you upright under a variety of conditions, you can overpower the balancing capability of your PT by aggressively leaning into

and ignoring the Speed Limiter.

• Do not insert the power cord if the PT Charge Port is wet.

• Use a surge protector when charging the PT to help protect it from damage due to power surges and voltage spikes.

• Always shut down your PT and unplug the AC Power Cord before performing any maintenance or installing any part or accessory.

• All PT parts must be properly installed. Never attempt to use your PT without the LeanSteer™ Frame attached and secured. Using your PT without all parts

properly installed could damage your PT and result in serious injury from loss of control, collisions, and falls.

• Use only Segway approved parts and accessories. Do not modify the PT. Modiﬁcations to the PT could interfere with the operation of the PT, could result in

serious injury and/or damage, and could void the Segway PT Limited Warranty.

• Theft detection systems, such as the type used in some libraries and retail stores, can interfere with the PT’s ability to balance and/or cause the PT to

perform a Safety Shutdown. Do not ride within 5 ft. (1.5 m) of any theft detection system.