USER’S GUIDE
Precautions
• Please read and follow these instructions and keep this manual in a
safe place.
• Clean this product with only a soft, dry cloth.
• Keep this product away from children.
• Make sure that this product is intact and that there are no missing
parts.
• To avoid damage to this product, be careful not to overtighten or
improperly thread any of the threaded fittings.
• Do not exceed the maximum load capacity.
• All photos are for illustrative purposes only.
Contents Include
• Wall plate
• Two (2) vertical mounting brackets
• Horizontal mounting bracket
• Removable mounting bracket
• 4 Removable mounting plates
• Mounting-plate bolt
• Two (2) Mounting-plate nuts
• Two (2) 6 40 mm mounting screws×
• Two (2) 6 60 mm mounting screws×
• 8 mm screw
• Two (2) 3/8 screw anchors"
• Two (2) 4 12 mm machine screws×
• Two (2) 5 12 mm machine screws×
• Two (2) 6 12 mm machine screws×
• 5 mm hex key
Vertical Mounting
1. Start with the wall plate on a flat
surface. Orient the mounting
plate’s bolt-head so it's facing you.
2. Place one of the vertical
mounting brackets onto the
right-hand side of the wall plate
so their bolt holes are aligned.
Hold the mounting bracket in
place with the nut that has a
small bolt-hole.
Tip: The shape of the nut will
conform to the
corresponding side of the
wall plate.
3. Place the other vertical mounting bracket on the left-side of the wall
plate. Hold the mounting bracket in place with the nut that has a large
bolt-hole.
4. Insert the mounting-plate bolt through the nut that has a large
bolt-hole and use the included hex key to screw the bolt in place until
secure.
5. Confirm the desired mounting location on your wall. Hold the wall
plate against the wall at the desired mounting location, and use a
pencil to mark the exact location of the mounting holes.
6. Use a drill with a 1/4 bit to drill holes through the pencil marks."
7. Fully insert the included screw anchors into the holes.
8. Position the wall plate with the swivel-action bolt-head facing up.
Align the mounting holes with the screw anchors, and use the
6 40 mm or 6 60 mm mounting screws to secure the wall plate × ×
to the anchors.
Note: Use the 6 40 mm screws for the ASM-3 and ASM-4 speakers. ×
Use the 6 60 mm screws for the ASM-5 and ASM-6 speakers.×
9. Align the slots in the vertical mounting brackets with the mounting
holes in the speaker. Use the machine screws to secure the speaker to
the mounting bracket assembly. Use the 4 12 mm screws for the ×
ASM-3, the 5 12 mm screws for the ASM-4, and the 6 12 mm × ×
screws for the ASM-5 and ASM-6.
ASM-MNTKIT
