Models: 12 14 15 SLSFE | SLSFE | SLSFE
ELECTRONIC SAFE
USER MANUAL
OPENING YOUR SAFE FOR THE FIRST TIME
Upon rst use, users should open the safe with the
emergency key.
• To do this: Remove emergency lock cover, insert
the emergency key, and turn it counterclockwise.
• Turn the knob counterclockwise to open the door.
CAUTION: Finish operation, pull the emergency key out
and keep it in a safe place.
INSERTING THE BATTERIES
• Open the door with the emergency key
• Insert 4 X 1.5V batteries into the battery
compartment. Upon inserting, the buzzer will beep
and the green light will ash.
• If both green and red light are on, it indicates the
batteries are low and should be replaced.
SETTING USER CODE
• With the door open, press the reset button (the red
button on the battery compartment), input the 3- to
8-digit user code and press the “ ”button or enter
the “lock” button.
• 2 buzzer beeps with green light ashes indicates
the new user code is stored.
OPENING DOOR WITH USER CODE
Input your user code. After each press, the buzzer will
beep and the green light will ash, press the “ ” enter
button or the “ button. After the correct code is lock”
entered, there will be 2 buzzer beeps and the green
light will ash, rotate the knob counterclockwise
within 5 seconds to open the door.
CAUTION: A wrong code input will activate 3 buzzer beeps.
CLOSING DOOR
Turn the knob clockwise to close the door.
MOUNTING METHOD
• Fix the safe in a place which is not easy to move.
• Drill holes for expansion bolts (or clamping screws)
in the right place.
• Turn the expansion bolts counterclockwise to
separate.
• Use the expansion bolts (or clamping screws) to
secure the case to the wall.
• Make sure the case is mounted in place as
required and then tighten screws.
CAUTION: Use the expansion bolt when there is a
concrete wall surface. Use the clamping screw when
there is a wooden wall surface.
AUTOMATIC LOCK
3 continuous wrong inputs will activate the warning
beep for 20 seconds.
Another 3 continuous wrong inputs will activate the
warning beep for 3 minutes.
CAUTION: The keypad will be disabled during the
beeping. You can only stop the beeps by opening the
safe with emergency key or removing the batteries.
