SereneLife SLCATL420 Manual

SereneLife Højtryksrenser SLCATL420

Læs gratis den danske manual til SereneLife SLCATL420 (4 sider) i kategorien Højtryksrenser. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om SereneLife SLCATL420, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

www.SereneLifeHome.com

MAIN FEATURES

COMPONENTS

•

Premium user comfort: Full size & soft-close seat

and lid, large toilet bowl and 478mm seat height

brings greater homelike performance.

•

Easy to ush: High gloss toilet bowl with original

T type 3 way ush ow creates high-speed, full bowl

ushing.

•

Ergonomically enhanced pedal operation:

Lower pedal height for easier use.

One-direction action to open drain valve and ush.

•

Easy installation: Two bolts design ts most existing

toilet oor anges, great for new or replacement

installation. Just place on oor ange, tighten bolts,

connect water, and it’s ready.

FLOOR MOUNTING KIT

Flange plate Seal ring T-bolt and

rubber case

www.SereneLifeHome.com

PRODUCT AND MOUNTING DIMENSION

The outside diameter of the toilet drain outlet: 95mm / 3.7”;

The inner diameter of the toilet drain outlet: 87mm / 3.4”

INSTALLATION

Note:

•

Be sure foot pedal, when pressed, touches same at surface on which toilet is installed.

•

Ensure water supply pressure is no more than 0.4Mpa.

•

Hot water more than 40 degrees is forbidden.

1. To replace an older toilet, turn o water supply to toilet. Remove and drain water supply line.

Remove toilet hold-down bolts/screws. Remove toilet from oor. Remove and discard old ange seal

and hold-down bolts. Verify center of oor ange is at least 200mm/7.9” from back wall ( ).Fig.1

2. If installing a new oor ange, make certain that toilet mounting holes are located at the correct angle

(Fig.1). Floor ange must be secured to oor with a minimum of four screws. Insert two supplied T-bolts

into slots in oor ange (Fig.2).

3. Verify that oor ange seal is installed on base of toilet. Carefully set toilet over oor ange.

Align holes in toilet base with T-bolts as toilet is lowered onto oor ange.

4. Install oor mounting nuts onto T-bolts. When tight, base should be securely attached and at against

oor. Attach bolt covers onto nuts

5. Connect water supply line to ½ inch water inlet and turn on water supply line. (Fig.3)

Flush toilet several times and check for leaks.

Produkt Specifikationer

Mærke:	SereneLife
Kategori:	Højtryksrenser
Model:	SLCATL420

Har du brug for hjælp?

Hvis du har brug for hjælp til SereneLife SLCATL420 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højtryksrenser SereneLife Manualer

SereneLife SLCMPWT25 Manual

6 September 2024

SereneLife SLCMPWT40 Manual

6 September 2024

SereneLife SLCMPWT75 Manual

6 September 2024

SereneLife SLCATL490 Manual

6 September 2024

SereneLife SLPRWAS46 Manual

21 August 2024

SereneLife SLCATL420 Manual

20 August 2024

SereneLife SLCATL520 Manual

20 August 2024

SereneLife SLCATL320 Manual

20 August 2024

SereneLife SLCATL360 Manual

19 August 2024

SereneLife AZSLCATL320 Manual

18 August 2024

Højtryksrenser Manualer

Nyeste Højtryksrenser Manualer

Kärcher HD 3.0/27 G Teton Manual

14 Juni 2025

Kärcher HDS 5.0/30 ED Manual

13 Juni 2025

Kärcher WR-30E Manual

13 Juni 2025

Ozito HPW-2320K Manual

13 Juni 2025

Lavor HHPV Manual

8 Juni 2025

Lavor Thermic 5H Manual

8 Juni 2025

Draper 98679 Manual

7 Juni 2025

Draper 98677 Manual

7 Juni 2025

Draper Storm Force 98674 Manual

7 Juni 2025

Draper 03096 Manual

7 Juni 2025