Sharp SKMD30E9ES Manual

Sharp Mikrobølgeovn SKMD30E9ES

Læs gratis den danske manual til Sharp SKMD30E9ES (12 sider) i kategorien Mikrobølgeovn. Denne vejledning er vurderet som hjælpsom af 98 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 49.5 anmeldelser. Har du et spørgsmål om Sharp SKMD30E9ES, eller vil du spørge andre brugere om produktet?

Side 1/12
E 1
30" EXTENSION KIT: SKMD30E9ES INSTALLATION INSTRUCTIONS
IMPORTANT NOTES TO THE INSTALLER
Read all of the Installation Manual that is included with the Microwave Drawer before installing the extension kit.
Observe all governing codes, ordinances, and safety instructions.
Be sure to leave these instructions with the consumer.
Parts included:
Left Side Trim (qty. 1) Right Side Trim (qty. 1) Mounting Brackets (qty. 2)
Bracket Screws (qty. 8)
Trim Screws (qty. 4)
Install the extension kit after properly installing the microwave drawer in the cabinet. See steps below.
Note that the side trims are marked "L" and "R" on the back side.
T I N S KB 28 9M R R 0
MICROWAVE DRAWER STANDARD MOUNT, MEASUREMENTS AND INSTALLATION INSTRUCTIONS
D
G
A
B
C
H
I
F
E
JA. 215/8" (549.28 mm)
B. 411 /16" (119.06 mm)
C. 13/4" (44.45 mm)
D. 217/8" (555.63 mm)
E. 235/8" (600.07 mm)
F. 16" (406.4 mm)
G. 1419/ " (370.68 mm)32
H. 117/ " (38.89 mm) door thickness32
I. 15" (381 mm) auto drawer opening
J. 4" (101.60 mm)
Figure 1
E 2
1. Prepare cabinet opening as shown in Figure 2.
2. Place the drawer adjacent to the wall or cabinet opening. Plug the
power supply cord into the electrical outlet.
3. Carefully guide the drawer into the prepared opening. Avoid
contact with the sides of the cutout opening and pinching the cord
between the oven and the wall.
4. Slidethedrawerallthewaybackuntilthesiderailsareushwith
the face of the cabinet.
5. Open the drawer. Using the 4 holes on the drawer as a template,
pre-drill the cabinet using a
1/16" (1.6 mm) bit. Secure the drawer
with the 4 screws supplied. See Figure 3.
Side
Rail
Figure 3
6. Close drawer to complete oven installation. See Figure 4.
Figure 4
B
C
D
E
F
GH
I
I
O
J
K
L
Q
M
N
P
A
O
Figure 2
A. 6" (152.40 mm)
B. Suggested electrical outlet location*
C. Anti-Tip block
D. 5" (127 mm)
E. 31
/2" (88.90 mm)
F. 4" (101.60 mm)
G. 221/8" (561.98 mm) opening
H. 1413
/16" (376.24 mm) to bottom of Anti-Tip block
I. Allow 7/8" (22.22 mm) overlap
J. 231/2" (596.90 mm) minimum depth
K. Allow 7/16" (11.11 mm) overlap
L. 36" (914.40 mm) countertop height
M. Allow 7/16" (11.11 mm) minimum space
N. Floor must support 100 lb (45.4 kg)
O. Allow 41/8" (104.4 mm) minimum space
P. 159/16" (395.3 mm) opening
Q. 30" (762.0 mm) minimum width
Figures 1 and 2 contain many Microwave Drawer measurements for
reference when planning the drawer’s location.
This Microwave Drawer can be installed below any electric or gas
wall oven.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
reach. Power cord access hole in cabinet should be a minimum
11/ " diameter hole and deburred of all sharp edges.2
IMPO RTANT Always allow sufcient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.


Produkt Specifikationer

Mærke: Sharp
Kategori: Mikrobølgeovn
Model: SKMD30E9ES

Har du brug for hjælp?

Hvis du har brug for hjælp til Sharp SKMD30E9ES stil et spørgsmål nedenfor, og andre brugere vil svare dig




Mikrobølgeovn Sharp Manualer

Mikrobølgeovn Manualer

Nyeste Mikrobølgeovn Manualer