Shimano BL-MT402-3A Manual

Shimano Ikke kategoriseret BL-MT402-3A

Læs gratis den danske manual til Shimano BL-MT402-3A (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 45 personer og har en gennemsnitlig bedømmelse på 3.9 stjerner ud af 23 anmeldelser. Har du et spørgsmål om Shimano BL-MT402-3A, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Hydraulic Disc Brake

(for Downhill / Freeride)

IMPORTANT NOTICE

•Contact the place of purchase or a distributor for information on installation,

adjustment, and replacement of the products which are not found in the user's

manual. A dealer's manual for professional and experienced bicycle mechanics is

available on our website (https://si.shimano.com).

For safety, be sure to read this “user's manual” thoroughly

before use, follow it for correct use, and store it so that it

can be referenced at any time.

The following instructions must be observed at all times in order to prevent

personal injury and physical damage to equipment and surroundings. The

instructions are classified according to the degree of danger or damage which may

occur if the product is used incorrectly.

DANGER Failure to follow the instructions will result in

death or serious injury.

WARNING Failure to follow the instructions could result in

death or serious injury.

CAUTION

Failure to follow the instructions could cause

personal injury or physical damage to equipment

and surroundings.

Important safety information

WARNING

•Because each bicycle may handle slightly differently depending on the model, be

sure to learn the proper braking technique (including brake lever pressure and

bicycle control characteristics) and operation of your bicycle. Improper use of your

bicycle's brake system may result in a loss of control or a fall, which could lead to

severe injury.

•Do not disassemble or modify the product. This may cause the product to not

operate correctly, and you may suddenly fall and be seriously injured.

•Downhill bicycle riding and freeriding are inherently dangerous activities. It is

strongly recommended that riders wear protective head and body gear and

perform thorough safety checks of their bicycles before riding. Please remember

that you are riding at your own risk and that you have to consider your

experience and your skills very carefully. There is a risk of being involved in an

accident that can result in a serious injury or even death.

•Riders must become accustomed to the higher performance of this brake before

riding the bicycle.

–The brake system is designed for downhill bicycle riding and freeriding, and its

braking force is much higher than for other brakes. If you do not familiarize

yourself with the performance level of this brake, you may be involved in an

accident that could result in serious injury or even death. Furthermore, the

settings of the brakes make them unsuitable for riding on city streets. Sudden

brake operations may cause the bicycle to fall forward, which can result in

serious injury or even death.

–The 203 mm and 180 mm disc brake rotors provide a higher braking force than

the 160 mm disc brake rotors. If you ride the bicycle without becoming

sufficiently familiar with the braking characteristics, braking may cause you to

fall off the bicycle, potentially causing serious injury or a fatal accident.

•Please use extra caution to keep your fingers away from the

rotating disc brake rotor. The disc brake rotor is sharp

enough to inflict severe injury to your fingers if caught

within the openings of moving rotor.

•Do not touch the calipers or disc brake rotor while riding or immediately after

dismounting from the bicycle. The calipers and disc brake rotor will become hot

when the brakes are operated, so you may get burned if you touch them.

•Be careful not to allow any oil or grease to get onto the disc brake rotor and

brake pads. Riding the bicycle with oil or grease on the disc brake rotor and brake

pads may prevent the brakes from operating and result in serious injury due to a

fall or collision.

•Check the thickness of the brake pads and do not use them if they have a

thickness of 0.5 mm or less. Doing so may prevent the brakes from operating and

result in serious injury.

2 mm 0.5 mm

•Do not use the disc brake rotor if it is cracked or deformed. The disc brake rotor

may break, and result in serious injury due to a fall. Replace the disc brake rotor

with a new one.

•Do not use the disc brake rotor if its thickness is 1.5 mm or less. Also do not use it

if the aluminum surface becomes visible. The disc brake rotor may break, and

result in serious injury due to a fall. Replace the disc brake rotor with a new one.

•Do not continuously apply the brakes. Doing so may cause a sudden increase in

the brake lever stroke, preventing the brakes from operating and resulting in

serious injury.

•Do not use the brakes with fluid leaking. Doing so may prevent the brakes from

operating and result in serious injury.

•Do not apply the front brake too strongly. If you do so, the front wheel may lock

and the bicycle may fall forward, and serious injury may result.

•Because the required braking distance will be longer during wet weather, reduce

your speed and apply the brakes early and gently. You may fall or collide and be

seriously injured.

•A wet road surface may cause tires to lose traction; therefore, to avoid this,

reduce your speed and apply the brakes early and gently. If the tires lose traction,

you may fall and be seriously injured.

CAUTION

Cautions on SHIMANO genuine mineral oil

•Use appropriate eye protection when handling, and avoid contact with eyes. In

the event of eye contact, flush with fresh water and seek medical assistance

immediately. Contact with eyes may result in irritation.

•Use gloves when handling. In the event of skin contact, wash well with soap and

water. Contact with skin may cause a rash and discomfort.

•Cover nose and mouth with a respirator type mask and use in a well ventilated

area. Inhalation of mineral oil mist or vapors may cause nausea.

•If mineral oil mist or vapor is inhaled, go to an area with fresh air. Cover up with

a blanket. Stay warm and stable and seek professional medical advice

immediately.

Bed-in period

•Disc brakes have a bed-in period, and the braking force will gradually increase as

the bed-in period progresses. Make sure that you are aware of any such increases

in braking force when using the brakes during the bed-in period. The same thing

will happen when the brake pads or disc brake rotor are replaced.

Notice

•To prevent noise and ensure the best performance, perform the bed-in procedure

after replacing the brake pads or disc brake rotor.

•When the bicycle wheel has been removed, it is recommended that pad spacers

are installed. Do not depress the brake lever while the wheel is removed. If the

brake lever is depressed without the pad spacers installed, the pistons will

protrude further than normal. If that happens, consult a place of purchase.

•Use soapy water and a dry cloth when cleaning and carrying out maintenance of

the brake system. Do not use commercially available brake cleaners or silencing

agents. Such substances can cause damage to parts such as seals.

•This product is not warranted against damage resulting from improper use, such

as jumping while riding or if the bicycle falls over, except if such malfunctions are

caused by manufacturing methods.

•Products are not guaranteed against natural wear and deterioration from normal

use and aging.

•For maximum performance we highly recommend SHIMANO lubricants and

maintenance products.

Regular inspections before riding the bicycle

Before riding the bicycle, check the following items. If any problems are found,

consult your place of purchase or a distributor.

•Are there any signs of brake oil leakage?

•Do the front and rear brakes work correctly?

•Do the pads have a thickness of 0.5 mm or more?

•Is the disc brake rotor cracked or deformed?

•Are the levers securely installed to the handlebar?

•Are there signs of cracks or peeling on the levers?

•Are there any abnormal noises?

UM-8VT0A-003 User's Manual

Names of parts

Brake lever

Disc brake rotor

Caliper

Brake pad

How to operate

This product has a reach adjustment function.

If the brake levers seem too far away and are difficult to reach, contact the place of

purchase or a distributor.

How to perform bed-in

To optimize the performance of the brake pads and disc brake rotor, perform the

bed-in procedure as explained in the steps below:

1. Ride your bicycle in a flat and safe area without obstacles and accelerate to a

moderate speed.

2. Operate the brake lever until you slow down to walking speed.

Do this only with one brake lever at a time. Be careful when performing this

procedure. Always operate your brake lever with moderation, especially when

you bed in the front brake.

3. Repeat steps 1 and 2 for at least 20 times for both the front and rear brakes.

While repeating the process, the brake force will increase.

Please note: specifications are subject to change for improvement without notice. (English)

One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003

High Tech Campus 92, 5656 AG Eindhoven, The Netherlands Phone: +31-402-612222

3-77 Oimatsu-cho, Sakai-ku, Sakai City, Osaka 590-8577, Japan

Produkt Specifikationer

Mærke:	Shimano
Kategori:	Ikke kategoriseret
Model:	BL-MT402-3A

Har du brug for hjælp?

Hvis du har brug for hjælp til Shimano BL-MT402-3A stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Shimano Manualer

Shimano FC-MT610-B2 Manual

11 Januar 2025

Shimano ST-T4000-R Manual

30 December 2025

Shimano BR-M8120 Manual

7 Oktober 2024

Shimano SL-RV400-6R Manual

7 Oktober 2024

Shimano SL-RV300-6R Manual

6 Oktober 2024

Shimano ST-2400-R Manual

6 Oktober 2024

Shimano CN-HG901-11 Manual

6 Oktober 2024

Shimano DH-T785 Manual

4 Oktober 2024

Shimano CLARIS 2400 ST-R240-R Manual

1 Oktober 2024

Shimano SL-RV300-7R Manual

1 Oktober 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Schneider LUCD1XES Manual

4 Juli 2025

Ikea BLÄDDRARE 304.743.99 Manual

4 Juli 2025

NUX Komp Core Deluxe MKII Manual

4 Juli 2025

Ikea GRÖNAMARANT 204.604.25 Manual

4 Juli 2025

Rowenta Focus DW5121 Manual

4 Juli 2025

Racktime Baskit Breeze 2.0 Manual

4 Juli 2025

Schneider KSB32CP15D Manual

4 Juli 2025

Wiesenfield WIE-IN-100 Manual

4 Juli 2025

Ergotec PM-705N Manual

4 Juli 2025

Sol Expert 19590 Manual

4 Juli 2025