Shure WL184 Manual

Shure Mikrofon WL184

Læs gratis den danske manual til Shure WL184 (2 sider) i kategorien Mikrofon. Denne vejledning er vurderet som hjælpsom af 48 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 24.5 anmeldelser. Har du et spørgsmål om Shure WL184, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Wireless Lavalier Microphone User Guide

WL183, WL184, AND WL185 LAVALIER MICROPHONES

GENERAL

Models WL183, WL184 and WL185 are lavalier electret condenser

microphones designed for use with a wireless bodypack transmitter. Each

microphone has a 1.2 meter (4 ft.) cable terminated with a miniature

Switchcraft TA4F connector. The furnished tie clip can be rotated in 90°

intervals for placement flexibility.

APPLICATIONS

WL183 (Omnidirectional): Recommended for general purpose

sound reinforcement, recording, or remote monitoring applications.

Low handling noise. Pickup angle is 360°.

WL184 (Supercardioid): Recommended for sound reinforcement ap-

plications requiring high rejection of ambient noise and narrow pickup

angle. Use of windscreen highly recommended. Pickup angle is 115°.

WL185 (Cardioid): Recommended for general purpose sound rein-

forcement applications requiring good rejection of ambient noise. Use

of windscreen highly recommended. Pickup angle is 130°.

INSTALLATION

1. Insert the top of the microphone through tie clip loop from below until

tie clip loop snaps into place over the lower groove on the micro-

phone. Refer to the following illustration.

2. To install the snap–fit windscreen, press it down on the microphone

until it clicks into place inside the upper groove on the microphone.

The snap–fit windscreen provides 30 dB of pop protection.

NOTE: The snap–fit windscreen can be removed by spreading the

slot in the plastic snap–fit ring.

To install the smaller foam windscreen, slip the windscreen over the

top of the microphone so that it covers the side slots.The foam wind-

screen provides 5 to 10 dB of pop protection.

TIE CLIP

WINDSCREEN

3. Attach the microphone approximately 76 mm to 152 mm (3 to 6 in.)

below the neckline.

NOTE: Do not cover the microphone with your hand or clothing.

CHANGING CARTRIDGES

The WL183, WL184, and WL185 microphones use interchangeable

cartridges. To remove the cartridge, unscrew the tip of the microphone

and remove it. Install the replacement cartridge by screwing it onto the

microphone base.

REPLACEMENT PARTS AND ACCESSORIES

Omnidirectional Cartridge R183B. . . . . . . . . . . . . . . . . . . . . . . . . .

Supercardioid Cartridge R184B. . . . . . . . . . . . . . . . . . . . . . . . . . .

Cardioid Cartridge R185B. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Snap–fit Windscreens (4) RK183BWS. . . . . . . . . . . . . . . . . . . . .

Foam Windscreen (4) RK261WS. . . . . . . . . . . . . . . . . . . . . . . . . .

Tie clips (2) RK183T1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Miniature 4-pin connector WA330. . . . . . . . . . . . . . . . . . . . . . . . .

SPECIFICATIONS

Type: Condenser (electret bias)

Frequency Response: 50 to 17,000 Hz

500 1,000 2,000 5,000 10,00050 100 20020

+10

–10

20,000

500 1,000 2,000 5,000 10,000 20,000

50 100 20020

+10

–10

500 1,000 2,000 5,000 10,000 20,000

50 100 20020

+10

–10

WL183 FREQUENCY RESPONSE

WL184 FREQUENCY RESPONSE

WL185 FREQUENCY RESPONSE

Polar Patterns (at 1 kHz):

–10 dB

–15 dB

–5 dB

–20 dB

–10 dB

–15 dB

–5 dB

–20 dB

–10 dB

–15 dB

–5 dB

–20 dB

CARDIOID

(WL185)

OMNIDIRECTIONAL

(WL183)

150o

120o

150o

120o

180o

30 o

60o

90o

30 o

60o

90o

150o

120o

150o

120o

180 o

30 o

60o

90o

30 o

90 o

SUPERCARDIOID

(WL184)

150o

120o

150o

120o

180 o

30 o

60o

90o

30 o

60o

90o

Output Impedance : 1800 Ω

Sensitivity (1 Pa = 94 dB SPL): WL183: –40.0 dBV/Pa

WL184: –44.5 dBV/Pa

WL185: –45.5 dBV/Pa

Maximum Sound Pressure Level: WL183: 125.0 dB SPL

WL184: 129.5 dB SPL

WL185: 130.5 dB SPL

Output Noise (A–weighted): WL183: 22.5 dB SPL

WL184: 27.0 dB SPL

WL185: 28.0 dB SPL

Dynamic Range: 102.5 dB

Polarity: Positive pressure on diaphragm produces positive voltage on

pins 3 and 4 relative to pin 1.

Power Requirements: Regulated nominal +5 Vdc (1.5 Vdc to 10 Vdc)

provided at microphone connector pin 2 relative to pin 1 of a Shure

wireless microphone transmitter.

NOTE: For additional technical assistance, phone Shure at (847)

866-2200. In Europe, phone 49-7131-72140.

CONDENSER

CARTRIDGE

IMPEDANCE CONVERTER

SHIELD

BLK

RED

D+ 4

MICROPHONE WIRING DIAGRAM

1 GROUND

2 BIAS

3,4 AUDIO

27B2833 (AA)

2001, Shure Incorporated Printed in U.S.A

Produkt Specifikationer

Mærke:	Shure
Kategori:	Mikrofon
Model:	WL184

Har du brug for hjælp?

Hvis du har brug for hjælp til Shure WL184 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Mikrofon Shure Manualer

28 September 2025

1 September 2025

22 August 2025

18 August 2025

22 Juli 2025

Shure PGA56-XLR Manual

15 Juli 2025

Shure ULXD6 Manual

23 Juni 2025

Shure MoveMic One Manual

21 Februar 2025

Shure MV7i Manual

21 Februar 2025

Shure VP89M Manual

29 December 2024

Mikrofon Manualer

Nyeste Mikrofon Manualer

Blue enCORE 100 Manual

5 November 2025

Nady SP-4C Manual

4 November 2025

Nady SCM 800 Manual

4 November 2025

Nady SP-R3 Manual

4 November 2025

Phenyx Pro PTU-7000A Manual

4 November 2025

JARO J100-CS Manual

4 November 2025

MayBesta WM150 Manual

3 November 2025

XIAOKOA N80-B Manual

3 November 2025

Singing Machine CPK565 Manual

3 November 2025

Shaevle SW-16 Manual

3 November 2025