Siemens SN 25M230 Manual

Siemens Opvaskemaskine SN 25M230

Læs gratis den danske manual til Siemens SN 25M230 (2 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Siemens SN 25M230, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Start

Reset 3sec.

Filling the salt dispenser

Adding rinse aid

Adding detergent

Select programme

Brief and handy:

everything your dishwasher

needs …

Before using for the first time,

read the Installation instructions

and Operating instructions!

Summary of instructions Dishwasher

Switching on the appliance

Switch off the appliance

Everything o.k....

Start programme

Here we go...

9000 397 652

(9001) 640 MA

Ask your water

supply company

what the water

hardness

is and enter...

Adjusting the water softening system*

Quickly sorted ...

* only before the first

wash or if the water

hardness has been

changed

How to adjust

– Switch on ON/OFF switch.

– Hold down programme button A and press START button until H:0...

is indicated on the digital display.

– Release both buttons.

The LED for button A flashes and the factory set value of H:04

is indicated on the digital display.

– Press programme buttonC.

Each time the button is pressed the set value increases by one setting;

when the value reaches H:07, the display jumps back toH:00 (off).

– Press START button. The chosen setting has now been stored.

• ‹‹

• ‹‚

• ‹ƒ

• ‹„

• ‹…

• ‹†

• ‹‡

• ‹ˆ

0-8

9-10

11-12

13-15

16-20

21-26

27-38

39-62

0 -1.1

1.2-1.4

1.5-1.8

1.9-2.1

2.2-2.9

3.0-3.7

3.8-5.4

5.5-8.9

Water

hardness

value

°Clarke

Hardness

range

mmol/l

Factory

setting

soft

medium

hard

Dissolves limescale (not necessary for set value 0!) ...

Unscrew

cover.

Fill the salt

dispenser with

water before

the first wash only.

Add special salt

(never add

detergent!).

Screw on

the cover.

Wash

immediately.

Spick and span ...

Press

mark 1,

lift up

cover 2.

Fill in

rinse aid.

Screw on

the cover.

CLICK!

A lot of dirt, a lot of detergent ...

If required,

open the cover

(press button).

Attention:

Combination

products

are not suitable

for all programmes,

manufacturer’s

instructions.

Pour detergent

into the dry

detergent

dispenser only.

Slide cover

shut, press.

PLOP!

15 ml

25 ml

50 ml

Overview of programmes

The max. possible number of programmes

is illustrated in this overview.

The corresponding programmes for your appliance

can be found on the fascia.

The programme data has been measured

in the laboratory according to European

standard EN 50242.

Deviations are possible in practice.

* half normal load

Quick, economical or intensive ...

Prerinse

Quick

45°

Gentle

40°

Eco

50°

Auto

45°–65°

Intensive

70°

Energy consumption in kWh

With Aquasensor

Water consumption in litres

Duration: hs : mins

ø²

2:15 1:35-2:30 2:20 1:10 0:29 * 0:15

1,50 1,00-1,60 1,05 0,80 0,80 0,05

15 - 12 13 10 4

12 9-19 - 10 - -

Additional options**

Flexibility…

Express Wash

... is obtained by increased

energy consumption

at a constant cleaning

performance.

Half load

... for a few items,

saves water, energy

and time.

Extra drying

... improves the drying

result by increased

temperature

in the final rinse.

(Please take care

with delicate dishes.)

Hygiene

... the temperature

is increased during

the final rinse process.

This increases

the hygiene status.

Intensive zone

... perfect for

a mixed load.

Washing pressure

and washing temperature

are increased slightly.

** depending on model

Maintenance and care

Cleaning waste water pump

CLICK!

For perfect rinsing results ...

Filters

... check,

if required,

clean.

Rotate

filter cylinder,

remove filter

system...

rinse

under

running

water ...

insert ...

Screw on

filter system

NOTE

MARK!

Spray arms

...Remove

blockages/

deposits.

pull lower arm

upwards...

unscrew

upper arm …

clean spray nozzles

under running water

(if required

use toothpicks) ...

insert

lower arm ...

screw on upper

arm tightly

– Pull out the mains plug.

– Remove filters and scoop out water.

– Lever off cover (A).

– Check area around the fan impeller

for foreign objects.

– Click cover shut (B).

– Insert filters.

Rectifying minor faults yourself ...

... as it is worth doing it yourself!

Fault Possible causes

Remedial action

Display “6” is lit

Supply fitting jammed or calcified

1. Unscrew water connection.

2. Clean filter in the water connection.

3. Flow rate must be min. 10l/min.,

when water supply is open.

If the flow rate is less, replace the supply fitting.

Open supply fitting.

Install supply hose without kinks.

Display “E:25”

and “6” are lit

Waste water pump blocked

Clean waste-water pump (see above).

Rust on the cutlery

Cutlery not rust-resistant

Hard knife blades are more susceptible

Extraneous rust

Use dishwasher-proof cutlery.

Never wash rusting parts in the appliance.

Other fault display

“E:XX” is lit

Display “E:24”

and “6” are lit

Residual water

in the appliance

Appliance has technical defect

Waste water hose is blocked

or kinked

Cover not attached to waste

water pump

Call factory customer service (state fault display).

Unplug appliance.

Install waste water hose without kinks.

Attach cover (see above).

The programme has not yet ended

Close the appliance and switch it on or terminate

the programme (see Terminating the programme).

Fault Possible causes

Remedial action

More information can be found in the operating instructions

Utensils are not clean

Sand or gritty residue

on the utensils

Utensils are situated close together

or one above the other

Too little detergent

Unsuitable programme selected

Spray arm nozzles blocked

Filters dirty, not seated firmly

Spray arms blocked

Separate the utensils, prevent contact points.

Follow manufacturer’s instructions (detergent).

Select a more intensive programme.

Clean the spray arms (see above).

Clean the filters (see above).

Arrange the utensils so that the spray

arms can rotate freely.

Stains and streaks

Milky deposits

on the utensils

(can be removed)

Milky deposits, glasses

cloudy/tarnished

(cannot be removed)

Plastic/utensils

discoloured

Rinse aid dosage too high/too low

Water softening system incorrectly set

No salt

Glasses not dishwasher-proof

Too little detergent

Discoloration caused by food colourings

(tomato sauce)

Streaks: reduce dosage.

Water or limescale stains: increase dosage.

Correctly set water softening system.

Refill with special salt.

Use dishwasher- proof glasses.

Use a detergent suitable for glasses.

Follow manufacturer’s instructions (detergent).

Discoloration is harmless;

subsequent rinse cycles will cause it to fade.

Utensils not dry

Rinse aid Increase dosage.

Change the product.

The combined detergent used

has a poor drying performance

Use rinse aid.

Appliance setting

Activate intensive drying (depending on model).

Dishwasher-proof utensils (not soiled with ash, wax, lubricating grease, ink

or adhesive labels; remove large remnants of jam, milk products and food

according to the operating instructions and check that the spray arms can rotate freely.

While the programme is running,

press the START button

for approx. 3 sec. (Reset).

The numerical display

indicates “0:01”;

approx. 1 minute after

the programme ends,

“0:00” is indicated.

Switch off the appliance.

Terminating the programme ... Loading the dishwasher correctly ...

Produkt Specifikationer

Mærke:	Siemens
Kategori:	Opvaskemaskine
Model:	SN 25M230

Har du brug for hjælp?

Hvis du har brug for hjælp til Siemens SN 25M230 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Opvaskemaskine Siemens Manualer

Siemens SN 25M230 Manual

4 Oktober 2025

Siemens SE66T373EU Manual

3 Oktober 2025

Siemens SX66T052EU Manual

30 September 2025

Siemens iQ100 SX614X04AE Manual

25 September 2025

Siemens SN64E001EU Manual

19 September 2025

Siemens SN24E209EU Manual

19 September 2025

Siemens SN13EW04CS Manual

14 September 2025

Siemens SN13HW72CS Manual

14 September 2025

Siemens SN13ES04CS Manual

14 September 2025

Siemens SN25E803EU Manual

14 September 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Westinghouse WSF6602WC Manual

4 Oktober 2025

Westinghouse WSF6602XC Manual

4 Oktober 2025

Westinghouse WSF6608KXC Manual

4 Oktober 2025

Westinghouse WSU6608KXC Manual

4 Oktober 2025

Zanussi-Electrolux DE6855 Manual

4 Oktober 2025

Zanussi-Electrolux ZSF2400 Manual

4 Oktober 2025

Zanussi-Electrolux DE540X Manual

4 Oktober 2025

Zanussi-Electrolux ZDF601S Manual

3 Oktober 2025

Zanussi-Electrolux ZDF501S Manual

3 Oktober 2025

Zanussi-Electrolux DCS12W Manual

3 Oktober 2025