Sigma EF-530 DG ST Super (Canon) Manual

Sigma Blitz EF-530 DG ST Super (Canon)

Læs gratis den danske manual til Sigma EF-530 DG ST Super (Canon) (12 sider) i kategorien Blitz. Denne vejledning er vurderet som hjælpsom af 67 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 34 anmeldelser. Har du et spørgsmål om Sigma EF-530 DG ST Super (Canon), eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

ENGLISH

Thank you very much for purchasing the Sigma EF-530 DG SUPER EO-TTL II Electronic Flash. This

product is specifically developed for the Canon EOS series SLR cameras. Depending on the camera model,

functions and operation may vary. Please read this instruction booklet carefully. To add to your enjoyment

of photography, the flash has a variety of features. To make the most of all these to get the features and

maximum performance and enjoyment from your flash, please read this instruction booklet together with

your camera’s instruction manual before using the flash, and also keep it handy for your future reference.

PRECAUTIONS

In order to avoid causing any damage or injury, please read this instruction manual very carefully,

paying attention to the cautionary signs below, before using the flash.

Please take special note of the two cautionary signs below.

Warning !!

Caution!!

Symbol denotes the important points, where warning and caution are required.

Symbol contains information regarding the actions that must be avoided.

Using the product disregarding this warning sign might cause serious injur

or other dangerous results.

Using the product disregarding this caution sign might cause injury o

damage.

Warning !!

This flash contains high voltage circuits. To avoid electric shock or burns, do not attempt to

disassemble the flash. If the outside shell of the unit is broken or cracked, do not touch the

mechanism inside.

Do not fire the flash close to eyes. Otherwise the bright light could damage the eyes. Keep at least

1m/3feet distance between face and the flash unit when taking a picture with flash.

Do not touch the synchro terminal of your camera when the flash is attached to hot shoe. High the

voltage circuitry could cause an electric shock.

Never use your camera in an environment where flammable, burnable, gas, liquids or chemicals,

etc, exist. Otherwise it might cause fire or explosion.

Caution !!

Do not use this flash unit on any camera other than the Canon EOS series cameras, otherwise the

flash may damage the circuitry of these cameras.

This flash unit is not waterproof. When using the flash and camera in the rain or snow or near water,

keep it from getting wet. It is often impractical to repair internal electrical components damaged b

water.

Never subject the flash and camera to shock, dust, high temperature or humidity. These factors

might cause fire or malfunctioning of your equipment.

When the flash is subjected to sudden temperature change, as when the flash unit is brought from a

cold exterior to warm interior, condensation might form inside. In such a case, place your equipment

in a sealed plastic bag before such a change, and do not use the flash unit until it reaches room

temperature.

Do not store your flash in a drawer or cupboard etc. containing naphthalene, camphor or othe

insecticides. These chemicals will have a negative effects on the flash unit.

Do not use a thinner, Benzene or other cleaning agents to remove dirt or finger prints from the

component. Clean with a soft, moistened cloth.

For extended storage, choose a cool dry place, preferably with good ventilation. It is recommended

that the flash be charged and fired several times a month, to maintain proper capacitor functioning.

DESCRIPTION OF THE PARTS

EXTERNAL PARTS

1.Flash Head 2.Built-in Wide Panel 3.AF Auxiliary Light 4.Bounce Angle; Up and Down

5.Bounce Angle; Right and Left 6.Bounce Lock and Release Button; Up and Down 7.Swivel Lock

and Release Button; Right and Left 8.LCD Panel 9.Battery Cover 10.Shoe Ring 11.Shoe

CONTROLS

12.MODE Button 13.<SEL> SELECT Button 14.< + > Increment Button 15.< - > Decrement Button

16.ZOOM Button 17.TEST Button 18.LIGHT Button 19.Ready Light 20.Power Switch

CAMERA MODELS AND FUNCTIONS

Although this Flash unit has been equipped with numerous functions, depending on the camera model

being used some functions may have some limitations. Please confirm the type camera you have from the

list below. Please refer to explanations of each function through the instruction manual; If no model

information is specified, it means that this function of flash can be used with all type of EOS cameras.

A type camera E-TTL(E-TTL II) Compatible EOS SLR cameras

B type camera All other EOS cameras except those listed above

ABOUT THE BATTERY

This flash unit uses four “AA” type Alkaline dry cell batteries, Ni-Cad or Ni-MH rechargeable batteries.

Manganese batteries can also be used but as they have a shorter life than Alkaline batteries, we do not

recommend using them. Please replace batteries if it takes more than 30seconds to light the Ready Lamp.

◆ To assure proper electrical contact, clean the battery terminals before installing the batteries.

◆ NiCad batteries do not have standardized contacts. If you use NiCad batteries, please confirm that the

battery contacts touch the battery compartment properly.

◆ To prevent battery explosion, leakage or overheating, use four new AA batteries of the same type and

brand. Do not mix the type or new and used batteries.

◆ Do not disassemble or short-circuit the batteries, or expose them fire or water; they may explode. Do not

recharge the batteries other than Ni-Cd or Ni-MH rechargeable batteries.

◆ When the flash will not be used for an extended period of time, remove the batteries from the flash to

avoid the possibility of damage from leakage.

◆

Battery performance decreases at low temperatures. Keep batteries insulated when using the flash in cold weather.

◆ As with any flash, it is recommended you carry spare batteries when on a long trip or when

photographing outdoors in cold weather.

BATTERY LOADING

1. Be sure to set the Power Switch to the off position

then slide the battery cover in the direction of the

arrow to open.

2. Insert four AA size batteries into the battery chamber.

Be sure the + and – ends of the batteries are aligned

according to the diagram in the chamber.

3. Close the cover.

4. Slide the Power Switch to the ON position. After few seconds the Ready Lamp will light, indicating that

the flash unit can be fired.

5. Please press the “Test Button” to be sure that the flash is working properly.

AUTO POWER OFF

To conserve battery power, the flash unit automatically turns itself off when the flash is not used within

approximately 90 seconds. To turn the flash on again, depress the “TEST” button or the camera shutter

button halfway. Please note that the “Auto Power Off” mechanism does not work with wireless TTL flash

mode, normal slave flash, and designated slave flash modes.

ERROR INDICATION

If the battery power is not sufficient or there is an electric information error between the camera and flash unit,

the “Flash Coverage Angle” will blink on the LCD panel. When this occurs, turn the power switch off and on.

Produkt Specifikationer

Mærke:	Sigma
Kategori:	Blitz
Model:	EF-530 DG ST Super (Canon)

Har du brug for hjælp?

Hvis du har brug for hjælp til Sigma EF-530 DG ST Super (Canon) stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Blitz Sigma Manualer

Sigma EF-500 Manual

23 August 2024

Sigma EM-140 DG Macro Flash Canon Manual

7 August 2024

Sigma EF-610 DG ST (Nikon) Manual

5 August 2024

Sigma EF-610 Super Manual

31 Juli 2024

Sigma EF-530 DG ST Super (Canon) Manual

31 Juli 2024

Sigma EF-610 DG ST (Canon) Manual

21 Juli 2024

Sigma EF-610 DG ST Super (Sony) Manual

19 Juli 2024

Sigma EF-610 DG ST Super (Canon) Manual

18 Juli 2024

Blitz Manualer

Nyeste Blitz Manualer

Smith-Victor Orbit Pro Manual

24 Februar 2025

8 Januar 2025

8 Januar 2025

8 Januar 2025

8 Januar 2025

6 Januar 2025

Quantum Omicron 3 Manual

27 December 2024

Sony FDA-V1K Manual

22 December 2024

Sony FA-SHC1AM Manual

22 December 2024

Sony HVL-IRM Manual

22 December 2024