SkyRC NC1500 Manual

SkyRC Batterioplader NC1500

Læs gratis den danske manual til SkyRC NC1500 (2 sider) i kategorien Batterioplader. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om SkyRC NC1500, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Thank you for purchasing SkyRC NC1500 AA/AAA Battery Charger & Analyzer.

Charging batteries is usually a primitive, boring and mundane activity, and it still is. What matters during the charging

activity, especially for AA/AAA NiMH battery charging? No doubt, accuracy and safety. The creation of NC1500 charger

not only arises out of need, but also from the desire to have a simple but safe and accurate charger for such battery.

NC1500 has 4 independent slots and supports AA/AAA NiMH batteries, offers maximum charge rate of 1500mA.

INSTRUCTIONMANUAL

SK-100154

INTRODUCTION

NC1500

AA/AAA NiMH Battery Charger & Analyzer

To change the operation modes

among REFRESH, CHARGE and

DISCHARGE.

To select charge or

discharge current.

To display the battery

voltage, current, capacity,

elapsed time and internal

resistance.

To switch access between slots.

LCD Display

BatterySlots

USB Power Input

5V/2.1A

A good USB power

adapter with at least

2.1A(or 2100mA)

output is required.

CHARGE

DISCHARGE

REFRESH

m V mAh

CHARGE

DISCHARGE

REFRESH

m V mAh

CHARGE

DISCHARGE

REFRESH

m V mAh

CHARGE

DISCHARGE

REFRESH

Function Indicator

Number Display Area

m V mAh

Unit(mA,V,mAh,h, )

*At the start of a program, the device always performs a quick standard

test first in order to determine the internal battery resistance. Aged or

poor condition batteries have a higher IR and therefore heat up more

during charge or discharge. The values are estimates and will vary

depending on the state of the batteries and operation environment.

mAh

Charge or discharge current

Battery voltage

Battery capacity

Hour (duration of operation)

Battery internal resistance

OPERATION

FEATURES

1. CHARGE

Charges your battery with selected constant current. Charging terminates when the battery is full or some other

termination criteria has been met. Useful when battery needs to be recharged. Should be used on batteries

known to be in good condition and which have been in continuous use.

Once the process is initiated, no other operations, like mode change, current selection etc. will be accepted.

Users, however, can click to check the battery real-time parameters like current, voltage, charge

capacity, internal resistance and elapsed time.

Insert a battery into slot.

After setting, the interface will stop flashing and CHARGE will initiate automatically 8 seconds later.

Press CURRENT

Displays Full when the CHARGE

process has finished.

This function allows you to charge a single AA or AAA or mixed with AA and AAA battery up to four at one time.

Connect the USB power adapter to the charger. A good USB power adapter with at least

2.1A(or 2100mA) output is required to power up NC1500.

Press to select charge current (200, 500, 700, 1000, 1500mA),

CHARGE

Note: As the 4 slots are independent from each other, we only take slot 1 as an example for below

operation mode descriptions.

CHARGE

Four independent slots, can charge 1-4 pcs of

NiMH AA or AAA in any combinations.

Individual battery charging status

LCD display for easy reading.

Four buttons for easy operation.

Three modes of operation:

CHARGE, DISCHARGE and REFRESH.

Battery internal resistance detection

or power bank.

Maximum 1500mA charge rate for 1 or 2 batteries.

Termination methods:

- Individual minus delta voltage (-dV)

- Individual safety timer

- Temperature sensor

Trickle charge: to always have fully charged batteries

Maximum charging current can be set at 1500mA when only ONE or TWO batteries are charged.

The maximum charging current for THREE or FOUR batteries is 1000mA.

Trickle charging: After the battery is fully charged, the charger will give a small amount of current to

maintain the fully charged level.

~100min

~2h 30min

~3h 30min

~5h

~13H

~60min

~70min

~100min

~5h

1500 (1 or 2 Pcs)

1000

700

500

200

1000

700

500

200

Size of Battery

Battery Capacity

Charging Current Selected (mA)

Estimated Charging Time

2600mA

1000mA

AAA

Charging Time with Various Charging Current

Charge times are a guide only. Timing may differ according to brands/mAh capacity and environment conditions at

the time of charge

Produkt Specifikationer

Mærke:	SkyRC
Kategori:	Batterioplader
Model:	NC1500

Har du brug for hjælp?

Hvis du har brug for hjælp til SkyRC NC1500 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Batterioplader SkyRC Manualer

8 December 2025

8 December 2025

8 December 2025

8 December 2025

7 December 2025

7 December 2025

SkyRC T1000 Maestro Manual

7 December 2025

SkyRC Q100neo Manual

7 December 2025

SkyRC PC3000H Manual

7 December 2025

SkyRC iMAX B6AC V2 Manual

7 December 2025

Batterioplader Manualer

Nyeste Batterioplader Manualer

Draper 53490 Manual

6 December 2025

Powertec BC2A-Li40V Manual

5 December 2025

Scheppach BC3A-Li18V Manual

4 December 2025

Schumacher SC1280 Manual

4 December 2025

Aqiila Sunbird P100 Manual

3 December 2025

Schumacher SC1361 Manual

3 December 2025

Alogic Smartbox SB-DCS7C Manual

3 December 2025

Dometic SinePower DSP 1524 Manual

3 December 2025

Dometic SinePower DSP 1512 Manual

1 December 2025

Dometic SinePower DSP 1024 Manual

28 November 2025