Smeg CO200 Manual

Smeg Fryser CO200

Læs gratis den danske manual til Smeg CO200 (5 sider) i kategorien Fryser. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Smeg CO200, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

INSTRUCTIONS FOR USE

1. Lid handle.

2. Lock (if provided).

3. Seal.

4. Defrost water drain plug (depending on model).

5. Control panel.

6. Basket (depending on model).

7. Condenser (located at the rear).

INSTALLATION

•Refer to chapter “Before using the appliance”.

•Unpack the appliance.

•Remove the 4 protection pieces inserted between lid

and appliance.

•Warning: two of the four protection pieces must be

fitted in the seat of the condenser plastic supports,

located at the rear of the product.

This is necessary to ensure the correct distance from the

wall.

•Ensure that the defrosting water drainage plug (if provided) is

correctly positioned (4).

•For best operation of the appliance and in order to avoid

damage when the lid is opened, leave a space of at least 7

cm from the rear wall and 7 cm at the sides.

•Fit the accessories (if provided).

1. Thermostat: Temperature adjustment.

2. Red LED (if provided): indicates that the appliance

temperature is not sufficiently low.

3. Green LED (if provided): indicates that the appliance

is on.

4. Yellow LED (if provided): indicates that the fast freeze

function is active.

5. Fast freeze button (if provided): press to activate the

fast freeze function.

Switching on the appliance

•The appliance is factory set for optimum operation at a

temperature of -18°C.

•Plug in the appliance.

•The green LED lights up (if provided).

•Also the red LED (if provided) will switch on because the

temperature inside the appliance is not yet sufficiently low for

food storage. The red LED will normally switch off within the

first six hours after the appliance is switched on.

•After connecting the appliance to the mains supply

and when the optimal temperature has been reached

(this phase takes about 1 hour during which the lid

will not open), ensure that the fast freeze button is

not pressed (the yellow LED, if provided, is off)

•Place food inside the product only when the red LED

(if provided) has switched off.

•Thanks to the efficient lid seal, the appliance lid will not

re-open easily immediately after closing.

Wait a few minutes before re-opening the lid of the

appliance.

Temperature Adjustment

Use the thermostat to select the ideal storage temperature.

To adjust the internal temperature, proceed as follows:

•Turn the thermostat knob



to 1 for a storage temperature that

is less cold.

•Turn the thermostat knob to 6 / for a colder storage

temperature.

•When the appliance is only partially full, choose a lower

thermostat setting. For average loads, set the thermostat

to “3 Eco/e” to optimize energy consumption.

Climatic Class Amb. T. (°C) Amb. T. (°F)

SN From 10 to 32 From 50 to 90

N From 16 to 32 From 61 to 90

ST From 16 to 38 From 61 to 100

T From 16 to 43 From 61 to 110

Produkt Specifikationer

Mærke:	Smeg
Kategori:	Fryser
Model:	CO200
Bredde:	810 mm
Dybde:	650 mm
Højde:	870 mm
Produktfarve:	Hvid
Produkttype:	Kiste
Energieffektivitetsklasse (gammel):	A+
Placering af apparat:	Fritstående
Fryser, netto rumindhold:	204 L
Fryser, brutto rumindhold:	207 L
Frysekapacitet:	15 kg/24t
Stjernebedømmelse:	4*
Hurtig frys funktion:	Ja
Fryser antal hylder/kurve:	1