INSTRUCTIONS FOR USE
GB
1. Lid handle.
2. Lock (if provided).
3. Seal.
4. Divider (if provided).
5. Defrost water drain plug.
6. Control panel.
7. Side motor cooling grille.
8. Upper edge.
9. Condenser (located at the rear)
INSTALLATION
• Refer to the section “BEFORE USING THE
APPLIANCE”.
• Unpack the appliance.
• Remove the 4 protection pieces inserted between
lid and appliance.
• Make sure the defrost water drain plug (if provided) is
correctly positioned (5).
• For best appliance operation and to avoid damage when
the lid is opened, leave a space of at least 7 cm from
the rear wall and 7 cm at the sides.
• Fit the accessories (if provided).
1. Temperature adjustment thermostat.
2. Red LED (if provided): indicates that the appliance
temperature is not sufficiently low.
3. Green LED (if provided): indicates that the appliance is
on.
4. Yellow/orange illuminated button (if provided):
activates/deactivates the fast freeze function. It lights up
when the fast freeze function is active.
The exact configuration of the controls may vary
according to the model.
Switching on the appliance
• The appliance is factory set for optimum operation at a
temperature of -18°C.
• Plug in the appliance
• The green LED lights up (if provided).
• Also the red LED (if provided) will switch on because the
temperature inside the appliance is not yet sufficiently
low for food storage. The red LED will normally switch
off within the first six hours after the appliance is
switched on.
• After connecting the appliance to the mains supply and
when the optimal temperature has been reached (this
phase takes about 1 hour during which the lid will not
open), ensure that the fast freeze button is not pressed
(the yellow LED, if provided, is off).
• Place food inside the product only when the red LED (if
provided) has switched off.
• As the seal is tight, the appliance lid cannot be re-opened
immediately after closing. Wait a few minutes before re-
opening the lid of the appliance.
Temperature Adjustment
Use the thermostat to select the ideal storage temperature.
To adjust the internal temperature, proceed as follows
• Turn the thermostat knob to 1 for a storage temperature
that is less cold.
• Turn the thermostat knob to 6 / for a colder storage
temperature.
• When the appliance is only partially full, it is advisable to
set the thermostat to lower positions. For average loads,
set the thermostat to “3 Eco/e” to optimize energy
consumption.
CO Big
Climatic Class Amb. T. (°C) Amb. T. (°F)
SN From 10 to 32 From 50 to 90
N From 16 to 32 From 61 to 90
ST From 16 to 38 From 61 to 100
T From 16 to 43 From 61 to 110
