Smeg CR324PNF Manual

Smeg Køleskab CR324PNF

Læs gratis den danske manual til Smeg CR324PNF (23 sider) i kategorien Køleskab. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Smeg CR324PNF, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/23
DESCRIPTION OF PRODUCT
FINDKNSGRIPENLFGBD
GB
On / Off
Press to activate/deactivate the appliance.
Note: This operation does not disconnect the
appliance from the power supply.
Fan (where provided)
The fan is factory set to ACTIVE.
The fan can be deactivated by pressing the
button on the base (as shown in the figure). If
the room temperature exceeds 27°C or if
water droplets form on the glass shelves, the
fan must be on in order to guarantee the
correct preservation of food. Deactivation of the fan enables energy
consumption to be optimised.
Fast Cool Function
Press the "Temperature" button for 3 seconds to cool the
refrigerator compartment quickly, or 6 hours before placing large
quantities of fresh food in the freezer compartment. When the
function is active, the yellow light is on and the three green lights
are off. This function is automatically deactivated after 30 hours, or
manually by pressing the button again for 3 seconds. When the
function is not active, the yellow light is off and the indication of the
set temperature is shown by the green lights.
Note: Do not place fresh food to be frozen in direct contact with
already frozen food.
5019 608 01100
Printed in Italy 11/11
Refrigerator compartment temperature
The three green lights indicate the set refrigerator compartment
temperature.
A different temperature can be set using the "Temperature "
button.
The following adjustments are possible:
LED's on Set temperature
High (least cold)
Medium-high
Intermediate
Medium-low
Low (coldest)
Refrigerator Compartment
A. Fan and antibacterial and antiodour filter (depending
on the model)
B. Lamp or LED light (depending on the model)
C. Shelves
D. LED lights (depending on the model)
E. Crisper drawer cover
F. Crisper(s)
G. Rating plate (located at side of crisper)
H. Control panel
N. Dairy compartment
O. Door trays
P. Bottle holder (if provided)
Q. Bottle bin
Least cold zone
Intermediate zone
Coldest zone
Fruit and vegetable zone
Freezer Compartment
I. Top drawer (freezing area)
L. Middle and bottom drawers (storage area for frozen
and deep frozen food)
M. Ice cube tray (if provided)
Note: All shelves, door trays and racks are removable.
The ideal temperatures for preserving foods are already
factory-set.
Carefully read the user handbook provided before
using the appliance.
The characteristics, technical data and images may
vary according to the model.
What to do if... Possible causes: Cures:
The control panel is switched off, the appliance does not work.
The appliance could be in off mode.
There may be an appliance power supply problem.
Activate the appliance with the On/Off button
Make sure:
- there is not a power outage
- the plug is properly inserted in the power socket and the mains double-pole switch (if present) is in the correct position
(i.e. allows the appliance to be powered)
- the household electrical system protection devices are efficient
- the power cable is not broken.
The inside light does not work. The light may need replacing.
Models with lamp: disconnect the appliance from the power supply, check the lamp and, if necessary, replace it with a
new one (see the section "Lamp or LED replacement").
Models with LED lights: contact the authorised Service Centre.
The temperature inside the compartments is not low enough. There could be various causes (see "Cures")
Make sure:
- the doors close properly
- the appliance is not installed near a heat source
- the set temperature is adequate
- the circulation of air through the vents at the bottom of the appliance is not obstructed
There is water on the bottom of the refrigerator compartment.
The defrost water drain is blocked. Clean the defrost water drain hole (see the section "Appliance Maintenance and Cleaning")
The front edge of the appliance, at the door striker seal, is hot. This is not a defect It prevents condensation from forming. No remedy is necessary.
One or more indicator lights flash. Malfunction alarm
The alarm indicates a fault in a technical component.
Call the authorised Service Centre.
The appliance continues to maintain minimum preservation conditions.
Always unplug the refrigerator before replacing any light bulbs, then follow the relevant instructions in
accordance with the type of lighting fitted in your appliance.
Only use bulbs of the same type, which can be requested from the After-Sales Service and authorised
dealers.
Lighting type 1)
1. Loosen the screws and take off the lamp cover.
2. The lamp has a bayonet bulb and needs to be pulled out, not
unscrewed, following the directions of the arrows as
indicated.
3. After the new bulb has been inserted, replace the lamp cover
and wait five minutes before plugging the appliance back in.
Lighting type 2)
To remove the light bulb, turn anticlockwise as shown in the figure.
Wait for 5 minutes before reconnecting the appliance.
Lighting type 3)
If the product has LED lighting which is in need of
replacing, contact the After-Sales Service for assistance.
LED lights last longer than normal bulbs, they illuminate
better and are more environmentally friendly
10
Clean the appliance regularly using a cloth and a solution of lukewarm
water and neutral detergent specifically formulated for refrigerator
interiors. Never use abrasive detergents. Clean inside the defrost water
drain outlet on the rear wall of the refrigerator (near the fruit and
vegetable crisper drawer) regularly, using the tool supplied with the
appliance so as to ensure defrost water is removed correctly (see figure).
Before all cleaning or maintenance procedures, unplug the appliance from
the mains or disconnect the electricity supply.
2
1
Connect the appliance to the mains power supply.
A beep may be emitted by some models, to indicate that the temperature alarm has intervened: press and
hold the button to switch off acoustic alarms. As applicable, insert the anti-bacterial/anti-odour filter into
the fan as indicated on the filter package.
Note: after switching on, the refrigerator needs approximately 4/5 hours to reach the correct
temperature for storing a normal fridge load of food.
FIRST USE
APPLIANCE MAINTENANCE
AND CLEANING
CHANGING THE BULB OR LED (depending on the model)

Produkt Specifikationer

Mærke: Smeg
Kategori: Køleskab
Model: CR324PNF

Har du brug for hjælp?

Hvis du har brug for hjælp til Smeg CR324PNF stil et spørgsmål nedenfor, og andre brugere vil svare dig


Køleskab Smeg Manualer

Smeg

Smeg FAB10HLBL6 Manual

8 September 2025
Smeg

Smeg FC20EN1M1 Manual

3 September 2025
Smeg

Smeg FAB30RCR6 Manual

3 September 2025
Smeg

Smeg RBMU30R Manual

2 September 2025
Smeg

Smeg RSDU36RX Manual

2 September 2025
Smeg

Smeg FAB5RSV6 Manual

2 September 2025
Smeg

Smeg FAB5RDGME6 Manual

2 September 2025
Smeg

Smeg RBMU30RX Manual

2 September 2025
Smeg

Smeg RBMU36R Manual

2 September 2025
Smeg

Smeg RBMU36RX Manual

2 September 2025

Køleskab Manualer

Nyeste Køleskab Manualer

Snaigė

Snaigė Retro FR25SM-PRJ30F3 Manual

12 September 2025
Sub-Zero

Sub-Zero BI30 Manual

12 September 2025
Vivax

Vivax CF-310ENF X Manual

12 September 2025
Gorenje

Gorenje NRR9185ESBXL Manual

12 September 2025
Snaigė

Snaigė Retro R 13SM-PRJ30F3 Manual

12 September 2025
Sub-Zero

Sub-Zero UC-15IP Manual

12 September 2025
Barazza

Barazza 1FCE6I Manual

12 September 2025
Kubo

Kubo KBSD8326 Manual

12 September 2025
Vivax

Vivax DD-207E S Manual

12 September 2025
Gorenje

Gorenje N619EAW4 Manual

12 September 2025