Snom A230 Manual


Læs gratis den danske manual til Snom A230 (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om Snom A230, eller vil du spørge andre brugere om produktet?

Side 1/3
v2021001_w
A230
USB DECT Dongle
Important Information
Please read the instructions on safety and disposal and on how to set up and use the device before using it
and also give them to other users to read or inform those users of their contents. Save this document and
do not give the device to third parties without it.
Safety Instructions
Follow the instructions in the manual and other applicable documentation of the device.
Handle the product with care. Crushing, wrenching, or dropping it from even moderate heights may
damage it.
This device is for indoor use only! Do not install outdoors - NOT FOR OUTDOOR USE!
Do not install the device in rooms with high humidity (for example, in bathrooms, laundry rooms, damp
basements).
Do not immerse the device in water and do not spill or pour liquids of any kind onto or into the device.
Do not expose the product to extreme heat.
Standards Conformance
This device complies with Directive 2014/53/EU and the essential health, safety, and environmental
requirements of all relevant European and Australian directives. This device complies with the Radio
Equipment Regulations 2017 and the essential health, safety, and environmental requirements of all
relevant UK legislation. The declaration of conformity can be downloaded at https://www.snom.com/
conformity. Unauthorized opening, changing, or modifying the device will cause the warranty to lapse
and may also result in the loss of CE conformity. In case of malfunction contact authorized service
personnel, your seller, or Snom.
Safety: IEC 62368-1
Disposal
This device is subject to European Directive 2012/19/EU and may not be disposed of with general
household garbage. If you do not know where you may dispose of the device at the end of its lifespan,
contact your municipality, your local waste management provider, or your seller.
Registering a wireless device (speakerphone, headset)
1. Remove the dongle‘s protective cap.
2. Insert the dongle into the USB port.
3. Press the key on the dongle for 4 seconds to enter registration mode; the red
LED begins to double-ash rapidly. You now have 10 seconds to register the
device.
4. For pairing with A170/A150 headsets and C52-SP, see reverse side. For pairing
with other wireless devices, please refer to the manuals of the devices.
Deregistering
1. Press the key on the dongle for 10 seconds to enter deregistration mode. After 4 seconds the red LED
starts to double-ash; after 10 seconds the LED starts to ash red rapidly, indicating that the dongle has
entered deregistration mode.
2. Release the key and press it again for 1 second to conrm deregistration. The LED turns green for three
seconds, turns o for one second and then shows steady red light.
v2021001_w
2
A230 DECT USB-Stick
LED status indications
Description of state Pattern Green Red
Standby mode, no wireless device subscribed Steady - ON
In registration mode (duration 10 seconds) -Rapid double ashes ON
Standby, wireless device subscribed OFF - -
Ready to enter deregistration mode Rapid ashing ON
After deregistration mode has been conrmed:
1. Duration: 3 seconds Steady ON
2. Duration: 1 second OFF - -
3. Back in standby, no wireless device subscribed Steady - ON
Compatible with
Wireless headsets Snom A170, A150
wireless speakerphone Snom C52-SP
Pairing with A170/A150 headsets
1. Deregister the headset from its base station or from another dongle it may have been paired with. Please
refer to the user instructions of the headset or the dongle on how to do it. When the headset has been
deregistered, its LED blinks red and green alternatingly.
2. Press the key on the A230 for 4 seconds, then place the headset in its charger. The A230‘s red LED dou-
ble-ashes rapidly and turns o when the registration has been successful, while the headmit beeps once
and its LED switches to steady light (green if fully charged, red if charging).
Pairing with C52SP speakerphone
NOTE: If the speakerphone was previously registered to another DECT dongle or a C520-WiMi conference
phone, it must be deregistered rst.
For the deregistration from another A230 DECT dongle, see reverse side.
For the deregistration from the C520-WiMi, please refer to the C520-WiMi
user manual.
NOTE: The C52SP‘s battery must be fully charged, and the device must be connected
to a wall outlet via its power adapter. Keep distance between C52SP and A230
at < 30 cm until pairing was successful.
1. Press the white registration button underneath the battery compartment on the
bottom of the speakerphone for 5 seconds until the speakerphone‘s LEDs start ashing red and green
alternatingly.
2. Press the key on the A230 for 4 seconds. The red LED double-ashes rapidly and
turns o when the registration has been successful. The LEDs on the C52-SP briey
turn green and then turn o while the red Power LED turns on.
Pairing with both: One C52 SP and one headset can be registered at the A230.


Produkt Specifikationer

Mærke: Snom
Kategori: Ikke kategoriseret
Model: A230

Har du brug for hjælp?

Hvis du har brug for hjælp til Snom A230 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Snom Manualer

Snom

Snom D785 Manual

3 Juni 2025
Snom

Snom D812 Manual

4 Marts 2025
Snom

Snom D815W Manual

4 Marts 2025
Snom

Snom D8C Manual

4 Marts 2025
Snom

Snom HD351A Manual

5 Januar 2025
Snom

Snom HD300 Manual

5 Januar 2025
Snom

Snom HD350A Manual

5 Januar 2025
Snom

Snom A5E Manual

1 December 2024
Snom

Snom HD300A Manual

4 November 2024
Snom

Snom HD30LA Manual

2 November 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer