Owner’s Record
The model number and serial number
are located at the rear of the product.
Record the serial number in the space
provided below. Refer to them
whenever you call upon your Sony
dealer regarding this product.
Model No. PEGA-SA10
Serial No.______________
CAUTION
You are cautioned that any changes or
modifications not expressly approved
in this manual could void your
authority to operate this equipment.
This Class B digital apparatus
complies with Canadian ICES-003.
Cet appareil numerique de la classe B
est conforme a la norme NMB-003 du
Canada.
NOTE
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined
by rotating the equipment off and on,
the user is encouraged to try to correct
the interference using one or more of
the following measures:
–
Increase the separation between
the equipment and receiver.
– Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
– Consult the dealer or an
experienced radio/TV technician
for help.
If you have question about this
product, call the Sony Customer
Information Center at keep on next
line 1-877-760-7669; or write to the
Sony Customer Information Center at
12451 Gateway Boulevard, Fort Myers,
FL 33913. The number below is for
FCC-related matters only.
Declaration of Conformity
Trade Name: SONY
Model No.: PEGA-SA10
Responsible Party: Sony
Electronics Inc.
Address: 680 Kinderkamack Road,
Oradell, NJ 07649 USA
Telephone No.: 201-930-6972
This device complies with part 15
of the FCC Rules.
Operation is subject to the
following two conditions:
(1) This device may not cause
harmful interference, and
(2) This device must accept any
interference received,
including interference that
may cause undesired
operation.
The supplied interface cable must be
used with the equipment in order to
comply with the limits for a digital
device pursuant to Subpart B of Part
15 of FCC Rules.
