
To parents/guardians
Electronic products can lead to a re or personal injury if not used under 
safety instructions.
This leaet contains important instructions to prevent accidents. Please read the instructions carefully 
and use this product safely. Please keep this leaet handy for future reference.
FCC CAUTION 
Changes or modications not expressly 
approved by the party responsible for 
compliance could void the user’s authority 
to operate the equipment.
This equipment has been tested and found 
to comply with the limits for a Class B 
digital device, pursuant to part 15 of the FCC 
Rules. These limits are designed to provide 
reasonable protection against harmful 
interference in a residential installation. 
This equipment generates, uses and can 
radiate radio frequency energy and, if not 
installed and used in accordance with the 
instructions, may cause harmful interference 
to radio communications. However, there 
is no guarantee that interference will not 
occur in a particular installation.
WARNING:
This transmitter must not be co-located 
or operated in conjunction with any other 
antenna or transmitter.
For question regarding your product or for 
the Sony Service Center nearest you, call 
1-866-935-7669 in the United States.
Declaration of Conformity
Trade Name : SONY 
Model : EKV-250B
Responsible Party : Sony Electronics Inc. 
Address : 16535 Via Esprillo, San Diego, CA 
92127 U.S.A. Telephone Number : 1-858-
942-2230
Caution Exposure to radio frequency 
radiation 
This equipment complies with FCC radiation 
exposure limits set forth for an uncontrolled 
environment and meets the FCC radio 
frequency (RF) Exposure Guidelines. This 
equipment has very low levels of RF 
energy that is deemed to comply without 
maximum permissive exposure evaluation 
(MPE).
If this equipment does cause harmful 
interference to radio or television reception, 
which can be determined by turning 
the equipment o and on, the user is 
encouraged to try to correct the interference 
by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the 
equipment and receiver.
--Connect the equipment into an outlet on 
a circuit dierent from that to which the 
receiver is connected.
--Consult the dealer or an experienced 
radio/TV technician for help.
This device complies with part 15 of the 
FCC rules. Operation is subject to the 
following two conditions: (1) This device 
may not cause harmful interference, and 
(2) this device must accept any interference 
received, including interference that may 
cause undesired operation.