Speakman SR-2256-E2 Manual

Speakman Brusehoved SR-2256-E2

Læs gratis den danske manual til Speakman SR-2256-E2 (1 sider) i kategorien Brusehoved. Denne vejledning er vurderet som hjælpsom af 6 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 3.5 anmeldelser. Har du et spørgsmål om Speakman SR-2256-E2, eller vil du spørge andre brugere om produktet?

Side 1/1
800-537-2107
www.speakman.com
NEED HELP?
For additional assistance or service please contact:
92-SR-2256-01
SR-2256 SERIES
INSTALLATION INSTRUCTIONS
Icon Shower Head
Thread Seal Tape
(INCLUDED)
Adjustable
Wrench
IMPORTANT
MAINTENANCE
SAFETY TIPS:
Be sure to read and understand all instructions
before beginning installation.
Inspect all connections after installation.
Cover the drain to avoid loss of parts.
Be sure to wear proper eye protection.
Do NOT over tighten any connections or damage
may occur.
Shut OFF water supplies before beginning
installation.
Observe all local plumbing and building codes.
Periodic cleaning using a mild soap and warm
water will help keep your shower’s appearance in
its original condition.
For best results, dry immediately with a soft, clean
cloth. DO NOT USE harsh and/or abrasive
cleaners.
To help restore the finish, occasionally apply a
non-abrasive wax to your shower (follow
manufacturers instructions).
On CHROME PLATED SHOWERS, a two (2) part
white vinegar, one (1) part water solution can be
used to break down excessive mineral deposits on
the sprays. Let the showerhead soak in the solution
for about ½ hour then rinse thoroughly. Brush off
any remaining mineral deposits if necessary.
DO NOT USE the vinegar/water treatment on any
finish other than Chrome.
To reduce mineral build-up, turn the handle to
FLOOD position to let the water drain out after
every use.
APPLY THREAD SEAL TAPE
1
Apply the included Thread Seal Tape to the
outlet side of shower arm in a clockwise
direction.
INSTALL SHOWER HEAD
2
Thread Shower Head onto shower arm by
turning it in a clockwise direction. Tighten with
Adjustable Wrench. Turn water supply on and
check for leaks.
ADJUST SPRAY PATTERN
3
Adjust spray pattern by rotating side handle
to preferred Anystream
®
position.
Inlet: 1/2” NPT FEMALE
Model: -E175SR-2256
Max. Flow Rate: 1.75 gpm (6.6 L/min)
Min. Flow Rate: 1.5 gpm (5.7 L/min) @ 45psi
FOR USE WITH AUTOMATIC COMPENSATING VALVES RATED AT
5.7 L/MIN (1.50 GPM) OR LESS.
Model: SR-2256-E2
Max. Flow Rate: 2.0 gpm (7.6 L/min)
Min. Flow Rate: 1.75 gpm (6.6 L/min) @ 45psi
FOR USE WITH AUTOMATIC COMPENSATING VALVES RATED AT
6.6 L/MIN (1.75 GPM) OR LESS.
4
3
16
"
106mm
4
1
16
"
103mm
3
1
4
"
82mm
ROUGH IN DIAGRAM


Produkt Specifikationer

Mærke: Speakman
Kategori: Brusehoved
Model: SR-2256-E2

Har du brug for hjælp?

Hvis du har brug for hjælp til Speakman SR-2256-E2 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Brusehoved Speakman Manualer

Brusehoved Manualer

Nyeste Brusehoved Manualer