Speco Technologies SPCBC6 Manual

Speco Technologies Højttaler SPCBC6

Læs gratis den danske manual til Speco Technologies SPCBC6 (2 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 37 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 19 anmeldelser. Har du et spørgsmål om Speco Technologies SPCBC6, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Where Place Your In-Ceiling SpeakersTo

Placement can make all the difference in how your speakers sound, and how easy they will be to

install. Carefully consider where your speakers should be positioned. For optimum performance,

speakers should be mounted to the left and right of the main listening area and a minimum of 8 to

10 feet apart (See Fig. 2). Avoid mounting speakers in stud cavities containing electrical wiring,

heating ducts, water pipes, etc. Make sure the ceiling materials are sturdy enough to support the

weight of the speakers.

Adjustable eetersTw (Fig. 3)

The tweeter in your Speco speaker may be adjusted, allowing you to tailor the speaker to better

fit the listening area. The overall smoothest response is achieved with the tweeter facing straight

out; however, you may find the sound more pleasing by aiming tweeters toward a particular listen-

ing area. adjust the tweeter, grasp the outside of the tweeter plate and gently pivot it toward theTo

listening area.

Speaker Installation In Existing Construction (See )Fig. 4

Once you have selected the location for your speakers, you are ready to install them.

You will need the following:

• Stud Finder • Drill & Drill Bits • CutterWire /Strippers • Speaker Wire

• ncil • Phillips Scr • Utility Knife or Drywall Saw • Masking TapePe ewdriver

Speco recommends the use of 16-gauge wire minimum. For wire options, consult your retailer or

custom audio contractor.

1. Speco Speakers are designed to be installed in the ceiling or wall area between studs. Using a stud

finder, make sure you are between two studs. Tape the supplied template to the wall and lightly trace

around the inside with a pencil.

2. Cut the hole using your drywall saw. You may want to start with a small hole in the center of the

outline. This will allow you to check for any obstructions that may exist behind the desired location.

CAUTION: Be certain electrical wiring, water pipes or heating ducts do not interfere in the planned

installation areas prior to drilling or cutting the wall.

3. Run speaker wire from your amplifier or speaker switching device to the speaker location.

4. Carefully remove the grille and inner grille backing.

(Note: The open cell foam

inner grille backing is

designed to hide speaker

components from view

and may be removed if

desired.) If you like the

standard white finish of

your Speco speakers, skip

to step 5, but if you want

your speakers to blend in

with a colored wall or

ceiling, now is the time

to paint your speaker’s

Congratulations on choosing Speco

Architectural Loudspeakers. Like all

Speco products, great care has been taken

in their design. Their combination of

advanced engineering and state-of-the-art

materials will provide you with years of

listening pleasure, while blending

smoothly into your home’s decor. Before

you get started, it is a good idea to identify

all the parts and hardware (See Fig. 1). Speaker with self-contained

mounting clamps

Metal grille with foam

inner grille cover

FIG. 2

Speco ceiling speakers can e used as b rear

surround hannels by mounting them (1)c

on each side of, (2) just behind, or (3) in

back of the viewing position.

FIG. 3

Black

grille

adhesive

(Continued on verse)re

Model S CBC6 P

61/2˝ Two-Way In-Ceiling Speaker Systems

Cutout

template

Painting mask

Pivoting

tweeter

Grille

removal

tool

FIG. 1

FIG. 4

outer frame and perforated grille.

(Continued from front)

(Remove the foam inner grille backing and put it

aside in a clean and dust free area for later rein-

stallation if desired.) The speaker outer surface’s

will accept ordinary latex wall paint or aerosol

spray paint. Because the speaker baffle surface

behind the grille should remain unpainted, you will

need to cover this area with the supplied cardboard

paint mask. Cover the speaker interior black sur’s -

face, woofer and tweeter. Paint the outer speaker

frame and grille separately. (Grille painting hint:

Use a paint roller that is nearly out of paint to first

paint the inside of the grille, then the outside. This

will avoid paint filling the grille perforations.)

5. Attach the wire to the input terminals on the

rear of the speaker. Remember to maintain prop-

er polarity with the amplifier by attaching the

positive (+) lead to the red terminal and the neg-

ative (-) lead to the black terminal.

6. ee Fig. 5. ith the speaker wire attached toS W

the speaker, slide the speaker up inside the cut-

out hole. Center the speaker in the cut-out hole

and turn the four locking screws clockwise until

the speaker is drawn up snugly to the wall board

from behind, clamping the speaker in place. Try to

tighten each screw equally. Replace the speaker

grille by gently pressing it into place. -If neces

sary, use black grille adhesive to secure the grille.

New Construction

1. Determine speaker locations and mark them

on your plans for future reference.

2. If possible, run speaker wires after HVAC

and electrical wiring is in place.

3. Secure speaker wires in place along the run

with insulated staples only and be careful not to

pierce the wire’s insulation. Allow a bit of slack

for expansion of building materials.

4. Needless to say, the actual speakers should

not be installed until the wall board is in place. In

the meantime, leave several feet of wire coiled up

and secured at the back side of the mounting hole.

5. complete the installation follow steps 2To

through above. 5

Operational Check

After making all connections, it’s a good idea to make sure every thing is working properly.

Turn on your surround or stereo system making sure the volume control is turned down and

that the balance control is in the center position. Activate a musical or movie source such as

FM, a CD or DVD player. Gently turn up the volume, you should hear sound coming from

your new Speco speakers. If no sound is heard from any or all speakers, switch off the sys-

tem immediately and check for open or loose connections, wrong polarity or shorts, or

proper source selection.

FIG. 5

Speco Indoor Speakers Lifetime Limited Warranty

This warranty is valid only on products purchased in the United States of America. This

warranty applies only to the original user/purchaser. Subject to conditions and exclusions found

below, this indoor audio speaker is warranted against manufacturing defects in material and

workmanship for the lifetime of the product, including parts and labor. Speco Technologies will

repair or replace (at our discretion) any parts found to be defective for the warranty period

specified. We will provide a replacement for any defective part.

Conditions

1. You must obtain a Return Authorization (RA) number for any merchandise being turnedre

to Speco Technologies, whether for turn/exchange or pai hether in or out of arrantyre re r, w w .

2. This warranty will be honored only upon the presentation of the original dated bill of sale or

sales slip.

3. Transportation of the product to Speco Technologies for service is the responsibility of the user.

Repaired or replaced product will be returned prepaid during warranty period.

Exclusions

1. This warranty shall not cover improper adjustment of customer operated controls or products

which have been altered or abused.

2. This warranty shall not apply to the appearance of the product or accessory items including,

but not limited to cabinets, cabinet parts, knobs, etc.

3. This warranty does not apply to uncrating, setup, installation, or removal and/or reinstallation

of products prior to or after repair.

4. This warranty shall not apply to repairs or replacements necessitated by any cause beyond the

result of manufacture including, but not limited to, any malfunction, defects or failure caused by

or resulting from unauthorized service or inferior parts, neglect, accident, fire, flood, other acts

of nature or incorrect line voltage.

The foregoing is in lieu of all other expressed warranties and we do not authorize any party to

assume for us any obligation or liability. In no event shall we be liable for incidental or conse-

quential damage arising from the use of this product, or for any delay in the use of this product

due to causes beyond our control.

Some states do not allow limitations of how long an implied warranty lasts and/or do not allow

the exclusion or limitation of consequential damages. The above limitations on implied warranty

and consequential damages may not apply to you.

This warranty gives you specific legal rights. You may have other rights which vary from state

to state.

NO : For warranty purposes and your protection in the eventTE

of theft or loss of this product, please fill in the information

below and .keep with your sales receipt

SPCBC6

5 - 60 tts Wa

90dB

63 Hz-21,000 Hz

˝ (16 mm) 5 mineral-filled

compression-molded polymer cone

woofer with rubber surround

(1 mm) pivoting liquid-cooled 3

titanium anodized dome tweeter 8

ohms nominal

9˝ (22 mm) 9 dia.x 3˝ (7 mm) D 6

˝ (19 mm) 1 dia.

Specifications

Power Handling Efficiency

Fr Reequency sponse Driver

Complement

Impedance

Speaker Dimensions

Ceiling Cutout Dimensions

200 New Highway, Amityville, NY 11701

For information regarding service or return,

Call us TOLL FREE: 1-800-645-5516

In Metro New York 631-957-8700

http://www.specotech.com

Date of Purchase: ____________________________

Where rchased:Pu ____________________________

Purchase Price: ______________________________

Speco Technologies is constantly developing and improving products. Rev. 4/ /202021

Produkt Specifikationer

Mærke:	Speco Technologies
Kategori:	Højttaler
Model:	SPCBC6

Har du brug for hjælp?

Hvis du har brug for hjælp til Speco Technologies SPCBC6 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højttaler Speco Technologies Manualer

Speco Technologies G86KITPR Manual

1 September 2024

Speco Technologies SPC15R Manual

16 August 2024

Speco Technologies SP-5CLCC Manual

16 August 2024

Speco Technologies SPC40RP Manual

15 August 2024

Speco Technologies SP6MAWT Manual

15 August 2024

Speco Technologies DMS-3TSW Manual

15 August 2024

Speco Technologies SPC10T Manual

15 August 2024

Speco Technologies SP6ECS Manual

15 August 2024

Speco Technologies SPRK65CGT Manual

14 August 2024

Speco Technologies SP525C Manual

14 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer

The Box Pro DSX 110 M Manual

1 August 2025

Muse M-968 BTY Manual

1 August 2025

Grundig Portable 360 Manual

1 August 2025

Grundig Band 360 Manual

1 August 2025

Grundig GBT Connect 360 Manual

1 August 2025

Muse M-968 BTR Manual

31 Juli 2025

JLab Epic Party Manual

31 Juli 2025

JVC XS-E423 Manual

30 Juli 2025

SoundTube RF31-EZ-T Manual

30 Juli 2025

Valcom VIP-480AL-W-SA Manual

30 Juli 2025