StarTech.com AP150WN1X1U Manual

StarTech.com Adgangspunkt AP150WN1X1U

Læs gratis den danske manual til StarTech.com AP150WN1X1U (2 sider) i kategorien Adgangspunkt. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om StarTech.com AP150WN1X1U, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Quick Start Guide

Manual Revision: 07/31/2018

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

I T: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

P T: Guia do usuário - pt.startech.com

Packaging Contents

• 1 x Travel Router

• 1 x USB Cable

• 1 x RJ45 Cable

• 1 x Carrying Pouch

• 1 x Instruction Manual

System Requirements

• Available USB port (or wall charger) for power

AP150WN1X1U

Portable 150Mbps Wireless N Travel Router / Access Point - USB Powered

WPS / Reset Button

WPS

WPS mode is disabled by default because it requires a secured wireless network to be

used.

1. Once you have selected an operating mode and are connected to the

web interface (details in the following sections of this manual), congure

your desired wireless security protocol and key.

2. Enable WPS mode.

LED Indicators

WiFi

O: No Wi-Fi signal

Solid: Wi-Fi signal broadcasting

Flashing: Activity

WLAN

O: No RJ45 connection detected

Solid: RJ45 connection detected

Flashing: Activity

POWER

O: No power supplied to the device

Solid: Connected to a USB power source

3. Once enabled, a single press of the button will activate it.

Reset

In order to reset the device to factory defaults:

Note: All previously congured settings will be deleted after performing a reset

1. Ensure the AP is connected to a power source.

2. Press and hold the reset button for 8 seconds, then release.

Installation

Please visit www.startech.com/AP150WN1X1U for full operating instructions and

specications

Default Settings

SSID: AP150WN1X1U

LAN IP Address: 192.168.16.254

Username / Password: admin / admin

Wireless Access Point

In AP mode, the AP150WN1X1U acts as a wireless transmitter which adapts a wired

network signal into WiFi, so that other wireless devices like smartphones and tablets

within range can share the wired connection.

Widely used in: Hotel rooms, school dormitories, etc.

1. Adjust the switch on the device to AP Mode.

2. Connect one end of the included Ethernet cable to the RJ45 port of the AP, and

the other to the hotel wall jack/switch.

3. Connect one end of the included USB cable to the USB port of the AP, and the

other to a USB power source (e.g. laptop, USB wall charger, etc.).

4. Connect your wireless devices to the “AP150WN1X1U” SSID and open your web

browser to access the Internet.

NOTE: If the hotel Internet connection requires a password or has a captive portal

RJ45 Interface WPS/Reset Button Mode Selector Switch USB Interface

Product Overview

Wireless Router

In RT mode, the AP150WN1X1U acts as a wireless router to create a wireless signal

from a cable or DSL modem provided by an Internet Service Provider (ISP). This allows

multiple wireless devices to use a wired connection that normally only allows one

device to connect.

1. Adjust the switch on the device to RT Mode.

2. Connect one end of the included Ethernet cable to the RJ45 port of the AP, and the

other to the cable / DSL Modem.

3. Connect one end of the included USB cable to the USB port of the AP, and the

other to a USB power source (e.g. laptop, USB wall charger, etc.).

4. Connect a wireless device to the “AP150WN1X1U” SSID, which will open your

default web browser to access the conguration page.

Note: If your web browser does not open automatically, open your preferred browser

and enter the default IP address 192.168.16.254 into the address bar.

5. Enter the username / password when prompted, to access the conguration page

(Default: admin / admin).

6. Congure your required WAN and Wireless settings:

a. WAN Setup: Enter in your ISP username / password (typically required for DSL, not

cable) and connection type (contact your ISP for further information if required).

b. Wireless Setup: Congure your desired SSID and Security type / Key, and click Apply

when nished.

Produkt Specifikationer

Mærke:	StarTech.com
Kategori:	Adgangspunkt
Model:	AP150WN1X1U
Vekselstrømsindgangsspænding:	100 - 240 V
Bredde:	28 mm
Dybde:	82 mm
Højde:	13 mm
Vægt:	68 g
Produktfarve:	Sort
Pakkevægt:	112 g
Pakkedybde:	175 mm
Pakkebredde:	140 mm
Pakkehøjde:	30 mm
Opbevaringstemperatur (T-T):	-40 - 70 °C
Relativ luftfugtighed ved drift (H-H):	10 - 90 %
Ethernet LAN-porte (RJ-45):	1
Antal USB 2.0-porte:	1
Driftstemperatur (T-T):	0 - 40 °C
Ethernet LAN-datahastigheder:	10, 100 Mbit/s
Sikkerhedsalgoritmer:	WEP, WPA, WPA2, WPA2-PSK
Husmateriale:	Plast
Hurtig start guide:	Ja
Kabler inkluderet:	LAN (RJ-45), USB
Certificering:	CE, FCC, RoHS
Netværksstandarder:	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3u
Webbaseret administration:	Ja
WPS trykknap:	Ja
LED-indikatorer:	Power, WLAN
Maksimal indendørs rækkevidde:	10 m
Antal brugere:	5 bruger(e)
Frekvensbånd:	2.4 - 2.4835 GHz
Intern:	Ingen
Maksimal dataoverførselshastighed:	150 Mbit/s
Modulation:	16-QAM, 64-QAM, CCK, DBPSK, DQPSK, OFDM
Antenne type:	Intern
USB-stik type:	Mini-USB B
2.4 GHz:	Ja
WAN-forbindelse:	Ethernet (RJ-45), Wi-Fi
Driftsmodus:	Access Point (AP), Repeater, Router