Supermicro 6038R-E1CR16H Manual

Supermicro I 6038R-E1CR16H

Læs gratis den danske manual til Supermicro 6038R-E1CR16H (81 sider) i kategorien I. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Supermicro 6038R-E1CR16H, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/81

SUPER STORAGE SYSTEM

6038R-E1CR16H

USER’S MANUAL

1.0a

iii

Preface

About This Manual

This manual is written for professional system integrators and PC technicians. It

provides information for the installation and use of the SuperStorageSystem 6038R-

E1CR16H. Installation and maintenance should be performed by experienced

technicians only.

Manual Organization

Chapter 1: Introduction

The rst chapter provides a checklist of the main components included with the

server system and describes the main features of the X10DRH-iT serverboard and

the SC836BE1C-R920B chassis.

Chapter 2: Server Installation

This chapter describes the steps necessary to install the SuperStorageSystem

6038R-E1CR16H into a rack and check out the server conguration prior to pow-

ering up the system. If your server was ordered without processor and memory

components, this chapter will refer you to the appropriate sections of the manual

for their installation.

Chapter 3: System Interface

Refer here for details on the system interface, which includes the functions and

information provided by the control panel on the chassis as well as other LEDs

located throughout the system.

Chapter 4: Safety Warnings

You should thoroughly familiarize yourself with this chapter for a general overview

of safety precautions that should be followed when installing and servicing the

SuperStorageSystem 6038R-E1CR16H.

Chapter 5: Advanced Serverboard Setup

Chapter 5 provides detailed information on the X10DRH-iT serverboard, including

the locations and functions of connections, headers and jumpers. Refer to this

The information in this User’s Manual has been carefully reviewed and is believed to be accurate.

The vendor assumes no responsibility for any inaccuracies that may be contained in this document,

makes no commitment to update or to keep current the information in this manual, or to notify any

person or organization of the updates. Please Note: For the most up-to-date version of this

manual, please see our website at www.supermicro.com.

Super Micro Computer, Inc. ("Supermicro") reserves the right to make changes to the product

described in this manual at any time and without notice. This product, including software and docu-

mentation, is the property of Supermicro and/or its licensors, and is supplied only under a license.

Any use or reproduction of this product is not allowed, except as expressly permitted by the terms

of said license.

IN NO EVENT WILL SUPERMICRO BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL,

SPECULATIVE OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OR INABILITY TO

USE THIS PRODUCT OR DOCUMENTATION, EVEN IF ADVISED OF THE POSSIBILITY OF

SUCH DAMAGES. IN PARTICULAR, SUPERMICRO SHALL NOT HAVE LIABILITY FOR ANY

HARDWARE, SOFTWARE, OR DATA STORED OR USED WITH THE PRODUCT, INCLUDING THE

COSTS OF REPAIRING, REPLACING, INTEGRATING, INSTALLING OR RECOVERING SUCH

HARDWARE, SOFTWARE, OR DATA.

Any disputes arising between manufacturer and customer shall be governed by the laws of Santa

Clara County in the State of California, USA. The State of California, County of Santa Clara shall

be the exclusive venue for the resolution of any such disputes. Super Micro's total liability for all

claims will not exceed the price paid for the hardware product.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class A

digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial environ-

ment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the manufacturer’s instruction manual, may cause harmful interference

with radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference, in which case you will be required to correct the interference at your own expense.

California Best Management Practices Regulations for Perchlorate Materials: This Perchlorate warn-

ing applies only to products containing CR (Manganese Dioxide) Lithium coin cells. “Perchlorate

Material-special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate”

WARNING: Handling of lead solder materials used in this

product may expose you to lead, a chemical known to the

State of California to cause birth defects and other repro-

ductive harm.

Manual Revision 1.0a

Release Date: May 13, 2016

Unless you request and receive written permission from Super Micro Computer, Inc., you may not

copy any part of this document.

Information in this document is subject to change without notice. Other products and companies

referred to herein are trademarks or registered trademarks of their respective companies or mark

holders.

Printed in the United States of America

Produkt Specifikationer

Mærke:	Supermicro
Kategori:	I
Model:	6038R-E1CR16H
Tænd-/slukkontakt:	Ja
Vekselstrømsindgangsspænding:	100 - 240 V
Vekselstrømsindgangsfrekvens:	50 - 60 Hz
Bredde:	437 mm
Dybde:	648 mm
Højde:	132 mm
Vægt:	21800 g
Produktfarve:	Sort
Opbevaringstemperatur (T-T):	-40 - 70 °C
Relativ luftfugtighed ved drift (H-H):	8 - 90 %
Relativ luftfugtighed ved opbevaring (H-H):	5 - 95 %
Ethernet LAN-porte (RJ-45):	2
Antal USB 2.0-porte:	2
Antal USB 3.2 Gen 1 (3.1 Gen 1) type-A-porte:	2
Ethernet LAN:	Ja
Driftstemperatur (T-T):	10 - 35 °C
Ethernet LAN-datahastigheder:	10,100,1000 Mbit/s
Certificering:	80 PLUS Platinum
LED-indikatorer:	HDD, Network, Power, Power fail
Bæredygtighedscertifikater:	RoHS
Processorserie:	Intel
Maksimal intern hukommelse:	2000 GB
Hukommelse form faktor:	288-pin DIMM
On-board grafikkort, model:	Aspeed AST2400
Indgangsstrøm:	11 - 4.5 A
Antal VGA-porte (D-sub):	1
Ethernet-grænsefladetype:	Fast Ethernet, Gigabit Ethernet
Kobber ethernet kabelteknologi:	10GBASE-T, 100BASE-TX, 1000BASE-T
Antal blæsere:	2 blæser(e)
Antal understøttede lagerdiske:	16
Antal serielle porte:	1
Kabinettype:	Stativ (3U)
Ventilator diameter:	80 mm
Strømforsyning:	920 W
Processor sokkel:	LGA 2011 (Socket R)
PCI Express slots version:	3.0
Systembus-hastighed:	9.6 GT/s
Fejlkorrigerende kode:	Ja
PCI Ekspres x8 slots:	6
PCI Express x16 slots:	1
Redundant strømforsyning:	Ja
Hukommelsesbus:	72 Bit
Kompatibel processor serie:	Intel® Xeon®
Bundkort chipsæt:	Intel® C612
Understøttede hukommelsestyper:	DDR4-SDRAM
LAN Kontroller:	Intel X540, Realtek RTL8201N
Understøttede lagerdrev brugerflader:	Serial Attached SCSI (SAS)-3, Serial ATA III
BIOS-type:	AMI
BIOS-hukommelsesstørrelse:	16 Mbit
ACPI-version:	2.0
RAID-niveauer:	0, 1,5, 10
Antal understøttede processorer:	2
Hukommelsesspænding:	1.2 V
Understøttede lagerdisk størrelser:	2.5, 3.5 "
Hot-swap HDD båse:	Ja
Antal DIMM-slots:	16
Understøttelse af backplane:	Ja
Understøttet RDIMM-clockhastigheder:	2400,1600,1866,2133 MHz
IPMI LAN (RJ-45) port:	Ja
Understøttet DIMM modul kapaciteter:	4GB, 8GB, 16GB, 32GB, 64GB
DC udgående strøm (+12 V):	75 A
Maksimal RDIMM hukommelse:	512 GB
Intel® Xeon serie:	E5-2600
Understøttelse af Intelligent Platform Management Interface (IPMI):	Ja
Understøttelse af redundante blæsere:	Ja
Opbevaringscontroller:	LSI SAS3108
Mulighed for at installere sammen med rack:	Ja
Maksimum cache:	55 MB
BIOS funktioner:	APM 1.2, PCI 2.2, Plug & Play, SMBIOS 2.3, UEFI
System bustype:	QuickPath Interconnect (QPI)