Supermicro SuperServer F619P3-FT Manual

Supermicro Server SuperServer F619P3-FT

Læs gratis den danske manual til Supermicro SuperServer F619P3-FT (11 sider) i kategorien Server. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Supermicro SuperServer F619P3-FT, eller vil du spørge andre brugere om produktet?

Side 1/11
Appendix D: Information for Lot 9 of ErP ( Ecod ) esign
This appendix designaddresses European Union E -(EU) co requirements for servers and storage
products only . All data and ratings within this appendix are in reference to the product(s) in this manual.
The below information corresponds to in Annex II of requirements laid down the commission regulation
2019/424.
3(1)(a): See section 1.1 of this manual for the product type.
3(1)(b): See title page and preface of this manual for trademark and manufacturer’s address.
3(1)(c): . See title page for product model number(s)
3(1)(d): See year . serial number on the physical system to determine the of manufacture
3(1)(e)*: PSU efficiency (Table) and power factor value (from 80 Plus report)
PSU Model #: PWS- - 2K20A 1R
Watts: 2200W
PSU efficiency
power factor
% of rated load
% % % % % 10 20 50 100 50
Single - )output (AC DC
. % 95. % 96. % 94. % 93 49 26 26 38 0.99
System (EUT) efficiency in idle state power
Representative Configurations
Measured Idle State Power (W)
Calculated Idle Power Allowance
(W)
High-end performance
configuration
569.1
1 013.9
Typical Configuration
N/A
N/A
Low-end performance
configuration
554.8
655.5
System (EUT) efficiency in active state power
Representative Configurations
Active state efficiency score
(Effserver)
Minimum active state
efficiency for 2 socket server
High-end performance
configuration
25.2
Typical Configuration
N/A
8
Low-end performance
configuration
17.4
3(1)(f)* :
3(1)(g)*:
3(1)(h)*:
3(1)(i)*: The following components, if included with the product in this manual, contain
additional idle power allowances: HDDs or SSDs, additional memory, and/or AOCs.
3(1)(j)* :
3(1)(k)*: is A2 The operating condition class
Dry bulb °Ctemp
Humidity range, non condensing-
Operating
condition
class
Allowable
range
Recom
mended
range
Allowable range
Recommended range
Max dew
point (°C)
Maximum
rate of
change
C/hr)
A1
15- 32
18 27-
12 and °C Dew P oint (DP)
8 % (RH) relative humidity to
17 80 ° C DP and % RH
9 °C DP to
15 °C DP and
60 % RH
17
5/20
A2
10 35-
18 27-
12 and to °C DP 8 % RH
21 °C DP % RHand 80
Same A1as
21
5/20
A3
5-40
18 27-
12 and to °C DP 8 % RH
24 °C DP % RHand 85
Same A1as
24
5/20
A4
5-45
18 27-
12 and to °C DP 8 % RH
24 °C DP % RHand 90
Same A1as
24
5/20
3(1)(l)*: The idle state power at the higher boundary temperature of the operating conditions
class is 569.1W
3(1)(m)*: The active state efficiency and performance: 25.2
3(1)(n): Secure data deletion description here. Chris/Michelle (SW) provide link----
3(1)(o): List of recommended combinations of blade servers with chassis. N/A
3(1)( F619P3p) List of all current SKUs within this product family.---- SYS- -FT
3(3)(a): There is no use of cobalt in batteries in this product.


Produkt Specifikationer

Mærke: Supermicro
Kategori: Server
Model: SuperServer F619P3-FT

Har du brug for hjælp?

Hvis du har brug for hjælp til Supermicro SuperServer F619P3-FT stil et spørgsmål nedenfor, og andre brugere vil svare dig