Supermicro SuperServer SYS-510T-MR Manual

Supermicro Server SuperServer SYS-510T-MR

Læs gratis den danske manual til Supermicro SuperServer SYS-510T-MR (11 sider) i kategorien Server. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om Supermicro SuperServer SYS-510T-MR, eller vil du spørge andre brugere om produktet?

Side 1/11
Information for Lot 9 of ErP (Ecodesign)
This addendum addresses European Union (EU) Ecodesign requirements for servers and storage
products. All data and ratings within this addendum are in reference only to the Supermicro product(s) in
the manual. The below information conforms requirements laid down in Annex II of the Commission to
Regulation 2019/424.
3(1)(a): See Section 1.1 of the system manual for the product type.
3(1)(b): See the title page and preface of the system manual for the trademark and
manufacturer’s address.
3(1)(c): See the title page of the system manual for product model number(s).
3(1)(d): See the serial number on the physical system to determine the year of manufacture.
3(1)(e-j): PSU Efficiency and Power Factor Value (Table) (From 80 Plus report)
PSU Model #: PWS-407P- 1R
Watts: 0W 40
PSU Efficiency
Power Fact or
% of Rated Load
10 %
20 %
50 %
100 %
50 %
Single Output (AC-DC)
85.64 %
92.05 %
94.43 %
93.17 %
0.98
System (EUT) Efficiency in Power (Table) Idle State
Representative
Configurations
Measured Idle State
Power (W)
High-End Performance
Configuration
69.50
Typical Configuration
N/A
Low-End Performance
Configuration
51.20
System (EUT) Efficiency in Power (Table) Active State
Representative
Configurations
Active State
Efficiency Score
(Effserver)
Minimum Active State
Efficiency
High-End Performance
Configuration
17.7
Typical Configuration
N/A
9
Low-End Performance
Configuration
14.1
3(1)(k): The operating condition class is . A2
Dry bulb temp C°
Humidity range, non-condensing
Operating
condition
class
Allowable
range
Recom
mended
range
Allowable range
Recommended
range
Max
dew
point
(°C)
Maximum
rate of
change
(°
C/hr)
A1
15- 32
18-27
12 C Dew Point °
(DP) and
8 %
relative humidity
(RH) to
17 C DP and °80 %
RH
9 C °DP to
15 C °DP
and
60 %
RH
17
5/20
A2
10-35
18-27
12 C and 8 °DP
% RH to
21 C °DP
and % 80 RH
Same as A1
21
5/20
A3
5-40
18-27
12 C and 8 °DP
% RH to
24 C °DP
and % 85 RH
Same as A1
24
5/20
A4
5-45
18-27
12 C and 8 °DP
% RH to
24 C °DP
and % 90 RH
Same as A1
24
5/20
3(1)(l): The idle state power at the higher boundary temperature of the operating conditions
class is 82.01 W.
3(1)(m): The active state efficiency and performance is a minimum of 14.1.
3(1)(n): There are two methods by which a user can securely delete data from this system. The
user performing secure data deletion should be an IT professional.
The first is with a Unified Extensible Firmware Interface (UEFI) shell utility. This utility
works on X12/X11/H11/H12/M11 motherboard series with onboard SATA/NVMe devices.
Any user may access and download this utility through following link:
https://www.supermicro.com/about/policies/disclaimer.cfm?url=/wftp/utility/Lot9_Secure
_Data_Deletion_Utility/
Download the shell utility package and extract it to a USB flash drive, then plug the drive
into the server for which secure data deletion is necessary. Then turn the system on.
Navigate to the BIOS setup menu, and then place the server system into the UEFI shell


Produkt Specifikationer

Mærke: Supermicro
Kategori: Server
Model: SuperServer SYS-510T-MR

Har du brug for hjælp?

Hvis du har brug for hjælp til Supermicro SuperServer SYS-510T-MR stil et spørgsmål nedenfor, og andre brugere vil svare dig