Please read these instructions for use and have a good look at the illustration before
using the appliance.
This appliance is not intended for use by persons(including children)with reduced
physical,sensory or mental capabilities,or lack of experience and knowledge,unless they have
been given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The heater must not be located immediately below a socket-outlet.
Do not use this heater in the immediate surroundings of a bath,a shower or a swimming pool!
GENERAL SAFETY
●DO NOT COVER, RESTRICT AIR INLET OR USE TO DRY CLOTHES
●THE SURFACE OF THIS FAN HEATER IS HOT. CLOSELY SUPERVISE ANY CHILDREN
AND PETS WHEN IN USE.
●DO NOT USE FAN HEATER NEAR FLAMMABLE OR HEAT SENSITIVE ITEMS.
●USE IN UPRIGHT POSITION ONLY AND DO NOT LEAVE UNATTENDED.
ELECTRICAL SAFETY
●FOR INDOOR USE ONLY.
●SWITCH OFF AND UNPLUG WHEN NOT IN USE.
●DO NOT PULL THE HEATER ALONG BY THE CORD OR USE IF DAMAGED.
●DO NOT USE HEATER IN HUMID OR WET ENVIRONMENTS.
●IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED BY AN ELECTRICAN
OR SIMILARLY QUALIFIED PERSON, TO AVOID HAZARD.
TO USE
1. Turn the heater to the “OFF” position before plugging in.
2. The operating temperature is selected by a combination of the power switch and
thermostat. The hottest setting will be when the heater is at the “High” setting and
thermostat is turned to “Maximum”.
3. To determine the correct working temperature for your conditions, turn the heater to “High”
and the thermostat to “Maximum”. The power light will be activated and the heater will start.
When a comfortable temperature has been reached turn the thermostat slowly
anticlockwise until the heater turns o. The temperature will now be kept constant.
4. If you want to lower the operating temperature select the “Low” heater setting and repeat
the above process.
5. For air circulation only (no heat) select “Fan only”.
6. The heater is tted with an automatic cut out in the event that it overheats. If this activates,
turn the heater to the o position and un plug. Allow the heater to cool and remove
anything restricting the airow before using the heater again. If the automatic cut out
operates repeatedly contact a qualied electrician for advice.
