Techly IC-HEAT004 Manual

Techly Varmeapparat IC-HEAT004

Læs gratis den danske manual til Techly IC-HEAT004 (20 sider) i kategorien Varmeapparat. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Techly IC-HEAT004, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/20
P/N: IC-HEAT004
8059018369977
SCAN
for MORE
PRODUCT INFO
2000W
GLASS PANEL HEATER
Technical features
2000
WATT
ADJUSTABLE
LED
DISPLAY
EN
This product is only suitable for well insulated
spaces or occasional use.
IT
Questo prodotto è adatto solo per spazi
ben isolati o per un uso occasionale.
WWW.TECHLY.COM
EN
User's Manual
IT
Manuale d’istruzione
TECHNICAL DATA
GENERAL SAFETY INSTRUCTIONS
1. Before using the machine, carefully read this entire instruction manual. Keep the instruction leaet
somewhere safe so that you can consult it in future.
2. Before using your new heater, check it, including cord and plug, for any visible damage. Do not use a
damaged heater, but send it back to your dealer for replacement.
3. Do not use the heater until it is been fully installed in accordance with the instructions under the heading
‘Installation’.
4. This heater is strictly intended for normal domestic use. Only use it for the additional heating of your
home.
5. This heater is, in principle, suitable for use in wet or damp spaces such as bathrooms, wash rooms etc.
(IP24). Keep it at least 1.5 m from water sources and water reservoirs (bath, sink, toilet) and ensure that
it can never fall into water and that no water penetrates the heater itself. If the heater does get wet make
sure you remove the plug from the socket! Do not use a heater that is wet inside but take it to be repaired.
Never immerse the cable or plug in water or any other uid and never touch the heater with wet hands.
6. The supply voltage and utility frequency, specied on the machine, need to match those of the socket
that is used. The socket used needs to be earthed and the electrical installation needs to be secured with
a ground-fault circuit interrupter (max. 30 mAh).
7. Fully extend the cord before plugging in the heater. Make sure it does not come into contact with any part
of the heater and prevent it from heating up any other way. Do not run the cord underneath carpeting; do
not cover it with mats, carpet strips or similar and make sure it is not placed in any passageways. Make
sure the cord cannot be stepped on and that no furniture is placed on top of it. Do not lead the cord
around sharp corners and do not roll it up too tightly after use!
8. If possible, do not use an extension cord, as this poses the risk of overheating and re. If the use of
an extension cord is unavoidable, then make sure it is an undamaged, approved extension cord with a
minimum diameter of 3 x 2,5 mm² and a minimum permissible power of 2000W. To prevent overheating,
always fully extend the cord!
9. To prevent the circuit being overloaded and fuses blowing, make sure no other appliances are connected
to the same socket or wired to the same electrical circuit as the heater.
10. Do not use the heater outdoors and do not use it in spaces, smaller than 20 m².
11. Always turn off the device and remove the plug from the power socket: Never turn off the heater using
the plug!
12. A heater contains hot and/or glowing and sparking components. Do not, therefore, use it in areas where
fuels, paint, ammable liquids and/or gasses etc. are stored.
13. Do not place the heater near, under, or directly opposite a socket and do not place it near an open re or
other heat source.
14. Do not use the heater near or directly opposite furniture, animals, curtains, paper, clothes, bedding or
other inammable objects. Keep them at least 1 metre away from the heater!
15. Never cover a heater! The heater’s ventin openings should never be obstructed in any way, so as to
prevent the possibility of re. Never use the heater to dry clothes and do not place anything on top of the
heater.
16. Make sure that the air around the heater can circulate freely. Do not place the heater too close to walls
or large objects and do not place it under shelves, cupboards or similar. For minimum free space around
the heater, see ‘Installation’.
17. Prevent foreign objects from entering the heater via the venting or exhaust openings as this may lead to
electric shock, re or damage.
2000W GLASS PANEL HEATER
EN - 2
WWW.TECHLY.COM
Type
IC-HEAT004
Supply Voltage 230V, 50-60Hz
Power 2000W
Protection against electric shock Class I
Open-window detection YES
IP Class IP24

Produkt Specifikationer

Mærke: Techly
Kategori: Varmeapparat
Model: IC-HEAT004

Har du brug for hjælp?

Hvis du har brug for hjælp til Techly IC-HEAT004 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Varmeapparat Techly Manualer

Techly

Techly IC-HEAT001 Manual

8 Juli 2025
Techly

Techly IC-HEAT002 Manual

8 Juli 2025
Techly

Techly IC-HEAT003 Manual

26 Marts 2025
Techly

Techly IC-HEAT004 Manual

26 Marts 2025

Varmeapparat Manualer

Nyeste Varmeapparat Manualer

Bestron

Bestron AOR9 Manual

12 Oktober 2025
Bestron

Bestron ABOX12Z Manual

12 Oktober 2025
Bestron

Bestron ASV45W Manual

12 Oktober 2025
Bestron

Bestron DDF27Z Manual

12 Oktober 2025
Gerlach

Gerlach GL7729 Manual

12 Oktober 2025
Gerlach

Gerlach GL7733 Manual

12 Oktober 2025
Bestron

Bestron AFT760W Manual

11 Oktober 2025
Euromac

Euromac EK2001 Manual

9 Oktober 2025
Euromac

Euromac Ultrafan Manual

9 Oktober 2025
Euromac

Euromac Golden 2500 Manual

9 Oktober 2025