Tiptop Audio Fold Processor Manual


Læs gratis den danske manual til Tiptop Audio Fold Processor (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om Tiptop Audio Fold Processor, eller vil du spørge andre brugere om produktet?

Side 1/3
www.tiptopaudio.com
Fold Processor
The Fold processor is a 100% analog module built from two sections: rst is a diode ‘folding circuit
inspired by the middle section of the Serge wave multiplier module and its output is available at
the OUT jack. The second section feeds from the OUT into a square & divide circuit which is origi-
nal to this module, is output at the SUBDIV OUT. The module is very easy to use, the resulting
sounds are heavily dependent on the type of the incoming signal.
To get started patch as the drawing above, set your Z2040 resonance to max, set the frequency
knob half way, this will cause the Z2040 to self oscillate a natural sine wave (if you don’t have a
Z2040 use the sine output from your Z3000). Plug the Z2040 out into the IN1 on the Fold Proces-
sor (we’ll call it just Fold from now on). Connect the Fold OUT jack to your speaker system and
sweep the FOLD knob, if you don’t hear a sound change the INJECT knob as it might be in the
dead’ zone.
You should now hear how the FOLD knob folds the signal and how the Inject input further osets
the signal adding more variations. Both of these knobs can be voltage controlled by CV with the
amount of modulation set by the ATTEN knobs.
Audio System


Produkt Specifikationer

Mærke: Tiptop Audio
Kategori: Ikke kategoriseret
Model: Fold Processor

Har du brug for hjælp?

Hvis du har brug for hjælp til Tiptop Audio Fold Processor stil et spørgsmål nedenfor, og andre brugere vil svare dig