Ultimaker 2+ Connect Manual

Ultimaker Printer 2+ Connect

Læs gratis den danske manual til Ultimaker 2+ Connect (39 sider) i kategorien Printer. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Ultimaker 2+ Connect, eller vil du spørge andre brugere om produktet?

Side 1/39
Ultimaker 2+ Connect
Installation and user manual
EN 10/2020 v1.0 Original instructions
Ultimaker 2+ Connect user manual 1
Table of contents
1. Safety and compliance
1.1 Safety messages 4
1.2 General safety information 4
1.3 Hazards 5
1.4 Regulatory information 6
2. Introduction
2.1 Main components 9
2.2 Specications 11
3. Installation
3.1 Unboxing 13
3.2 What's in the box? 14
3.3 Hardware installation 15
3.4 First setup 16
3.5 Firmware update 17
3.6 Install Ultimaker Cura 18
4. Operation
4.1 Touchscreen 20
4.2 Materials 21
4.3 Preparing a print with Ultimaker Cura 22
4.4 Printing with the Air Manager 24
4.5 Remove the print 25
4.6 Change the printer conguration 26
5. Maintenance
5.1 Update the rmware 28
5.2 Material handling and storage 28
5.3 Maintenance schedule 29
5.4 Replace the Air Manager lter 30
6. Troubleshooting
6.1 Error messages 32
6.2 Extrusion problems 32
6.3 Adhesion issues 33
6.4 Air Manager troubleshooting 34
7. Warranty
7.1 General 36
7.2 Conditions 36
7.3 Notication 37
7.4 Exclusions 37
7.5 Applicable law and competent court 37


Produkt Specifikationer

Mærke: Ultimaker
Kategori: Printer
Model: 2+ Connect

Har du brug for hjælp?

Hvis du har brug for hjælp til Ultimaker 2+ Connect stil et spørgsmål nedenfor, og andre brugere vil svare dig