Bolt Nut (D)
Canopy
Rubber Pad (E)
Socket
Holder
Shade
Socket Ring
Max. 60W Type A Bulb
(not included)
Cord
WARNING:
TO A L SHOCK, BE SURE TO SHUT OFF
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
T0349 T0493
a
c (3")
d (3/8")
b (9")
Fig.1
Turn off the power at fuse or circuit box.
Installation Steps
Hardware Package (included):
Bolt Nut (D)
Mounting Strap Unit (A)
Mounting Screw (B)
Wire Connector (C)
Rubber Pad (E)
Strain Relief (F)
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read
and save these instructions.
Outlet Box
House Ground Wire
Wire Connector (C)
Mounting Strap Unit (A)
Fixture Mounting Screw
Green Ground Screw
Mounting Screw (B)
Strain Relief (F)
1. Measure the desired length of the cord (a) from the canopy
to the shade and leave additional 9" cord (b) above the
canopy (include the canopy). Then cut off the unnecessary
cord. (See Fig.1)
2. Adjust strain relief (F) at 9" position from the top of the cord.
3. Mark the 3" cord (c) from the top of the cord (b).
Use a knife to peel off the insulation of the cord (c)
carefully to show the 3 inside wires.(See Fig.1)
Caution : Cutting too deep may cut off three
inside wires and destroy the insulation surface
of the three inside wires.
4. Peel off the 3 wires from the top about 3/8" long (d)
to expose the copper for wiring.
5.
Attach the mounting strap unit
(A)
to outlet box by
using two mounting screws (B).
6. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
• Attach the fixture ground wire (green insulation) to the house ground wire with a wire connector (C).
Carefully put all of the wires back into the outlet box.
7. Attach the canopy to the mounting strap unit (A) by inserting the two fixture mounting screws into the open
holes on the canopy, and secure it with two rubber pads (E) and two bolt nuts (D).
Note: Adjust the strain relief can decrease or increase the length of cord exposing outside.
Page 1 / 2
230804
