Velleman DCM330 Manual

Velleman Multimeter DCM330

Læs gratis den danske manual til Velleman DCM330 (29 sider) i kategorien Multimeter. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Velleman DCM330, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/29

DCM330

DIGITAL CLAMP MULTIMETER

DIGITALE STROOMTANG

PINCE AMPÈREMÉTRIQUE NUMÉRIQUE

PINZA AMPERIMÉTRICA DIGITAL

DIGITALE STROMZANGE

MULTIMETRO DIGITALE CON PINZA AMPEROMETRICA

USER MANUAL

GEBRUIKERSHANDLEIDING

NOTICE D’EMPLOI

MANUAL DEL USUARIO

BEDIENUNGSANLEITUNG

MANUALE UTENTE

DCM330_v2 VELLEMAN

DCM330 – DIGITAL CLAMP MULTIMETER

1. Introduction

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that disposal of the

device after its lifecycle could harm the environment. Do not dispose of the

unit (or batteries) as unsorted municipal waste; it should be taken to a

specialized company for recycling. This device should be returned to your

distributor or to a local recycling service. Respect the local environmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for choosing Velleman! Please read the manual thoroughly before bringing this

device into service. If the device was damaged in transit, do not install or use it and contact

your dealer.

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by

the warranty and the dealer will not accept responsibility for any ensuing defects or

problems.

• Switch off the meter when not in use.

• Do not exceed the maximum allowable input range of any function.

• Do not apply voltage to the meter when the resistance function is enabled.

• Set the function switch to the appropriate position before measuring.

• Do not switch to current/resistance modes when measuring a voltage.

• Do not measure current on a circuit whose voltage exceeds 240V.

• Always disconnect the test leads from the circuit under test when changing ranges

with the selector switch.

• Note that damage caused by user modifications to the device is not covered by the

warranty.

• Keep the device away from children and unauthorised users.

3. General Guidelines

• Improper use of this meter can cause damage, shock or injury. Read and understand

this manual before operating this meter.

• Always remove the test leads before replacing the battery.

• Inspect the condition of the test leads and the meter for any damage before operating.

Repair any damage or replace before use.

• Use great care when making measurements of voltages higher than 25VAC RMS or

35VDC. These voltages are considered hazardous.

• Remove the battery if the meter is to be stored for long periods.

• Always discharge capacitors and remove power from the device under test before

performing diode, resistance or continuity tests.

• Voltage checks on electrical outlets can be difficult and misleading because of the

uncertainty of connection to the recessed electrical outlets. Other means should be

used to ensure that the terminals are not live.

Refer to the manual for further information.

Double insulation.

Hazardous voltages may be present under normal use.

Produkt Specifikationer

Mærke:	Velleman
Kategori:	Multimeter
Model:	DCM330
Vægt:	210 g
Dimensioner (BxDxH):	205 x 70 x 37 mm
Baggrundslys:	Ja
DC spændingsområde:	0.2 - 600 V
AC-spæningsområde:	0.2 - 600 V
AC strømområde:	0.001 - 400 A
Modstandsområde:	200 - 20000000 ohm (Ω)
Basis nøjagtighed (AC strøm):	±(2.5%+6d), ±(2.5%+4d), ±(3.0%+4d)
Basis nøjagtighed (AC spænding):	±(1.5%+3), ±(1.5%+30d)
Basis nøjagtighed (modstand):	±(2.0%+4d), ±(1.5%+2d), ±(2.0%+3d), ±(3.0%+5d)
Basis nøjagtighed (DC spænding):	±(1.2%+3d), ±(0.5%+5d)
Kontinuitetscheck:	Ja
Data hold:	Ja