Vivotek AW-IHT-0601 Manual

Vivotek Ikke kategoriseret AW-IHT-0601

Læs gratis den danske manual til Vivotek AW-IHT-0601 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Vivotek AW-IHT-0601, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

1. Install the switch in a ventilated and dry place that is free of electromagnetic source, vibration, moisture, and dust.

2. Make sure the ventilation openings on the switch are not blocked.

3. Use ber optic cables and transceiver compliant with the following: Multi-mode: 50/125um, 62.5/125um, 850nm;

Single-mode): 9/125um ,1310nm.

4. DC input: (AW-IHT-0600 - 44V~56VDC; AW-IHT-0601 - 12~56VDC). Follow the printed polarity for V+, V-, and Ground.

AW-IHT-0600 Industrial PoE Switch

AW-IHT-0601

Quick Installation Guide

The AW-IHT-0600 series is a rugged media PoE switch designed for delivering a max. of 30 watts to powered devices.

The optional TX or FX uplink port can be used to extend the connection to a remote site. With its multi-purpose design, it

is t for IP surveillance, trafc monitoring, and security applications in critical environments. The machine features a total

budget of 126 watts and a wide range of operating temperatures ranging from -40°C to 75°C.

IMPORTANT:

INTRODUCTION

CONNECTION

* 1x PoE switch * 1x Quick Installation Guide * 1x 6-pin terminal block

* 2x wall mount brackets * 1x DIN rail bracket

PACKAGE CONTENTS

1. Pull out the 6-pin terminal block.

2. Connect positive wires to V+, negative wires to V-, and

neutral wire to the ground screw.

Connect the 24V DC @1A pins to external devices.

When 2 power pins are connected, the relay is shorted.

When any of them is diconnected, the relay connection

is open.

3. Connect SFP transceivers and ber cables to the ber

ports.

4. Install the 6-pin terminal block.

1 2

F5 1000M

T5 100M

DIP 1 F5 Enable the F5 ber port (default)

T5 Enable the T5 Ethernet port

DIP 2 1000M The F5/T5/F6 port in the Gigabit mode (default)

100M The F5/F6 ber port in the 100Mbit mode. If T5 (Ethernet) is put to use, the

T5 port can not operate in the 100Mb mode.

WARNING - Always ground the power source to maintain a clean power input.

- OR -

LAN/WAN

PW1 ON When power is connected.

PW2 ON When power is connected.

ERR (relay) OFF When both PW1 and PW2 are

connected.

ON Only PW1 or PW2 is connected.

F5 ON Port 5 ber is detected.

OFF Port 5 ber is not detected.

Flashing Data is being transmitted or received.

F6 ON Port 6 ber is detected.

OFF Port 6 ber is not detected.

Flashing Data is being transmitted or received.

Link ON TX link is detected.

OFF Link is not detected.

Flashing Port is active.

SPD ON 1000M speed is detected.

OFF 10/100M speed is detected.

P1,P2,P3,

ON PD is detected on the designated port.

OFF No PD is detected.

LED DEFINITIONS

IMPORTANT - You can either use the F5 ber or the T5 Ethernet port. These ports can not be

used at the same time. Use the DIP switch to make the selection.

Note that the conguration change only takes effect after a power cycle.

Produkt Specifikationer

Mærke:	Vivotek
Kategori:	Ikke kategoriseret
Model:	AW-IHT-0601
Kode for international beskyttelse (IP):	IP30
Bredde:	105 mm
Dybde:	142 mm
Højde:	43 mm
Vægt:	680 g
Produktfarve:	Sort
Opbevaringstemperatur (T-T):	-40 - 85 °C
Relativ luftfugtighed ved drift (H-H):	5 - 95 %
Relativ luftfugtighed ved opbevaring (H-H):	5 - 95 %
Strømforbrug (typisk):	126 W
Driftstemperatur (T-T):	-40 - 75 °C
Husmateriale:	Metal
Certificering:	CE, C-Tick, FCC, VCCI, LVD
Netværksstandarder:	IEEE 802.3,IEEE 802.3ab,IEEE 802.3af,IEEE 802.3at,IEEE 802.3u,IEEE 802.3x,IEEE 802.3z
LED-indikatorer:	Error,LAN,PoE,Power
Kan monteres på væggen:	Ja
DC indgangsspænding:	48 - 56 V
Strøm over Ethernet (PoE):	Ja
Total Power over Ethernet (PoE):	120 W
Power over Ethernet (PoE) effekt pr. port:	30 W
Auto MDI/MDI-X:	Ja
Kobber ethernet kabelteknologi:	10BASE-T,100BASE-TX,1000BASE-T
Basis omskiftning RJ-45 Ethernet porte, antal:	4
Basis omskiftning RJ-45 Ethernet porttype:	Gigabit Ethernet (10/100/1000)
Kombo SFP porte, antal:	1
Opbevar-og-frem:	Ja
MAC adresselabel:	1000 entries
Switch kapacitet:	12 Gbit/sek.
Jumbo Frames support:	Ja
Jumbo rammer:	9000
Strømbeskyttelsesfunktioner:	Over current,Short circuit
Bufferstørrelse:	128 KB
Power over Ethernet (PoE) porte, antal:	4
DIN-skinne montering:	Ja
Monteringssæt til væggen:	Ja
Power over Ethernet (PoE) spændingsområde:	24 - 56 V
DIN skinne inkluderet:	Ja
Understøttede kabeltyper:	Cat3,Cat4,Cat5,Cat5e,Cat6,Cat7
Pakke videresendelsesrate (1 Gbps):	1488000 pps
Pakke videresendelsesrate (100 Mbps):	148000 pps
Pakke videresendelsesrate (10 Mbps):	14880 pps
Antal installerede SFP moduler:	1