Wayne CDU980E Manual

Wayne Pomp CDU980E

Læs gratis den danske manual til Wayne CDU980E (24 sider) i kategorien Pomp. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Wayne CDU980E, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/24
SAFETY GUIDELINES
This manual contains information that is very important
to know and understand. This information is provided
for SAFETY and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information, observe all safety
information labeled danger, warning, caution, and notice.
DESCRIPTIONS
SUMP PUMPS
Sump pumps are automatic pumps used to remove ground
water from sump pits. The most common application is for
basement drainage to prevent fl ooding in residential buildings.
These sumps are designed to pump clear water only.
EFFLUENT PUMPS
Effl uent pumps are pumps used to remove grey water from
septic tanks, sump pits or laundry tray systems. Grey water
is waste water from bathtubs, sinks, washing machines, and
other kitchen appliances. The pumps are designed to pass
solids 1/2 to 3/4 inches in diameter.
SEWAGE PUMPS
Sewage pumps are pumps used to remove waste water
that contains solids up to 2 inches in diameter. The most
common application is for draining bathroom waste water to
a sewer or septic line.
UNPACKING
Inspect your pump. Occasionally, products are damaged during
shipment. If the unit is damaged, contact our Customer Service
department at the number listed on the parts and warranty sheet.
READ & FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS — DO NOT DISCARD
200001-015 6/11© 2011
Sump, Effl uent and Sewage pumps
INSTALLATION MANUAL
IMPORTANT SAFETY INFORMATION
WARNING INDICATES A POTENTIALLY HAZARDOUS
SITUATION WHICH, IF NOT AVOIDED, COULD RESULT
IN DEATH OR SERIOUS INJURY.
RISK OF ELECTRIC SHOCK. TO REDUCE THIS
RISK, OBSERVE THE FOLLOWING WARNINGS:
MAKE SURE THERE IS A PROPERLY GROUNDED
RECEPTACLE AVAILABLE. This pump is supplied with a
grounding conductor and grounding-type attachment plug. To
reduce the risk of electric shock, be certain that it is connected
only to a properly grounded, grounding-type receptacle.
NEVER REMOVE THE GROUND PRONG from the plug or
bypass the grounding wires.
FOR ADDED SAFETY the receptacle should be protected with a
ground fault circuit interrupter (GFCI). All wiring must be performed
by a qualifi ed licensed electrician and comply with the National
Electric Code and all applicable local codes and ordinances.
DO NOT REMOVE POWER SUPPLY CORD and strain relief or
connect conduit directly to the pump.
MAKE SURE THE POWER SUPPLY HAS A FUSE OR
CIRCUIT BREAKER rated to handle the current (amps) noted
on the pump nameplate or cordtag.
DO NOT USE AN EXTENSION CORD. Extension cords could
present a safety hazard if not sized properly, become damaged
or the connection falls into the sump. If receptacle is not within
reach of the pump’s power cord, contact a qualifi ed licensed
electrician to install a new receptacle.
ALWAYS DISCONNECT THE PUMP from power supply before
installing, servicing or making any adjustments.
DO NOT SUBMERGE PEDESTAL MOTOR or allow motor to
be exposed to water.
DO NOT WALK on the fl oor when water is present until all
power is turned off. If the electric panel is in the basement, call
an electrician.
NEVER HANDLE A PUMP or motor with wet hands or when
standing on a wet or damp fl oor while the pump is plugged into
the power supply.
WASH HANDS AFTER HANDLING. According to the state of
California (Prop 65), this product may contain chemicals known to
the state of California to cause cancer and birth defects or other
reproductive harm.
RISK OF ELECTRIC SHOCK. This pump has not been
investigated for use in swimming pool and marine areas.
DO NOT USE TO PUMP FLAMMABLE OR EXPLOSIVE FLUIDS
such as gasoline, fuel oil, kerosene, etc. Do not use in a fl ammable
and/or explosive atmosphere. Pump should only be used to pump
clear water. Personal injury and/or property damage could result.
PUMPS ARE NOT DESIGNED TO TRANSFER WATER
INTENDED FOR DRINKING. Do not use the pump for moving
water that will be used for potable/drinking water. Pump
should only be used in applications for which it is designed.
Read and save these instructions. This manual contains very important Safety Warnings and Operating Instructions. You will need to refer to
it before attempting any installation or maintenance. Always keep this manual with the unit so that it will be easily accessible. Failure to read
and follow these warnings and instructions could result in property damage, serious injury or death.
Printed on 100% Recycled Paper
INSTALLATION MANUAL
CAUTION INDICATES A POTENTIALLY HAZARDOUS
SITUATION WHICH, IF NOT AVOIDED, MAY RESULT
IN MINOR OR MODERATE INJURY.
TO REDUCE THE RISK OF HAZARDS THAT
CAN CAUSE INJURY OR PROPERTY DAMAGE,
OBSERVE THE FOLLOWING WARNINGS:
IF THIS PUMP CONTAINS A SWITCH FOR AUTOMATIC
OPERATION, IT IS THE INSTALLER’S RESPONSIBILITY
TO MAKE SURE THE SWITCH IS ABLE TO OPERATE
WITHOUT ANY OBSTRUCTIONS WITHIN THE BASIN. It is
recommended that the installer test and observe the pump’s
operation for several cycles after installation.
IT IS RECOMMENDED TO USE RIGID PIPING AND
FITTINGS to secure the pump in the basin and reduce pump
movement. Pump movement can prevent the switch from
operating correctly.
THIS PUMP SHOULD BE INSPECTED 3 TO 4 TIMES PER
YEAR for pump movement or buildup of debris on the switch or
fl oat. Reposition pump if it has moved. Remove any debris that
could interfere with the operation of the switch.
2
IT IS RECOMMENDED TO USE A CHECK VALVE with this
pump to prevent the back-fl ow of fl uid after each pump cycle.
DO NOT INSTALL OR OPERATE THE PUMP IF IT HAS
BEEN DAMAGED IN ANY WAY.
DO NOT LIFT OR CARRY THE PUMP BY THE POWER
CORD. Use the pump’s handle.
DO NOT USE THIS PUMP IN MUD, SAND, CEMENT, OIL
OR CHEMICALS.
DO NOT USE SUMP AND EFFLUENT PUMPS TO HANDLE
RAW SEWAGE.
AN INDEPENDENT HIGH WATER ALARM OR BACK UP
PUMP SHOULD BE USED when risk of property damage from
high water levels exists
THE SWITCH SHOULD BE REPLACED EVERY TWO (2)
YEARS. This maintenance will reduce the risk of improper
pump operation, switch failure, or fl ooding.
Figure 1: Submersible Sump Figure 2: Pedestal Sump
1
2
3
5
8
9
7
6
1. GFCI OUTLET 5. PIPE INLET 9. SUMP BASIN
2. CHECK VALVE 6. DISCHARGE PIPE 10. FLOAT ROD
3. VENT PIPE 7. SUMP PUMP 11. FLOAT GUIDE
4. GASKET/BASIN LID 8. SWITCH (SEE CHART A, ON PAGE 3) 12. SWITCH ARM
MINIMUM
BASIN
HEIGHT
(SEE
CHART A,
COLUMN B)
MINIMUM BASIN DIAMETER
(SEE CHART A, COLUMN A)
4
MAXIMUM
BASIN HEIGHT
(SEE CHART B,
COLUMN B)
MINIMUM BASIN
DIAMETER
(SEE CHART B,
COLUMN A)
8
6
2
3
7
9
11
5
12
10
4
TYPICAL SUMP INSTALLATION DIAGRAMS
Printed on 100% Recycled Paper
1

Produkt Specifikationer

Mærke: Wayne
Kategori: Pomp
Model: CDU980E

Har du brug for hjælp?

Hvis du har brug for hjælp til Wayne CDU980E stil et spørgsmål nedenfor, og andre brugere vil svare dig


Pomp Wayne Manualer

Wayne

Wayne CDU980E Manual

12 August 2024
Wayne

Wayne CDU800 Manual

8 August 2024

Pomp Manualer

Nyeste Pomp Manualer

Little Giant

Little Giant OPWG-29 Manual

1 April 2025
Interphone

Interphone Air Pump 3000 Manual

1 April 2025
Grundfos

Grundfos UPS 20-60 N 150 Manual

1 April 2025
Grundfos

Grundfos UPS 40-50 FN 250 Manual

1 April 2025
Grundfos

Grundfos MTA 120-280 Manual

1 April 2025
Grundfos

Grundfos DMX 860-5 Manual

1 April 2025
Grundfos

Grundfos UPM4 Manual

1 April 2025
Grundfos

Grundfos DMH 880-10 Manual

1 April 2025
Grundfos

Grundfos MTA 200-280 Manual

1 April 2025
Grundfos

Grundfos MTSE 40-66 Manual

1 April 2025