Whirlpool FFD 10449 CV GCC Manual

Whirlpool Vaskemaskine FFD 10449 CV GCC

Læs gratis den danske manual til Whirlpool FFD 10449 CV GCC (4 sider) i kategorien Vaskemaskine. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Whirlpool FFD 10449 CV GCC, eller vil du spørge andre brugere om produktet?

Side 1/4
EN
Quick guide
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your appliance on
www.whirlpool.eu/register
Before using the appliance carefully read the Health and Safety guide.
Before using the machine, it is imperative that the transport bolts are removed. For more detailed
instructions on how to remove them, see the Installation Guide.
PROGRAMME CHART
1. “ON/OFF button
2. Programme selector
3. Temperature button
4. “Spin button
5. “Start delay button
6. “Start/Pause” button
7. Option buttons
8. “Key lock“button
INDICATORS
Door can be opened
Washing phase
Indicates washing phase of the cycle
Failure: Call Service
Refer to Troubleshooting section
Failure: Water lter clogged
Water cannot be drained; water lter
might be blocked
Failure: Water tap closed
No or not sucient inlet water. “Beep
sound every 5 seconds.
CONTROL PANEL
2.1. 6.3. 4. 5.
8.7. 7.
PRODUCT DESCRIPTION
1. Worktop
2. Detergent dispenser
3. Control panel
4. Door handle
5. Door
6. Water lter - behind plinth
7. Plinth (removable)
8. Adjustable feet (4)
1.
2.
7.
3.
4.
5.
6.
8.
DETERGENT DISPENSER
Main wash compartment
Detergent for the main wash, stain remover
or water softener. For a liquid detergent it is
recommended to use removable plastic partition
A (supplied) for a proper dosage. If powder
detergent is used, place the partition into slot B.
Prewash compartment
Detergent for the prewash.
Softener compartment
Fabric softener. Liquid starch.
Pour in softener or starch solution only up to the max mark.
Release button
Press to remove tray for cleaning.
A
B
This data may dier in your home due to changing conditions in inlet water temperature,
water pressure etc. Approximate programme duration values refer to the default setting of the
programmes, without options.
** After programme end and spinning with maximum selectable spin speed, in default
programme setting.
*** The duration of the programme is shown on the display.
**** The display will show the suggested spin speed as default value.
6th Sense - the sensor technology adapts water, energy and programme duration to your wash
load.
1) Test wash cycle according to UAE.S 5010-2 : 2019 regulations:
Set WHITE wash program at a temperature of 60°C for the Standard Cotton 60°C.
Cotton Eco - Test wash cycles in compliance with regulations 1061/2010.
These are the reference programs for the energy label. Set this wash cycles with a
temperature of 40°C or 60°C. They are the most ecient programmes in terms of energy
and water consumption for washing normally soiled cotton laundry. The actual water
temperature may dier from the declared one.
For all Test Institutes:
Long wash cycle for cottons: set wash cycle with a temperature of 40°C.Cotton
Synthetic program along: set wash cycle with a temperature of 40°C.Synthetics
Max load 10 Kg
Power consumption in o -mode 0.5 W / in left-on mode 8 W Detergents and additives Recommend-
ed detergent
Residual
dampness % (**)
Energy
consumption kWh
Total water lt
Programme
Temperatures Max.
spin
speed
(rpm
Max
load
(kg
Duration
(Minutes
Prewash Main
wash Softener Pow-
der Liquid
Default Range
Mixed 40°C - 40°C 10
1000 *** – –
White (1)(Whites) 60°C - 90°C 10
1400 *** (90°) – –
Cotton 40°C - 60°C 10 255
1400   49 1,10 97
Cotton
60°C 60°C 10 250
1400   53 1,0 53
40°C 10 255 1400   49 1,10 97
Bed linen 60°C - 60°C 10 1400 ***   – –
Sport 40°C - 40°C 4.5
600 *** – –
Duvet (Duvets) 30°C - 30°C 3.5
1000 *** – –
Steam Refresh - 2 – –***
Spin & Drain 10 – –
1400 ***
Rinse & Spin 10 – –1400 *** – –
Rapid 30’ 30°C - 30°C 1200
(****) 5.5 –*** – –
Colours 1 15°C 15°C 5.5 1000 *** – –
Silk 30°C - 30°C 600
(****) 1 –*** – –
Wool 40°C - 40°C 800 2.5
*** – –
Delicates 30°C - 30°C 600
(****) 1 –*** – –
Synthetics 40°C - 60°C 1200 5.5
175   35 0,8 55
Dosing required Dosing optional
PROGRAMMES
For choosing the appropriate programme for your kind of
laundry, always respect the instructions on the care labels of
the laundry. The value given in the tub symbol is the maximum
temperature possible for washing the garment.
Mixed
For washing lightly to normally soiled resilient garments in cotton, linen,
syntheticbres and mixed bres.
White
For washing normally to heavily soiled towels, underwear, table and bed
linen, etc in resilient cotton and linen. Only when the temperature is
selected at 90°C the cycle is provided with a prewash phase before main
washing phase. In this case it is recommended to add detergent both, in the
prewash and main wash section.
Cotton
Normally to heavily soiled and robust cottons .
Eco Cotton
For washing normally soiled cotton garments. At 40°c and 60°C, this is the
standard cotton programme and the most ecient in terms of water and
energy consumption.
Bed linen
Use this programme to wash bed linen an towels in one single cycle. It
optimises softner performance and helps you save time and energy. We
recommend to use powder detergent.
Sport
For washing lightly soiled sports clothing (tracksuits, shorts, etc.). For best
results, we recommend not exceeding the maximum load indicated in the
‘PROGRAMME CHART‘. We recommend using liquid detergent , and adding
the amount suitable for half-load.
Duvet
Designed for washing eiderdown padded items such as double or single
duvets, cushions and anoraks. It is recommended to load such padded
items in the drum with the edges folded inwards and not to exceed ¾ of
the drums volume. For optimal washing, we recommend using a liquid
detergent.
Steam Refresh
This programme refreshes garments by removing bad odours and relaxing
the bres (2 kg, roughly 3 items). Insert dry items only (that are not dirty)
and select programme “Steam Refresh”. Garments will be a little damp
at the end of the cycle and can be worn after a few minutes. The Steam
Refresh programme makes ironing easier.
! Not recommended for wool or silk garments.
! Do not add softeners or detergents.
Spin & Drain
Spins the load then empties the water. For resilient garments. If you exclude
the spin cycle, the machine will drain only
Rinse & Spin
Rinses and the spins. For resilient garments.
Rapid 30’
For washing lightly soiled garments quickly. This cycle lasts only 30 minutes,
saving time and energy.
Colours 15°
This cycle helps protect colours by washing in cold water (15°C) and uses
less energy to heat the water while still oering satisfactory wash results.
Suitable for lightly soiled, ustained garments. This cycle oers wash results
comparable to 40°c mixed at just 15°C.
Silk
Use this cycle to wash all silk garments. We recommend the use of special
detergent which has been designed to wash delicate clothes.
Wool
All wool garments can be washed using programme ‚“Wool“ even those
carryng the hand-wash only “ label. For best results, use special detergents
and do not exceed max kg declaration of laundry.
Delicates
For washing particularly delicate garments. Preferably turn garments inside
out before washing.
Synthetics
For washing soiled garments made from syntheticbres (such as polyester,
polyacrylic, viscose, etc.) or cotton/synthetic blends.
FIRST TIME USE
The rst time the machine is switched on, you will be asked to select the
language and the display will automatically show the language selection
menu.
To select the desired language press the Temperature button or “Start
delay button; to conrm the selection press the “Spin” button.
To change the language switch o the washing machine and press buttons
“Key lock” , “Intensive rinse” and simultaneously until an
alarm is heard: the language-selection menu will be displayed again.
To remove any residues from the manufacturing process. Select the
“Cotton programme at a temperature of 60°C. Add a small amount of
heavy duty detergent to the main wash compartment of the detergent
dispenser (maximum 1/3 of the quantity recommended by the detergent
manufacturer for lightly soiled laundry). Start the programme without
adding any laundry.
DAILY USE
Prepare your laundry according to the recommendations in the “HINTS
AND TIPS” section. Load the laundry, close the door, open the water tap
and press the “ON/OFF button to switch the washing machine on,
the “Start/Pause button ashes. Turn the programme selector to the
desired programme and select any option if needed. The temperature
and spin speed shown on the display can be changed by pressing the
Temperature button or the “Spin button. Pull out the detergent
dispenser and add the detergent (and additives/softener) now. Observe the
dosing recommendations on the detergent pack. Then close the detergent
dispenser.
STARTING CYCLE
Press the “Start/Pause button.
The machine will lock the door ( symbol OFF) and the drum will
start to rotate; the door will be unlocked ( symbol on) and then
locked again ( symbol OFF) as preparation phase of each washing
cycle. The “Clicking” noise is part of the door locking mechanism.
Water will enter the drum and start the washing phase once the
door is locked.
PAUSE A RUNNING PROGRAMME
To pause the wash cycle, press the button Start/Pause” again; the
indicator light will ash. If the symbol is illuminated, the door may be
opened. To start the wash cycle from the point at which it was interrupted,
press the button again.
OPEN THE DOOR, IF REQUIRED
Before starting and after end of a programme, the “Door open” symbol
lights to show the the door can be opened. As long as a wash programme is
running, the door remains locked. To open the door while a programme is
in progress, press the Start/Pause button. Provided the water level and/
or temperature is/are not too high, the door open indicator lights up
and you can open the door. For example to add/ remove laundry. Press the
Start/Pause button again to continue the programme.
PROGRAMME END
The “Door open indicator lights up, and the display shows Cycle end.
To switch othe washing machine after programme end press the
ON/OFF” button, the lights go o. If you do not press “ON/OFF
button, the washing machine will switch o automatically after about a
10 minutes. Close the water tap. Open the door and unload the machine.
Leave the door ajar to allow the drum to dry.
OPTIONS
! If the selected function is incompatible with the set programme, the
incompatibility will be signalled by a buzzer (3 beeps) and the wording
“No Selection” will appear on the display.
! If the selected function is incompatible with another previously set
function, the wording will appear on the display and the “No Selection”
function will not be enabled.
Clean+
Clean+ is an option working on 3 dierent levels (Intensive, Daily and Fast)
that are specially designed to set the right washing action, depending on
your cleaning needs:
Intensive: this option is designed for high levels of dirtiness, removing most
stubborn stains.
Daily: this option is designed to remove everyday stains.
Fast: this option is designed to remove lightly soiled stains.
Intensive rinse
By selecting this option, the eciency of the rinse is increased and optimal
detergent removal is guaranteed. It is particularly useful for sensitive skin.
Press the button once, two or three times to select an additional 1, 2 or 3


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Vaskemaskine
Model: FFD 10449 CV GCC

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool FFD 10449 CV GCC stil et spørgsmål nedenfor, og andre brugere vil svare dig