Whirlpool WHE22333 4 Manual

Whirlpool Fryser WHE22333 4

Læs gratis den danske manual til Whirlpool WHE22333 4 (4 sider) i kategorien Fryser. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Whirlpool WHE22333 4, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

INSTRUCTIONS FOR USE

DIAGRAM OF THE APPLIANCE (Fig. 1)

A. Handle.

B. Safety lock (if provided).

C. Gasket.

D. Separator (if provided).

E. Defrost water drain plug.

F. Control panel.

G. Side motor cooling grille.

DIAGRAM OF THE CONTROL PANEL (Fig. 2)

1. Red light: when ashing, indicates an alarm condition

(see paragraph “TROUBLESHOOTING GUIDE”).

2. Blue light: The function “6th Sense” is automatically

activated and does not need to be selected by the user,

therefore the blue LED (2) “Sense” always remains

on. For more technical details, refer to paragraph “6th

Sense function”.

3. Green lights: indicate that the product is running and

the temperature has been set.

4. Set temperature button: to adjust the set temperature

and to activate/deactivate fast freeze procedures.

INSTALLATION

• Unpack the appliance.

• Remove the 4 spacers inserted between the door

and the appliance. (Fig. 3)

• Make sure the defrost water drain plug (if provided) is

correctly positioned (E).

• For optimum appliance operation and to avoid damage

when the door is opened, leave a space of at least 7 cm

from the rear wall and 7 cm at the sides. (Fig. 4)

• Fit the accessories (if provided).

• Clean the inside of the appliance before using it.

SWITCHING ON THE APPLIANCE

• Plug in the appliance.

• The green LED lights up (“Normal”).

• The blue LED lights up (“Sense”).

• The red LED ashes to indicate that the temperature

inside the appliance is not yet suciently low for food

storage. The red LED will normally switch o within the

rst six hours after the appliance is switched on.

• Place food inside the product only when the red LED has

switched o.

Note: As the seal is tight, the appliance lid cannot be

reopened immediately after closing. Wait a few minutes

before re-opening the lid of the appliance.

• This appliance features “skin condenser”

technology: the condensing unit is integrated into

the walls of the freezer. For this reason the side and

front walls of the product may become hot while

the product is running. This is entirely normal and

also reduces the risk of condensation forming in

particularly critical environmental conditions (see

paragraph “Troubleshooting guide”).

TEMPERATURE ADJUSTMENT

Use the key (4) to select the desired temperature.

To adjust the internal temperature, proceed as follows:

• Repeatedly press the key (4). Each time the key is

pressed, the set temperature is updated, displaying the

“Normal”, “Eco” and “Max” values in succession.

• Select “Max” for a colder storage temperature.

• With partial loads “Eco” is recommended: this setting will

optimize energy consumption.

The green indicator lamps indicate the selected setting (3)

according to the following diagram:

Eco: least cold temperature (left

indicator lamp lit).

Normal: intermediate temperature

(right indicator lamp lit).

Max.: extra low temperature (both

indicator lamps lit).

Shopping: Fast Freezing (both

indicator lamps lit).

See section “Freezing fresh food”.

Note: The settings will be saved in the memory even if a

power cut occurs. The time needed for the temperature

inside the freezer to reach the set value, can vary

depending on climatic conditions and the set temperature

itself.

‘6TH SENSE’ FUNCTION

The “6th Sense” function is always active to control the

internal temperature of the appliance and guarantee the

optimum conditions.

It automatically intervenes in the following cases:

• door opening

This function activates every time the opening of the

door changes the internal temperature of the appliance.

The function remains active for the time needed to

reinstate optimum operating conditions.

• storing food inside the freezer

This function activates every time signicant quantities

of food are introduced. It remains active for the time

needed to reinstate optimum freezing conditions of

the food introduced, ensuring the best compromise

between the quality of the freezing process and energy

consumption.

Note: The duration of the “6th Sense” function is set

automatically, and may vary depending on the way the

product is used.

FREEZING FOOD

Preparation of fresh food for freezing

• Before freezing, wrap and seal fresh food in: aluminium

foil, cling lm, air and water-tight plastic bags,

polyethylene containers with lids, provided they are

suitable for freezing foods.

• Food must be fresh, mature and of prime quality in order

to obtain high quality frozen food.

• Fresh vegetables and fruit should preferably be frozen

as soon as they are picked to maintain the full original

nutritional value, consistency, colour and avour.

• Always leave hot food to cool before placing in the

appliance.

Freezing fresh food

• Place foods to be frozen in direct contact with the walls

of appliance:

A) - foods to be frozen,

B) - foods already frozen.

• Avoid placing foods to be frozen in direct contact with

food already frozen.

• For best and fastest freezing, foods should be split into

small portions; this will also be useful when the frozen

items are to be used.

• If minimum quantities of food are introduced (up to 1/4

of the maximum freezing power stated on the rating

plate), the operation of the appliance will be controlled

automatically by the “6th Sense” function without any

need for intervention from the user.

• When freezing higher quantities of food, up to the

maximum freezing capacity of the appliance, indicated

on the rating plated, proceed as follows:

1. At least 24 hours before storing fresh foods inside the

product for freezing, activate the fast freezing function

by pressing (4) for approximately 3 seconds. The

green LEDS (3) ash in sequence.

2. Introduce the food to freeze inside the appliance, and

keep the door of the appliance closed for 24 hours.

After this period the food will be frozen.

The fast freezing function can be deactivated manually by

pressing (4).

If the fast freeze function is not manually deactivated, it

will be automatically deactivated by the appliance after

50 hours.

FOOD STORAGE

Refer to the table on the appliance.

Classication of frozen foods

Load and classify the frozen foods; it is advisable

to indicate the storage date on the packs, to ensure

consumption before the expiry dates listed in months in

Fig. 6 for each type of food.

Advice for storing frozen food

When buying frozen food, make sure that:

• The packaging is intact (food in damaged containers

may have deteriorated). If a package is swollen or has

damp patches, the product may not have been stored

in optimum conditions and therefore undergone partial

defrosting.

• When shopping, leave frozen food purchases until last

and carry them in a thermally insulated bag.

• On arriving home, immediately place the frozen food in

the appliance.

• Avoid or minimise temperature variations. Observe the

expiry date on the packaging.

• Always follow the storage instructions on frozen food

packages.

Note:

Eat fully or partially defrosted foods immediately.

Do not refreeze unless the food is cooked after it has

thawed. Once cooked, the food can be refrozen.

In case of a prolonged power failure:

• Do not open the appliance door, except to place ice

packs (if provided) over the frozen foods on the right and

left side of the appliance. This will slow down the rise

in temperature.

APPLIANCE DEFROSTING

The appliance should be defrosted when the thickness of

ice on the walls reaches 5-6 mm.

• Disconnect the appliance from the power supply.

• Remove food from the appliance and put it in a very cool

place or a thermally insulated bag.

• Leave the appliance door open.

• Remove the internal defrost water drain plug (depending

on model) (Fig. 8).

• Remove the external defrost water drain plug (depending

on model) and reposition it as shown in Fig. 8.

• Use the separator (depending on model) inside the

product as a recipient for any remaining water, (D) as

shown in Fig. 8. If there is no separator, use a shallow

container.

• Defrosting can be sped up by using a spatula to detach

the frost from the appliance walls.

• Remove the frost from the bottom of the appliance.

• In order to avoid permanent damage to the

appliance interior, do not use pointed or sharp

metal instruments to remove the ice.

• Do not use abrasive products or heat up the interior

articially.

• Dry the inside of the appliance thoroughly.

• Ret the plug after defrosting.

CHANGING THE LID LIGHT BULB (if provided)

• Disconnect the appliance from the mains power supply.

• Remove the diuser by following the sequence of steps

shown in the gure.

• Unscrew the light bulb and replace it with an identical

bulb of the same wattage and voltage.

• Ret the diuser and plug in the appliance.

TROUBLESHOOTING GUIDE

1. The red LED ashes.

• Is there a power failure?

• Is a defrosting operation in progress?

• Has fresh food recently been introduced?

• Is the appliance lid properly closed?

• Is the appliance placed near a heat source?

• Are the ventilation grille and condenser clean?

2. All LEDs ash at the same time.

• Contact the After-Sales Service.

3. The appliance is too noisy.

• Is the appliance perfectly horizontal?

• Is the appliance in contact with other furniture or

objects that may cause vibrations?

• Has the packaging been removed from under the

appliance?

Note: Gurgling noises from the refrigerating circuit after the

compressor cuts out are perfectly normal.

4. All LEDs are o and the product is not working.

• Is there a power failure?

• Is the plug properly inserted in the socket?

• Is the electric cable intact?

5. All LEDs are o and the product is working.

• Contact the After-Sales Service.

6. The compressor runs continuously.

• Have hot foods been put in the appliance?

• Has the appliance lid been left open for a long time?

• Is the appliance placed in a very warm room or near

heat sources?

Produkt Specifikationer

Mærke:	Whirlpool
Kategori:	Fryser
Model:	WHE22333 4
Justerbar termostat:	Ja
Vekselstrømsindgangsspænding:	220 - 240 V
Vekselstrømsindgangsfrekvens:	50 Hz
Bredde:	1180 mm
Dybde:	698 mm
Højde:	916 mm
Vægt:	45100 g
Produktfarve:	Hvid
Kontroltype:	Berøring
Indbygget skærm:	Ingen
Produkttype:	Kummefryser
Strøm:	16 A
Ledningslængde:	2.45 m
Pakkevægt:	46500 g
Årligt energiforbrug:	165 kWh
Driftstemperatur (T-T):	10 - 43 °C
Placering af apparat:	Fritstående
Indvendig belysning:	Ja
Dørhængsel:	Op
Tilsluttet belastning:	100 W
Støjniveau:	42 dB
Energieffektivitetsskala:	A til G
Støjemissionsklasse:	D
Energieffektivitetsklasse:	D
Vendbare døre:	Ingen
Fryser, netto rumindhold:	219 L
Fryser, brutto rumindhold:	220 L
Frysekapacitet:	16 kg/24t
Opbevaringstid under strømafbrydelse:	40 t
Klimaklasse:	SN-T
Frostfri system:	Ingen
Stjernebedømmelse:	4*
Automatisk afrimning (fryser):	Ingen
Hurtig frys funktion:	Ja
Fryser antal hylder/kurve:	3
Låsning:	Ja
Fejlalarm:	Ingen
Afrimning vandafløb:	Ja
Fejlindikation:	Ja