Whirlpool WHFG 63 F LE X Manual

Whirlpool Emhætter WHFG 63 F LE X

Læs gratis den danske manual til Whirlpool WHFG 63 F LE X (3 sider) i kategorien Emhætter. Denne vejledning er vurderet som hjælpsom af 45 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 23 anmeldelser. Har du et spørgsmål om Whirlpool WHFG 63 F LE X, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

Quick guide

THANK YOU FOR BUYING A WHIRLPOOL PRODUCT

In order to receive a more complete assistance, please

Before using the appliance carefully read the Safety

Instruction.

PRODUCT DESCRIPTION

FIRST TIME USE

AIR VENT FOR THE SUCTION VERSIONS

Connect the hood and discharge holes on the walls with a diameter

equivalent to the air outlet (connection ange).

Using the tubes and discharge holes on walls with smaller dimensions

will cause a diminution of the suction performance and a drastic

increase in noise.

Any responsibility in the matter is therefore declined.

!Use a duct of the minimum indispensible length.

!Use a duct with as few elbows as possible (maximum elbow angle: 90°).

!Avoid drastic changes in the duct cross-section.

!The company declines any responsibility whenever these regulations

are not respected.

FILTERING OR DUCTING?

!Your cooker hood is ready to be used in suction version.

To use the hood in ltering version the special ACCESSORY KIT must be

installed.

Check if the ACCESSORY KIT is furnished or must be bought separately.

Note: If furnished, in certain cases, the additional activated carbon ltering

system may be installed on the hood. Information about the conversion of

the hood from suction version to ltering version is present in the Manual

“Safety Instructions & Installation”.

DUCTING VERSION

In this case the fumes are conveyed outside of the building by means

of a special pipe connected with the connection ring located on top of

the hood.

Attention! The exhausting pipe is not supplied and must be purchased

apart. Diameter of the exhausting pipe must be equal to that of the

connection ring.

Attention! If the hood is supplied with active charcoal lter, then it

must be removed.

FILTER VERSION

The aspirated air will be degreased and deodorised before being fed

back into the room.

In order to use the hood in this version, you have to install a system of

additional ltering based on activated charcoal.

CONTROL PANEL

T1. Fan Motor / ON/OFF 1st speed

T2. Fan Motor / ON/OFF 2nd speed

T3. Fan Motor / ON/OFF 3rd speed

T4. “POWER BOOST“ ON/OFF Function

(time-controlled)

Note: the hood will go back to running at the

3th speed, after ve minutes.

T5. Operation “ZEN Mode” ON/OFF

Function

Note: This function makes it possible to activate

an extraction speed with the perfect balance

between quietness and extraction eciency.

T6. Main light ON/OFF

GREASE/CHARCOAL FILTER ALARM/RESET

At regular intervals, the hood signals the need to perform lter

maintenance.

Note: The indicators will only work for 40secs after switching OFF Fan

Motor speed.

T1 + T2 ashing: carry out maintenance of the grease lter.

T3 + T4 ashing: carry out maintenance of the charcoal lter.

Note: charcoal lter alarm is normally disabled, to enable: switch hood

OFF then press and hold T3+T4 for more than 3 secs, both signals lit for

about 3secs to indicate charcoal lter alarm is enabled. Repeat operation

to disable (both signals ashes for about 3 secs).

Resetting the lter saturation indicators

Press and hold for almost 3 secs signals while ashing.

* Available only on certain models

TECHNICAL DATA

Model Height (cm) Width (cm) Depht (cm) Ø of exaust tube (cm)

WHC 93 F LT X 74.5 -118.5 89.8 52.0 15

WHC 63 F LT X 74.5 -118.5 59.8 52.0 15

WHC 63 F LB X 74.5 -118.5 59.8 51.5 14.9

WHC 93 F LE X 74.5 -118.5 89.8 51.5 14.9

WHBS 93 F LE X 70.7 – 114.8 89.8 45.0 14.9

WHBS 63 F LE X 70.7 – 114.8 59.8 45.0 14.9

WHFG 63 F LE X 68.3 – 113.7 59.8 41.4 14.9

WHFG 93 F LE X 68.3 – 113.7 89.8 41.4 14.9

WIFG 103 F LE X 78.4 – 106.4 99.8 50.9 14.9

CLEANING AND MAINTENANCE

CLEANING

• Do not use steam-cleaning equipment.

• Disconnect the appliance from the mains.

Important: do not use corrosive or abrasive detergents. If any such

products unintentionally come into contact with the appliance, clean

the appliance immediately with a damp cloth. Do not use alcohol.

• Clean the surfaces with a damp cloth. If it is very dirty, add a few

drops of washing-up detergent to the water. Finish o with a dry

cloth.

Important: do not use abrasive sponges or metallic scrapers or

scourers. Over time, these can ruin the enamel surfaces.

• Use detergents specically designed for cleaning the appliance

and follow the manufacturer's instructions.

Important: clean the lters at least once a month to remove oil and

grease residue.

MAINTENANCE OF THE GREASE FILTERS

This must be cleaned once a month (or when the lter saturation

indication system - if envisaged on the model in possession - indicates

this necessity) using non aggressive detergents, either by hand or in the

dishwasher, which must be set to a low temperature and a short cycle.

When washed in a dishwasher, the grease lter may discolour slightly,

but this does not aect its ltering capacity.

Pull out the handle to remove the lter.

Once the lter has been washed and left to dry, proceed in reverse

order to ret the lter.

MAINTENANCE OF THE CHARCOAL FILTER (FOR FILTRATION

MODELS ONLY)

This lter retains the unpleasant odours produced during cooking.

Saturation of the carbon lter occurs after a relatively long use,

however this depends on the type of cooking and how regularly

the grease lter is cleaned. Regardless, it is necessary to replace the

cartridge every 4 months. It CANNOT be washed or recycled.

Fitting or replacing the carbon lter

1. Disconnect the hood from the mains.

2. Remove the grease lters.

3. Hook the carbon lter rstly to the metal tab at the back on the

hood and then x it at the front with the two knobs.

4. Reinstall the grease lter in place.

Proceed in reverse order to remove.

REPLACING THE LAMPS

The hood is equipped with an LED lighting system.

LEDs ensure excellent illumination, have a service life up to 10 times

longer than traditional bulbs, and oer up to 90% energy savings.

Note: For replacement LED, please contact the Technical After-sales Service

Centre.

* Available only on certain models

Produkt Specifikationer

Mærke:	Whirlpool
Kategori:	Emhætter
Model:	WHFG 63 F LE X

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool WHFG 63 F LE X stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Emhætter Whirlpool Manualer

Whirlpool WEI 9FF LR IX Manual

5 Oktober 2022

Whirlpool WHVS 90F LT C K Manual

5 Oktober 2022

Whirlpool AVM 971 BL Manual

5 Oktober 2022

Whirlpool AKR 558/1 IX Manual

5 Oktober 2022

Whirlpool AKR 759 IX Manual

5 Oktober 2022

Whirlpool WHFG 63 F LE X Manual

5 Oktober 2022

Whirlpool AKR 648/3 IX Manual

5 Oktober 2022

Whirlpool AKR 749/1 NB Manual

5 Oktober 2022

Whirlpool HOO 501-S Manual

5 Oktober 2022

Whirlpool WHSS 90F L T C K Manual

5 Oktober 2022

Emhætter Manualer

Nyeste Emhætter Manualer

Electrolux EFB70460OX Manual

5 Oktober 2022

AEG X69473BV0 Manual

5 Oktober 2022

BEKO HCB 61734 BXH Manual

5 Oktober 2022

Gorenje DK63CLI Manual

5 Oktober 2022

Bauknecht DDE 5790 AL Manual

5 Oktober 2022

Electrolux LFV316K Manual

5 Oktober 2022

Gaggenau AF280160 Manual

5 Oktober 2022

Smeg KS89AE Manual

5 Oktober 2022

Gaggenau AW442190 Manual

5 Oktober 2022

Electrolux LFP316AB Manual

5 Oktober 2022