KEY FOB PROGRAMMING INSTRUCTIONS -
These vehicles can be programmed using the
• 2001-2005 Chevrolet Venture
• 2001-2004 Oldsmobile Silhouette
• 2001-2005 Pontiac Montana
These vehicles require the use of a professional scan
tool for programming (see your local GM dealer or
ACDelco Professional Service Center):
• 2004-2012 Chevrolet Colorado
IMPORTANT: ALL TRANSMITTERS WHICH ARE TO BE RECOGNIZED BY THE
REMOTE CONTROL DOOR LOCK RECEIVER (RCDLR) MUST BE PROGRAMMED IN A
SINGLE PROGRAMMING SEQUENCE. IF THE SYSTEM IS PLACED IN PROGRAM MODE IT
WILL ERASE ALL PREVIOUSLY PROGRAMMED TRANSMITTERS UPON THE RECEIPT OF
THE PROGRAMMING SIGNAL FROM THE FIRST TRANSMITTER. UP TO FOUR TRANSMIT-
TERS CAN BE PROGRAMMED. TO PREVENT THE PROGRAMMING OF TRANSMITTERS TO
AN INCORRECT VEHICLE, DO NOT OPERATE OR PROGRAM THE TRANSMITTERS IN THE
VICINITY OF OTHER VEHICLES THAT ARE IN THE KEYLESS ENTRY PROGRAM MODE.
1. Remove the ignition key from the ignition lock cylinder.
2. Remove the body control module (BCM) PRGRM fuse from the fuse
block. (Refer to “Instrument Panel Fuse Block” in your Owner’s
Manual for the location of your fuse block and the Fuse Usage Chart.)
3. Close all of the doors.
4. Insert the ignition key into the ignition lock cylinder.
5. Turn the ignition to ACC.
6. Turn the ignition to OFF, and then back to ACC within 1 second.
7. Open and then close any vehicle door. The vehicle will chime in
order to confirm that the programming mode has been entered.
8. Press and hold the transmitter LOCK and UNLOCK buttons simul-
taneously for approximately 14 seconds.
IMPORTANT: AFTER APPROXIMATELY 3–5 SECONDS THE VEHICLE WILL CHIME
ONCE TO CONFIRM THAT THE PROGRAMMING HAS BEEN COMPLETED FOR THAT
9. Repeat the previous step in order to program each additional trans-
10. Remove the ignition key from the ignition lock cylinder.
11. Install the BCM PRGRM fuse into the fuse block.
12. Operate the functions of each transmitter in order to verify correct
