Aiwa XP-R120 Manual

Aiwa CD-afspiller XP-R120

Læs gratis den danske manual til Aiwa XP-R120 (8 sider) i kategorien CD-afspiller. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Aiwa XP-R120, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
C
Highlighted letters in the text of this manual correspond to the illustrations.
PRECAUTIONS
To maintain good performance
• Do not use the unit in places which are extremely hot, cold, dusty or humid. In
particular, do not use or keep the unit in following places.
• in a high humidity area such as a bathroom
• near a heater
• in an area exposed to direct sunlight (e.g., inside a parked car, where it can
become extremely hot)
• near sources of strong magnetism, such as televisions, speakers, or magnets
• where there is a lot of movement or vibration, such as on a car dashboard or
an unstable shelf
For safety
• Do not attempt to disassemble the unit. Laser rays from the optical pickup are
dangerous to the eyes.
• Make sure that pins or other foreign object do not get inside the player.
• Take care not to drop the unit or subject it to strong shocks.
• To keep dust from the pickup lens, keep the disc compartment lid closed after
use. Never touch the lens.
• If you hear no sound when playing a disc, DO NOT turn the volume up high
because music could suddenly start at high volume. Turn the volume control to
the lowest level before starting playback and slowly turn it up to the desired
level.
Note on listening with the headphones
• Listen at moderate volumes to avoid hearing damage.
• Do not wear the headphones while driving or cycling. It may create a traffic
hazard.
• You should use extreme caution or temporarily discontinue use in potentially
hazardous situations, such as walking, jogging, etc.
• Wear them properly; L is left, R is right.
Note on condensation
If the unit is suddenly moved from a cold place to a warm one, it may result in
condensation on the pickup lens and malfunction or playback difficulties.
Should this occur, leave the unit for a few hours, then try to playback again.
MAINTENANCE
To clean the lens →A
If the lens becomes dirty, the player will skip or not play. If this occurs, clean the
lens in the following manner.
To remove dust or dry particles, first use a camera lens blower/brush a to blow
a few times to loosen particles, then gently brush the lens clean. Finish byb
blowing the lens again.
To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe
gently from the center to the edge. Lens cleaning solution is commercially
available.
Note
Take care not to get too much solution on the swab, which could flow into the unit
and cause damage.
Pressing too strongly with the swab could scratch or break the lens.
To clean the discs → B
Before playing, wipe the disc from the center outward with a cleaning cloth. After
playing, store the disc in its case.
SPECIFICATIONS
Tracking system 3-beam laser
Laser pickup Semiconductor laser
D/A conversion 4-times oversampling digital filter + 1-bit DAC
Frequency response 20 – 20,000 Hz
Output PHONES/LINE OUT jack (stereo mini-jack)
Frequency range AM: 530/531 kHz – 1,710/1,602 kHz
(10 kHz/9 kHz steps)
FM: 87.5 – 108 MHz
Maximum output 12 mW + 12 mW (16 ohms at 1 kHz)
500 mV (47 k ohms at 1 kHz)
Power supply DC 3 V using two size AA (LR6) alkaline
batteries
DC 2.4 V using two commercially available
(Ni-Cd 1.2 V 700 mAh) rechargeable batteries
AC house current using an AC adaptor whose
rated output is DC 5 – 6 V, 250 – 300 mA
Maximum outside dimensions
130 (W) × 30.5 (H) × 130 (D) mm
(excluding projecting parts and controls)
(5 1/ 8× 1 1/ 4× 5 1/8 in.)
Weight Approx. 238 g (8.3 oz.) excluding batteries
Accessories Stereo headphones (1)
Carrying case (1)
The specifications and external appearance of this unit are subject to change
without notice.
XP-R120
COMPACT DISC PLAYER
OPERATING INSTRUCTIONS
8B-HCB-901-01
010207BYG-O9
Printed in Indonesia
A
B
C
If the lens becomes dirt th l ill ki t lay. If thi lean they, e p ayer w s p or no p s occurs, c
lens in the following manner.
To remove dust or dry particles, first use a camera lens blower/brush a to blow
a few times to loosen particles, then gently brush the lens clean. Finish byb
blowing the lens again.
To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe
gently from the center to the edge. Lens cleaning solution is commercially
available.
Note
Take care not to get too much solution on the swab, which could flow into the unit
and cause damage.
Pressing too strongly with the swab could scratch or break the lens.
To clean the discs → B
Before playing, wipe the disc from the center outward with a cleaning cloth. After
playing, store the disc in its case.
SPECIFICATIONS
Tracking system 3-beam laser
Laser pickup Semiconductor laser
D/A conversion 4-times oversampling digital filter + 1-bit DAC
Frequency response 20 – 20,000 Hz
Output PHONES/LINE OUT jack (stereo mini-jack)
Frequency range AM: 530/531 kHz – 1,710/1,602 kHz
(10 kHz/9 kHz steps)
FM: 87.5 – 108 MHz
Maximum output 12 mW + 12 mW (16 ohms at 1 kHz)
500 mV (47 k ohms at 1 kHz)
Power supply DC 3 V using two size AA (LR6) alkaline
batteries
DC 2.4 V using two commercially available
(Ni-Cd 1.2 V 700 mAh) rechargeable batteries
AC house current using an AC adaptor whose
rated output is DC 5 – 6 V, 250 – 300 mA
Maximum outside dimensions
130 (W) × 30.5 (H) × 130 (D) mm
(excluding projecting parts and controls)
(5 1/ 8× 1 1/ 4× 5 1/8 in.)
Weight Approx. 238 g (8.3 oz.) excluding batteries
Accessories Stereo headphones (1)
Carrying case (1)
The specifications and external appearance of this unit are subject to change
without notice.
USING ON DRY CELL BATTERIES → C
Open the battery compartment and insert two size AA (LR6) alkaline
batteries with the marks correctly aligned.0
and
9
Battery replacement
The battery indicator in the display changes from according
to to
to the remaining power of the batteries. Replace the batteries when lights.
If the unit remains in use after lights, “Lo-bAtt” appears and operation stops.
To maintain preset data
When replacing the batteries, the unit will retain the preset station frequencies
for about 1 minute. To prevent the erasure of the memories, replace the batteries
within 1 minute.
• Before replacing the batteries, turn off the power by pressing
sSTOP/OFF/CHARGE.
Battery life (using alkaline batteries LR6)
Battery life may vary depending on conditions of use.
If the cover of the battery compartment comes off → D
Note on dry cell batteries
• Make sure that the and marks are correctly aligned.0 9
• Do not mix the different types of batteries, or an old battery with a new one.
• To prevent the risk of electrolyte leakage or explosions, never recharge the
batteries, apply heat to them, or take them apart.
• When not using the batteries, remove them to prevent needless battery wear.
• If liquid leaks from the batteries, wipe thoroughly to remove.
D
The setting of the E•A•S•S switch Battery life
ON Approx. 21 hours
OFF Approx. 19 hours
A
B
OWNER’S RECORD
For your convenience, record the model number and the serial number (you
will find it inside the battery compartment of your set) in the space provided
below. Please refer to them when you contact your Aiwa dealer in case of
difficulty.
Model No.
Serial No.
NOTE
FOR USE IN THE U.S.A.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Modifications or adjustments to this product, which are not expressly approved
by the manufacturer, may void the user’s right or authority to operate this
product.

Produkt Specifikationer

Mærke: Aiwa
Kategori: CD-afspiller
Model: XP-R120

Har du brug for hjælp?

Hvis du har brug for hjælp til Aiwa XP-R120 stil et spørgsmål nedenfor, og andre brugere vil svare dig


CD-afspiller Aiwa Manualer

Aiwa

Aiwa PCD-1000BT Manual

13 Januar 2025
Aiwa

Aiwa CX-NDS15 Manual

6 Juli 2024
Aiwa

Aiwa NSX-AJ10 Manual

4 Juli 2024
Aiwa

Aiwa NSX-A30 Manual

4 Juli 2024
Aiwa

Aiwa NSX-A555 Manual

28 Juni 2024
Aiwa

Aiwa NSX-AJ100 Manual

23 Maj 2024
Aiwa

Aiwa NSX-A35 Manual

24 April 2024
Aiwa

Aiwa NSX-AJ800 Manual

13 April 2024
Aiwa

Aiwa CX-NA303 Manual

11 April 2024
Aiwa

Aiwa NSX-D60 Manual

2 April 2024

CD-afspiller Manualer

Nyeste CD-afspiller Manualer

Philips

Philips AX3306 Manual

15 August 2025
Philips

Philips AX5305 Manual

15 August 2025
Philips

Philips AZB1839 Manual

14 August 2025
Sencor

Sencor SPT 1200 Manual

14 August 2025
Sencor

Sencor SPT 280 Manual

14 August 2025
Denon DJ

Denon DJ DN-S3500 Manual

6 August 2025
Denon DJ

Denon DJ DN-S1000 Manual

6 August 2025
Denon DJ

Denon DJ DN-2000FLTD Manual

6 August 2025
Denon DJ

Denon DJ DN-D9000 Manual

6 August 2025
Denon DJ

Denon DJ DN-1000F Manual

5 August 2025