American International NDK724 Manual


Læs gratis den danske manual til American International NDK724 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 5 anmeldelser. Har du et spørgsmål om American International NDK724, eller vil du spørge andre brugere om produktet?

Side 1/4
NDK724 Mounting Kit
Nissan
2011 ROGUE
2012-13 ROGUE (Without 4.3 color display radios)
2007-12 SENTRA
VEHICLE APPLICATIONS (ISO Mount Only)
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC. TECH Ver. 6/13 PRINT Ver. 2/15
1. Carefully lift up and remove the top cover plate from the top of radio/pocket assembly.
2. Remove the (2) Phillips screws from top of radio trim bezel (located under the cover
plate removed in step 1.
3. Carefully lift up the trim from around the shifter lever enough to be able to remove
the panel above.
4. Carefully pull forward the climate control module and lay out of the way.
5. Remove the (2) Phillips screws from the lower radio trim bezel.
6. Carefully pull the Radio/pocket trim bezel forward, disconnect all attached harnesses
and remove the Radio/pocket trim bezel assembly.
7. Remove the (4) Phillips screws securing the factory radio/pocket assembly brackets to
the outermost corners of the trim bezel.
8. Remove the (8) T-20 torx screws securing the factory radio to the factory metal
mounting brackets then remove factory radio.
DASH DISASSEMBLY INSTRUCTIONS
1. Using a panel removal tool, carefully pry the front edge of the center channel speaker
cover upward to unclip and remove from the top of the dash.
2. Remove the (4) Phillips screws securing the center channel speaker (If equipped).
3. Disconnect the center channel wire harness from the speaker and remove speaker
if equipped.
4. Carefully pry the lower side edge trim pieces from beside the Vent/Hazard assembly,
then using a panel removal tool from inside the center channel speaker area at the
top of the dash, slide the panel removal tool between the center channel speaker
mount surface, and the base beneath the center channel speaker mount surface and
pry upward on the Vent panel assembly, disconnect all harnesses from the rear of
the panel and remove assembly.
5. Using a panel removal tool, carefully pry the climate control panel forward and lay out
of the way.
6. Using a panel removal tool, carefully pry and remove the radio panel including
air vents. Unplug hazard button.
7. Remove the (4) Phillips screws securing the radio to the sub-dash.
8. Carefully pull the radio forward, disconnect all wire harnesses and antenna lead
and remove radio
DASH DISASSEMBLY INSTRUCTIONS
2007-12 NISSAN SENTRA
2011-13 NISSAN ROGUE
2


Produkt Specifikationer

Mærke: American International
Kategori: Ikke kategoriseret
Model: NDK724

Har du brug for hjælp?

Hvis du har brug for hjælp til American International NDK724 stil et spørgsmål nedenfor, og andre brugere vil svare dig