1
At Antec, we continually refine and improve our products to ensure the highest
quality. As such, your new product may differ slightly from the description in this
manual. This isn’t a problem; it’s simply an improvement. As of the date of publi-
cation, all features, descriptions, and illustrations in this manual are correct.
Disclaimer
This manual is intended only as a guide for Antec’s Computer Enclosures. For more
comprehensive instructions on installing the motherboard and peripherals, please
refer to the user manuals that come with those components and drives.
MINUET 350 USER’S MANUAL
The Minuet 350 is a small case that’s big on features. It can be configured in
a desktop or vertical orientation. It comes with an 80PLUS® certified 350 Watt
power supply (PSU). The PSU generates less heat because it is designed for high
efficiency. This keeps the power supply cool and prolongs its working life.
The PSU includes Universal Input with Active Power Factor Correction (PFC).
Universal Input allows you to connect your PSU to any AC power outlet between
100~240V without setting a voltage switch. Active PFC reduces electrical waste
by improving the power factor value to the power supply, helping the power plant
to provide power more efficiently.
The PSU comes with an on/off switch. Make sure you turn the switch to the ON
(I) position before you boot up your computer for the first time. Normally, you
won’t need to switch it OFF (O), since the power supply can be controlled with the
soft on/off switch on the front of your computer case. If your computer crashes
and you can’t shut it down using the soft switch, you can switch the main power
to the OFF (O) position to clear the fault, then reboot.
SETTING UP
1. Take the case out of the box. Remove the Styrofoam and the plastic bag.
Place the case on a flat surface.
2. Remove the thumbscrews from the top panel (at the rear of the case). Slide
the panel to the rear of the case and remove it. Set the panel safely aside.
Note: Please don’t try to use your fingernails to pry or lift the panel.
3. Inside the case you should see the power supply, some wiring with marked
connectors (USB, PWR etc.), an installed I/O panel and a power cord. You will
also find a bag of screws, four rubber feet and two plastic stands.
4. Horizontal Orientation: stick the four adhesive rubber feet to the bottom panel
of the case to protect the paint from scratches.
5. Vertical Orientation: place the Minuet 350 in the two plastic stands such that
the side panel with the 80mm fan is facing up. Adjust the stands to fit snugly
against the case sides.
