Congratulations, you have purchased one of the finest
quality aquariums available. This product will give you
many years of excellent service when installed and
maintained correctly.
Getting started:
WARNING: the aquarium alone even when empty
may weigh up to 150KG. It must be lifted by at
least two capable people. Please read all instruc-
tions for all appliances before commencing
installation.
Step 1: Cabinet set up: please follow the set up
instructions for the cabinet enclosed.
Step 2: Preparing the aquarium: remove all packag-
ing from aquarium. Check carefully for any signs of
damage to glass and structure. We suggest cleaning
the tank inside before positioning on the cabinet. (see
cleaning instructions below). NOTE: the aquarium
has a protective mat underneath the tank. This
must stay there to protect the glass aquarium.
Non use of this mat invalidates the guarantee.
Step 3: Setting up the lighting system: once
aquarium is in position. (see set up of lighting) Check
lighting functions correctly. If you have chosen to
change the colour spectrum of your light tubes see
(changing your light tubes), do this while the lights
are not positioned on the aquarium.
TOP TIP: we suggest removing the lighting when filling
and landscaping the aquarium to avoid possibilities of
accidental damage.
GENERAL SAFETY NOTICE
It is absolutely imperative that you ensure this cabinet
and aquarium is installed upon level flooring. It is also
a prerequisite that. you ensure the flooring upon which
it is positioned is able to support the weight of this
aquarium which could be up to 1000kg including water
and decorations. Installation upon uneven flooring will
result in poor distribution of weight. Damages to the
aquarium, cabinet or equipment and damages caused
by leaks due to improper or uneven installation are
not covered by the guarantee with this product. We
recommend against aquariums above 150KG being
installed on 2nd story floorboards.
Connecting your appliance to the mains elec-
tricity supply - Country specific instructions.
United Kingdom Only
The plug supplied with this product is a sealed plug
and we do not recommend removing or changing it.
However, should the need arise, only a suitable plug
should be connected using the following diagram 1
An approved earth leakage circuit breaker (RCCB) or
otherwise known as an Residual circuit current device
(RCCD) must be also fitted in the supply line.
IF YOU ARE IN ANY DOUBT ABOUT INSTALLING
YOUR APPLIANCE YOU SHOULD CONSULT A
QUALIFIED ELECTRICIAN.
L E
Red or Brown
Blue or Black
Green with a
Yellow Stripe
N
Diagram 1
