Artec SE-2 Manual


Læs gratis den danske manual til Artec SE-2 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Artec SE-2, eller vil du spørge andre brugere om produktet?

Side 1/1
-Bass : +/-12 dB at 100 Hz
-Treble : +/-12 dB at 4 kHz
-Balance : MN500K Potentiometer
-Current : 0.16 mA
-Voltage range : 6 V ~ 22 V
-Battery : 9 V Alkaline
Specifications
The products manufactured by ARTEC will be free from defect in workmanship and
meterials for a period of two years from proven date. For warranty, please contact
Limited Warranty
-Bass : +/-12 dB at 100 Hz
-Treble : +/-12 dB at 4kHz
-Balance : MN500K Potentiometer
-Current : 0.16 mA
-Voltage range : 6 V ~ 22 V
-Battery : 9 V Alkaline
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
The plasticiser contained in the rubber feet of this product may possibly react
with the coating of your parquet, linoleum, laminate, or PVC floor and, after
some time, cause permanent dark stains. In case of doubt, do not put the
rubber feet directly on the floor, but use felt-pad floor protectors or a carpet.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal ÿ rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult
your local waste disposal facility.
BASS, TREBLE CONTROL EQUALIZER
SE /SE -A-2 2
SE -A2
S
E
2
SE2
SE -A2
If use a battery, When the indicator goes blinking or no longer lights while an effect
is on, it means that the battery is nearly dead and must be replaced. Also it means
that the voltage of power supply is too low or disconnected if use a power supply
system.
When use the pedal with batteries, Please use batteries to prevent ALKALINE
leaking damage.
When use the pedal with a AC adaptor or DC power supply system, Please use
DC9V (100mAREGULATED
or higher) power supply. Using unregulated or
switching power for IT
system can cause of HUM NOISE of high frequency noise.
Battery & Power


Produkt Specifikationer

Mærke: Artec
Kategori: Ikke kategoriseret
Model: SE-2

Har du brug for hjælp?

Hvis du har brug for hjælp til Artec SE-2 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Artec Manualer

Artec

Artec SE-ADL Manual

30 Juli 2025
Artec

Artec SE-2 Manual

30 Juli 2025
Artec

Artec SE-OE3 Manual

30 Juli 2025
Artec

Artec SE-NGT Manual

29 Juli 2025
Artec

Artec Edge Z Manual

20 Februar 2024
Artec

Artec Cubix G1R Manual

6 Oktober 2022

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer