ATN NVG7-2I Manual
ATN
Ikke kategoriseret
NVG7-2I
Læs gratis den danske manual til ATN NVG7-2I (56 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om ATN NVG7-2I, eller vil du spørge andre brugere om produktet?
Side 1/56
o p e r a t o r ’ s m a n u a l
Important Export Restrictions! Commodities, products,
technologies and services contained in this manual are
subject to one or more of the expor t control laws and
regulations of the U.S. Government and they fall under the
control jurisdiction of either the US Department of State
or the US BIS-Depar tment of Commerce. It is unlawful
and strictly prohibited to export, or attempt to export or
otherwise transfer or sell any hardware or technical data or
furnish any service to any foreign person, whether abroad
or in the United States, for which a license or written
approval of the U.S. Government is required, without first
obtaining the required license or written approval from the
Department of the U.S. Government having jurisdiction.
Diversion contrary to U.S. law is prohibited.
NIGHT VISION GOGGlES
ATN NVG-7
NVG7 OPERATOR’S MANUAL (REV. 1, AUGUST 2010)
The information in this manual is furnished for information use only, is subject to
change without notice, cannot be construed as a commitment by ATN Corp.
ATN Corp. assumes no responsibility or liability for any errors or inaccuracies
that may appear in this book.
© 2010 ATN Corp. All right reserved.
Register your product warranty online at
www.atncorp.com/warranty
a
SAFETY SUMMARY
STUDY CAREFUllY THIS MANUAl BEFORE
TURNING ON AND OPERATING THIS PRODUCT.
CAUTIONS
NVG-7 night vision units are precision optico-electronic instruments
and requires careful handling. To provide safe use of the goggles the
following instructions should be observed:
•Donotdismantletheunit.
•Keeptheunitclean;protectitfrommoisture,sharptemperature
drops and shocks.
•Becarefulnottotouchtheglasssurfaces.Ifyouputfinger-prints
on, or contaminate the glass surfaces, use only clean and soft
materials to clean it.
•Protecttheunitfromexcessivelighting.Donotturnthegog-
gles on in dayligh t with th e front len s cap of f. Do not poi nt
the goggles at the bright light sourc e ( a fire, car headlight s,
lanterns, street lamps, room lights, etc.).
•Donottestthedeviceindaylightconditionsevenwiththedaylight
filter/lens cap on for more than ten (10) minutes.
•Donotleavetheunitinonpositionduringstopsinoperation.
•Removethebatteryfromtheunitwhenstoringforperiodsexceed-
ing 3 days. Failure to do so may damage unit.
THIS PRODUCT CONTAINS NATURAl RUBBER lATEx
wHICH MAY CAUSE AllERGIC REACTIONS.
C AU T I O N :
b
EqUIPMENT lIMITATIONS
To avoid phys ical an d eq ui pment damage when u si ng t he
ATN NVG-7, carefully read and understand the following equipment
limitations.
•Theequipmentrequiressomenightlight(moonlight,starlight,
etc.) to operate. The level of equipment performance depends
upon the level of light.
•Nightlightreducesbypassingthroughtheclouds,whileoperating
under trees, at building shadows, etc.
•Theequipmentislesseffectivewhenviewingintoshadowsand
other darkened areas.
•Theequipmentislesseffectivewhenviewingthroughtherain,
fog, sleet, snow or smoke.
•Theequipmentwillnot“see”throughthedensesmoke.
•Hasprotectionsystem,whichcutsofftheimageintensifierwhen
ambient light level exceeds the limit of 40 lux during a 10 seconds
period.
•Understarlightconditionslowcontrastenvironments(such
as snowcovered territory, sandy deserts, large bodies of water
or grassy hills) degrade visibility thereby disguising or masking
changes in terrain.
•Undertoolow-lightconditionsthegogglesloosessomeofthe
resolution that it has under full moon.
i
TABLE OF CONTENTS
pg.
SAFETY SUMMARY a
SECTION I. INTRODUCTION 1-1
1.1. General 1-2
1.1.1. Goggles 1-2
1.1.2. Reports 1-2
1.1.3. Storage 1-2
1.1.4. Warranty 1-2
1.2. Description and Data 1-5
1.2.1. Description 1-5
1.2.2. NVG7 Standard Components 1-8
1.2.3. NVG7 Optional Components 1-9
SECTION II. OPERATING INSTRUCTIONS 2-1
2.1. Installation Procedures 2-2
2.1.1. Battery Installation 2-2
2.1.2. Flip-UpHeadMountInstallation 2-3
2.1.3. HelmetMountInstallation 2-5
2.1.4. 3x Lens Installation 2-6
2.1.5. 5x Lens Installation 2-6
2.1.6. 8x Lens Installation 2-7
2.1.7. IR-450 Installation 2-8
2.1.8. AdaptertoMil-SpecHead /HelmetMount 2-9
2.2. Operating Procedures 2-11
2.2.1. Controls and Indicators 2-11
2.2.2. Preparation for Operation 2-12
2.2.3. Operation in the Dark Condition 2-13
2.2.4. Focusing 2-13
2.2.5. IR Illuminator Operation 2-14
2.2.6. Shut-down Operation 2-16
ii
SECTION III. OPERATIONAL DEFECTS 3-1
3.1. Zeroing Operational Defects 3-2
3.1.1. Shading 3-2
3.1.2. Edge Glow 3-3
3.1.3. Flashing, Flickering, or Intermittent Operation 3-3
3.1.4. Cosmetic Blemishes 3-3
SECTION IV. MAINTENANCE INSTRUCTIONS 4-1
4.1. Preventive Maintenance Checks and
Services (PMCS) 4-2
4.1.1. Purpose of PMCS 4-2
4.1.2. Frequency of Performing PMCS 4-2
4.2. Troubleshooting Procedures 4-4
4.3. Maintenance Procedures 4-6
4.3.1. NVG7 Maintenance 4-6
4.3.2. Cleaning Procedures 4-7
4.4. Head Mount Maintenance 4-7
4.4.1. Removal and Installation of Browpad 4-7
4.4.2. Removal and Installation of Chinstrap 4-7
4.4.3. Removal and Installation of Chin Cup 4-8
4.4.4. Preparing for Extended Storage 4-8
Appendix A. Estimation of Ambient Illumination Level A-1
Appendix B. Spare Parts List B-1
Appendix C. Removal and Installation
of Image Intensifier C-1
For Technical Information INFO-1
1-1
SECTION I
INTRODUCTION
1-2
1.1 GENERAl INFORMATION
1.1.1. GOGGlES
This manual contains instructions for use in operating and maintain-
ing the ATN NVG-7. Throughout this manual, the ATN NVG-7 will be
referred to as the goggles or the NVG-7.
1.1.2. REPORTS
Reports from the user on recommendations for improvements are
encouraged. Send reports to the address below.
American Technologies Network Corp.
1341 San Mateo Avenue
South San Francisco, CA 94080
(800) 910-2862
(650) 989-5100
(650) 875-0129 fax
www.atncorp.com
info@atncorp.com
1.1.3. STORAGE
Storage of the NVG7 should be done in the factory packing and after
a thorough PMCS as outlined in Chapter IV of this manual. This will
ensure the goggles remains in mission ready condition during stor-
age. Battery should be stored separately from the goggles.
The NVG7 should not be placed on the floor, in any area exposed to
high temperatures or direct sunlight. Presence of acid and alkaline
vapour, as well as of other aggressive admixtures in the air is unac-
ceptable.
1-4
ATN’s liability hereunder for damages, regardless of the form or action,
shall not exceed the fees or other charges paid to ATN by the customer or
customer’s dealer. ATN shall not, in any event, be liable for special, indi-
rect, incidental, or consequential damages, including, but not limited to,
lost income, lost revenue, or lost profit, whether such damages were fore-
seeable or not at the time of purchase, and whether or not such damages
arise out of a breach of warranty, a breach of agreement, negligence, strict
liability or any other theory of liability.
PRODUCT wARRANTY REGISTRATION
In order to validate the warranty on your product, ATN must receive a com-
pleted Product Warranty Registration Card for each unit or complete war-
ranty registration on our website at www.atncorp.com. Please complete the
included form and immediately mail it to our Service Center: ATN Corpora-
tion, 1341 San Mateo Avenue, South San Francisco, CA 94080.
OBTAINING wARRANTY SERVICE
To obtain warranty service on your unit, End-user must notify ATN serv-
ice department by calling 800-910-2862 or 650-989-5100 or via e-mail
service@atncorp.com to receive a Return Merchandise Authorization
number (RMA).
When returning please take or send the product, postage paid, with a copy
of your sales receipt to our service center, ATN Corporation at the address
noted above. All merchandise must be fully insured with the correct post-
age;ATNwillnotberesponsibleforimproperpostageor,missingordam-
aged merchandise during shipment.
When sending product back, please clearly mark the RMA# on the out-
side of the shipping box. Please include a letter that indicates your RMA#,
Name, Return Address, reason for service return, Contact information such
as valid telephone numbers and/or e-mail address and proof of purchases
that will help us to establish the valid start date of the warranty. Product
merchandise returns that do not have an RMA listed may be refused or a
significant delay in processing may occur.
Estimated Warranty service time is 10-20 business days. End-user/cus-
tomer is responsible for postage to ATN for warranty service. ATN will cover
return postage/shipping to continental USA end-users /customers after
warranty repair only if product is covered by aforementioned warranty. ATN
will return product after warranty service by domestic ground service and/
or domestic mail. Any other requested, required or international shipping
method the postage/shipping fee will be the responsibility of the end-user/
customer.
1-7
TABlE 1-1. SPECIFICATION
SYSTEM RESOlUTION SUBjECT TO TUBE RESOlUTION:
36 to 44 lp/mm 0.38 mrad/lp
45 to 54 lp/mm 0.30 mrad/lp
55 to 64 lp/mm 0.25 mrad/lp
Over 65 lp/mm 0.21 mrad /lp
MECHANICAl DATA:
Dimensions
(LengthxWidthxHeight)
6.3”x2.5”x4”/
160 x 60 x 102 mm
Weight 1.1 lb/0.5 kg
ElECTRICAl DATA:
Battery One AA (1.5 V) or CR123A (3 V)
Cell Life at 20 ˚C:
AA Alkaline Battery
123A Lithium Battery
30 hours
60 hours
OPTICAl DATA:
Magnification 1X (3X, 5X, 8X optional)
Objective Lens Focal Length 26 mm
Objective Lens F/number 1:1.2
Field of View 40°
Diopter Adjustment ±5
Focus Range 0.25 m to infinity
Interpupillary Distance 58 - 72 mm
ENVIRONMENTAl DATA:
Operating Temperature -40 to +50 ˚C
Storage Temperature -50 to +70 ˚C
Illumination Required Natural night illumination
(overcast starlight to moonlight)
Produkt Specifikationer
| Mærke: | ATN |
| Kategori: | Ikke kategoriseret |
| Model: | NVG7-2I |
Har du brug for hjælp?
Hvis du har brug for hjælp til ATN NVG7-2I stil et spørgsmål nedenfor, og andre brugere vil svare dig
Ikke kategoriseret ATN Manualer
17 August 2024
16 August 2024
16 August 2024
15 August 2024
11 August 2024
10 August 2024
10 August 2024
9 August 2024
9 August 2024
7 August 2024
Ikke kategoriseret Manualer
- Sonicware
- Atdec
- Soundstream
- SetonixSynth
- Finlux
- Rollei
- SunPower
- McGregor
- Plantronics
- Origin Storage
- Hillvert
- Source Audio
- Rocada
- Vroomshoop
- DS18
Nyeste Ikke kategoriseret Manualer
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025