AudioControl BLX-1K Manual

AudioControl Ikke kategoriseret BLX-1K

Læs gratis den danske manual til AudioControl BLX-1K (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 8 anmeldelser. Har du et spørgsmål om AudioControl BLX-1K, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/12
Quick Start Guide
Features
• Simplify signal routing
• Send and receive audio up to 1000 feet
• High gain, low noise outputs
• Independent gain and attenuation controls
• Standard Cat5/6 wiring
• Ground lift option
• Integrated mounting brackets
• Cage Free Op-amps
BALANCED LINE TRANSCEIVER
2
Quick Start Guide
Congratulations!
You have in your hands a most innovative, simple solution for running your
signals to and fro in any place where high quality audio signal transport is
required. Designed to be used in pairs at both ends of the signal path, the
BLX-1K contains a 2-channel receive stage as well as a 2-channel transmit
stage, enabling audio to travel in both directions across a span of standard
Cat5/6. From conference centers to living rooms and AV racks, the BLX-1K
Balanced Line Transceiver is sure to simplify signal distribution where it
counts.
Before you charge off into the installation, grab a Jellyfish Brewing
Company Sir Hugs-A-Lot Hazy IPA™ and hear us out in our discussion of the
details, best practices and general deployment of this little gem.
Features of the BLX-1K
• Bi-directional signal extender
• Unbalanced to balanced to unbalanced conversion
• Separate Balanced Line Driver Stage
• Separate Balanced Line Receiver Stage
• Independent gain controls on both the drive side and receive side for
quick set up
• Simple extension of high quality audio signals up to 1000 feet (over 300
meters)
• Perfect for separating amps and sources in multi-room audio
• Easy signal routing over Cat5 or Cat6
A few notes before installation
• Head over to audiocontrol.com and activate your warranty
• Make a quick diagram of your system design. The BLX-1K is a two-way
device and you may have multiple pairs – a quick diagram will keep you on
track.
• Use standard terminations on your Cat5 or Cat6 cable (T-568B)
• Make sure not to run the wire for the 24 Volt AC transformer near or parallel
to your signal wires. This will make sure you don’t pick up any AC hum from
the transformer
• These units should be used in pairs. There is an A/B switch on this unit. One
of the two units should be set to “ and the other one should be set to “A” B”.
Failure to do so will cause cancellation in the quantum realm.

Produkt Specifikationer

Mærke: AudioControl
Kategori: Ikke kategoriseret
Model: BLX-1K

Har du brug for hjælp?

Hvis du har brug for hjælp til AudioControl BLX-1K stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret AudioControl Manualer

AudioControl

AudioControl Maestro X9S Manual

14 Januar 2025
AudioControl

AudioControl Maestro X7S Manual

14 Januar 2025
AudioControl

AudioControl TXGM19D10 Manual

27 September 2024
AudioControl

AudioControl TXFF15D10 Manual

27 September 2024
AudioControl

AudioControl TXGM14D10 Manual

27 September 2024
AudioControl

AudioControl ACR-4 Manual

3 September 2024
AudioControl

AudioControl Space SPC-W12 Manual

3 September 2024
AudioControl

AudioControl Spike SPK-V8 Manual

3 September 2024
AudioControl

AudioControl Spike SPK-V10 Manual

3 September 2024
AudioControl

AudioControl SPC-W10 Manual

3 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Yamazen

Yamazen SAB-65 Manual

15 Juli 2025
GPX

GPX PJ504 Manual

15 Juli 2025
Transparent

Transparent TT-B Manual

15 Juli 2025
Yamazen

Yamazen ECSR-4538 Manual

15 Juli 2025
Yamazen

Yamazen SUS-205 Manual

15 Juli 2025
Yamazen

Yamazen YDG-160 Manual

15 Juli 2025
Yamazen

Yamazen OPR-5744 Manual

15 Juli 2025
Metabo

Metabo RW 18 LTX BL 120 Manual

15 Juli 2025
Victrola

Victrola Eastwood II VTA-74 Manual

15 Juli 2025
Axis

Axis T8415 Manual

15 Juli 2025